Swiffer Continuos Clean SYFM12 Replacement Instructions Manual

SWIFFER is a registered trademark of The Procter & Gamble Company, Cincinnati, Ohio

used under license by Project Air, LLC.

Filter
Replacement
Instructions

SYFM12

Continuous Clean

Air Cleaning System

™

Manufactured for:
Project Air, LLC
324A Half Acre Road
Cranbury, NJ 08512
Made in China ©2018
80 0-221- 6895
www.SwifferContinuousClean.com

Customer Service

If you have general questions about using or assembling this product,
please call World and Main customer service:

800-221-6895

Or you can visit our website www.SwifferContinuousClean.com

Continuous Clean

™

www.SwifferContinuousClean.com

4

Filter Life Indicator Pattern

For best results, replace your filter every 30 days,
or when filter life indicator pattern is visible on
the top of your filter.

Filter darkens as it captures particles from the air,
causing the Filter Life Indicator Pattern to become
visible. This indicates the filter is full and should
be replaced.

Filter Life Indicator Pattern

2

2 3

Continuous Clean

™

www.SwifferContinuousClean.com

Continuous Clean

™

www.SwifferContinuousClean.com

Filter Removal and Replacement

1. Unplug device

2. Grab top handle and twist gently counter-

clockwise to remove cover. Set aside.

3. Remove filter and discard in proper waste

receptacle.

4. Check air inlet (below fan) and if necessary wipe

with dry cloth or vacuum to remove soil.

5. Attach the filter to the fan by sliding the open

filter end with the internal elastic band over the
fan base. The filter should form a seal around the
fan housing. The top of the filter will remain loose
until inflated.

6. Gently insert the Filter Identity Chip into the slot

on the fan housing, ensuring that the Swiffer logo
is facing outward.

7. Plug the power cord into the power cord inlet

on the bottom of the fan housing. Once inlet is
secure, plug the power cord into a power outlet
(refer to Important Safety Instructions).

Note: Fan will initially operate at a higher speed
(~30 seconds) to aid filter inflation.

8. Lower cover over the inflated filter and twist

clockwise to lock in place. Cover must be in
place for unit to work properly. If filter does not
fully inflate inside cover, tug gently until the filter
height is just below top of cover.