Swimline 19120 User Manual
SOLSTICE®
HOME RESORT™ SERIES
INSTRUCTIONS
Your new Solstice Home Resort Series product features the “Insta-flate” system. This
system allows you to quickly and easily inflate and deflate your float. The system
combines our “19020AC InstaFlator” (4)“D” Cell battery operated pump with our
“InstaValve”. The “InstaFlator” inflator / deflator features nozzle adapters which will
connect to any of the 2 different valves on your float and can be used on many other
inflatable products as well.
19020AC InstaFlator & Adapters
INFLATION
To inflate your float, you’ll need the inflator provided or an inflator such as a bellows
foot pump, hand pump, electric inflator or any other inflator designed for air beds,
inflatable boats, rafts, pool floats, mattresses, and other low pressure inflatables.
Do not use an air compressor. It will damage your float.
For convenience, your new float features 2 types of valves: a smaller, “push-in” valve
and the large “InstaValve”. Inflation and deflation can be done with either of the 2
valves. If you use any other type of inflator, inflation usually must be done through the
smaller “push-in” valve. Be sure to close the valve you are not using during inflation.
1. Remove the cap from the InstaValve. The diaphragm inside the valve is designed
to allow air to flow in and not out. Push the nozzle from the inflator (marked on
the pump as “Inflate”) in to the valve.
2. Inflate the float until it is firm and all wrinkles are gone and then screw on the
cap.
3. Use the push-in valve for other pumps, if necessary and follow the same
guidelines.
SOLSTICE®
HOME RESORT™ SERIES
INSTRUCTIONS
(continued)
InstaValve
DEFLATION
To deflate your float, remove the cap from the InstaValve and depress the diaphragm so
that the air flows out. Roll your product up from the opposite end from the valve.
CARE
1. You may need to clean your product occasionally. Use mild soap and water only.
Do not use any abrasive or strong chemical cleaners.
2. Your product may need air added from time to time based on the air and water
temperature. If it seems soft after use, it does not mean that the product is leaking.
3. Allow the product to dry before storing. Do not fold and store when wet.
4. Do not expose your product to extreme temperatures.
5. Your product is made with heavy gauge, new materials. If a puncture does occur,
utilize the provided repair kit and follow the enclosed directions.
Loading...