Swimline 15100dc User Manual

SOLSTICE®

DESIGNER LOUNGER 15100DC™

INSTRUCTIONS

The following components comprise your Solstice Designer Lounger:

The Body (mattress) can be used as a float or mattress independent of the frame.

A) Anodized Aluminum Frame – 7 separate pieces (see drawing 1)
B) Fabric Covered Mattress Float (see drawing 4) – Which can be used by it’s own as a float.
C) Fabric Covered Left & Right Side Arm Rest Pontoons – 2 pieces (see drawing 2).
D) Carry / Storage Bag.

Follow these basic instructions to use your Lounge -

Slide the Armrest Pontoons on to the aluminum frame before inflating them. Once the frame is
assembled, inflate the Armrests.

INFLATION

To inflate your float, you’ll need an inflator such as a bellows foot pump, hand pump, electric
inflator or any other inflator designed for air beds, inflatable boats, rafts, pool floats, mattresses,
and other low pressure (PSI) inflatables.

Do not use an air compressor. It will damage your float.

DEFLATION

To deflate your lounge, remove the cap from the valve and depress the diaphragm so that the air
flows out. Roll your product up from the opposite end from the valve.

CARE

1. You may need to clean your product occasionally. Use mild soap and water only. Do not

use any abrasive or strong chemical cleaners.

2. Your product may need air added from time to time based on the air and water

temperature. If it seems soft after use, it does not mean that the product is leaking.

3. Allow the product to dry before storing. Do not fold and store when wet.

4. Do not expose your product to extreme temperatures.

5. Your product is made with heavy gauge PVC, new materials. If a puncture does occur,

utilize the provided repair kit and follow the enclosed directions.