swiftech Quiet Power FS20-H20 series Quick Installation Manual

Swiftech Inc., 1703 E. 28th St., Signal Hill, CA 90806 T. [phone] F. [phone]

uiet Power

Q



FS20-H20 series

Liquid cooled case

Quick installation guide

Swiftech Inc., 1703 E. 28th St., Signal Hill, CA 90806 T. [phone] F. [phone]

NO PARTS PS

NO PARTS PS

1 BEZEL, FRONT 1

2 BEZEL, FRONT, SUB 1

3 BUTTON, POWER 1

4 BUTTON, RESET 1

5 LENS 1

6 COVER, 5.25 FDD 4

7 COVER, 3.5 FDD 2

8 SPRING 1

9 PLATE, CAGE, 5.25 2

10 SPEAKER 1

11 BULKHEAD ASSY 1

12 SHIELD, I/O 1

13 CAGE, 3.5 ASSY 1

14 CARDGUIDE 1

15 POWER SUPPLY 1

16 BRACKET, P/S 1

17 COVER, TOP 1

18 CHASSIS, BOTTOM 1

Components installation

1. Open the side-panel #21 by loosening thumb screws #32

2. Remove the main cross bar #27, and the memory board cross bar #37 (discard #37 bar if not needed)

3. Loosen screw #33, and remove the front bezel #1

4. Remove the top cover #17

You now have full access inside the case to proceed with the installation of your power-supply, motherboard,
hard drive (s) and various components.

Liquid cooling circuit notes

19 PANEL, FRONT 1

20 PANEL, REAR 1

21 SIDE, PANEL 2

22 CAGE, 5.25 1

23 FILLER TOP 3.5 1

24 BRACKET, HDD 1

25 SLIDE BRACKET P/S 1

26 BASE, M/B 1

27 CROSS BAR 1

28 BRACKET, LED ASSY 1

29 FAN 120MM 1

30 SNAP RIVET 8

31 SHIELD 1

32 THUMB SCREW 2

33 SCREW 1

34 RIVET, ALUMINUM 49

35 RIVET-SUS 8

36 SCREW 20

MEMORY BOARD CROSS

37

BAR

1

• The water-block is installed onto the back-panel for safe shipping. Unscrew the 4 springs assemblies,

and remove the four aluminum standoffs used to secure the block to the back-panel. You will need
these standoffs later, together with the spring and screw assemblies to install the water-block onto your
motherboard.

• During installation of your motherboard inside the case, it is good practice to strap the block out of the

way, using a rubber band for example.

• Your cooling circuit is already filled with liquid (75% pure water, 25% antifreeze). All you need to do is to

install the water-block to your CPU (follow separate instructions for AMD or INTEL processors).

• Power to the pump: a spare power cord is provided to supply A/C power to the pump. It needs to be

connected to an A/C outlet.