English version
MI700 Sweex Bluetooth Mouse USB
Introduction
• Do not expose the Bluetooth Mouse to extreme temperatures. Do not place the device in direct sun light or close to heating
elements.
• Do not use the Bluetooth Mouse in extremely dusty or moist environments.
• Prevent hard shocks or impacts of the device, as this can cause damage to the internal electronics.
• Never try to open the device yourself, this voids the warranty.
Operation
To use the Bluetooth Mouse, you need a computer which can set up a bluetooth connection. This is possible if your computer or
notebook has a build in bluetooth adapter, or when you have connected an USB bluetooth adapter.
Bluetooth can be configured with several different types of software. Determine which steps you have to follow to connect to the
bluetooth mouse. This manual explains the basic windows and the IVT Bluesoleil software.
Connecting to the Bluetooth Mouse
To activate the Bluetooth Mouse slide the button to the left to “On”.
4
English version
Windows software:
1. Right click the Bluetooth icon and choose “Add a bluetooth device”.
2. Press the round button at the bottom of the button once. The red light on top of the mouse will start to blink.
3. Place a check mark at “My device is setup and ready to be found”.
4. Press “Next”.
5. Select the “Bluetooth Mouse” and press “Next”.
5
English version
6. Select “Don’t use a passkey”.
Windows will install the mouse automatically.
7. Press “Finish”.
The Bluetooth mouse is now ready to be used.
IVT Bluesoleil Software:
1. Start your Bluesoleil software.
2. Press the round button at the bottom of the button once. The red light on top of the mouse will start to blink.
3. Choose “My Bluetooth” → ”Bluetooth Device Discovery” and wait until searching is complete, and the mouse has been
found.
6
4. Right click the mouse and choose ”Pair Device”.
5. Enter “0000” (four zero's) as key and press OK.
6. A red check mark appears at the mouse icon.
7. Right click the mouse and choose “Refresh services”.
English version
8. Right click the mouse again and choose “Connect”, then choose “Bluetooth human interface device service”.
7
English version
Windows will install the mouse automatically. After several seconds the mouse is ready to be used.
If during the installation procedure the software does not respond, and the red light on the mouse has stopped blinking, press the
round button again at the bottom of the mouse until the red light starts to blink again. Then try to re-execute the procedure. The
red blinking light indicates that it is ready to communicate with the software.
Important:
Be aware that when the mouse is not used for a period of time it will go in to hibernation mode. To re-activate the mouse press
one of the mouse buttons once.
Warranty
For all Sweex products a warranty period of 3 years applies. We do not give support or warranty on supplied software,
rechargeable batteries and batteries. Transaction of warranty only takes place at the sales point where the product is bought.
All brand names and associated rights mentioned in this manual are and stay property of the rightful owner.
8
Loading...