Sweex PU013 Quick start guide

English version

PU013 Sweex 1 Port Parallel & 2 Port Serial PCI Card

Introduction

• Do not expose the PU013 to extreme temperatures. Do not place the device in direct sun light or close to heating elements.

• Do not use the PU013 in extremely dusty or moist environments.

• Prevent hard shocks or impacts of the device, as this can cause damage to the internal electronics.

Hardware Installation

1. Make sure the computer is turned off and that there is no power connected.

2. Also remove the printer and monitor cable, because these have their own power supply.

3. Now unscrew the computer casing.

4. Make sure that you undo yourself of possible static electricity. This can be done by grabbing a (naked) central heating pipe or
an unpainted water pipe. Pay attention not to use a magnetic screwdriver. Briefly touch the iron frame of the PC casing. Avoid
direct contact with the contact points of the PCI slot and contact points on the graphics card.

5. Locate a free PCI slot and remove the metal protection plate that is in the computer casing for the intended slot. Consult the
manual of your computer to find the PCI slot.

6. When possible fasten the card with screws so it can not move.

7. When the card is mounted successfully, check if the other cards are still fitted properly in their expansion slot. It can happen
that when a new card is added the other cards rise a little with as result that the card, or even the entire computer, may not
work.

8. Close the computer casing and reconnect all cables properly.

9. Turn on the computer.

2

Installation Windows XP

After starting the computer this window will appear.

Choose “No not this time” and click “Next”.

English version

Place the Sweex CD-ROM in the CD-ROM player. When the CD-ROM already was in the player, open the tray and close it again.
Windows will automatically install the drivers.
If windows can not find the drivers, choose “Install from a list or specific location” in the above window.

3

English version

Click “Browse” and navigate to the Sweex CD-ROM to find the drivers. Press “Next”.

It is possible that Windows will notify you that the driver is not certified. This is not a problem for correct functioning of the card.
All Sweex products and relevant drivers are tested thoroughly. Choose the option “Continue Anyway”.

4