SWEEX JB000150 Quick Start Manual

English version
3
Safety Notes
Do not try to open the camera by yourself. This may cause damage or electrical shock.
Do not flash in a close distance (less than 1 meter) of human eyes.
Keep the camera away from the reach of children or animals to prevent them from swallowing the batteries or small accessories.
Avoid using the camera, if any form of liquid enters the camera. If it happens, switch off the camera and contact the company where you
bought this camera for help.
Do not place or store the camera in a high temperature environment which may cause damage to the camera.
Do not mix different types of batteries of new and old batteries.
Take out the batteries when the camera will not be used for a long time. This to avoid electrical leakage which may damage the camera
Unplug the camera from the adapter (if used) for a long period, to avoid damage to the camera.
It’s normal that the temperature rises after the camera is used for a long period.
ICON INDEX TABLE
Working Mode Focus Range
Flash Modes Digital Zoom Thumbnails
Self-timer Movie Clip
Memory Card Inside Battery Status Image Size (Resolution) Image Quality White Balance Exposure Protected Image Print (DPOF) Darkness Warning
English version
WWW.SWEEX.COM
2
JB000150 Sweex 3.3 Megapixel digital camera
Benefits
3 in 1 multifunction camera: digital camera that can make video recordings and has a card reader function White balance: automatic, daylight, fluorescent, tungsten and sunset File Format: JPEG, EXIF, DPOF and AVI Internal 16 MB flash memory
Key Characteristics
LCD Display: 1.6 TFT LCD (85k pixels) Selftimer : 10 seconds Image size: 2560 x 1920 (5MP, Interpolated)
2048 x 1536 (3MP) 1600 x 1200
1280 x 960 Storage: SD/MMC card slot USB 1.1 Interface
Specifcations
Image sensor: High quality 3.3 Mega pixel CCD sensor
4x digital zoom
Interpolated to 5 Mega pixel Focus: Normal 1.2m - infinity
Portait: 0.8m - 1.6m
Macro: 0.2m Focal distance: f = 7.04 mm Aperture: F4.0 / F8.0 Lens Size: 1/2.7 inch ISO Rating: Auto Exposure: +/- 2 EV (0.5 EV / steps) Flash: Red-eye reduction, automatic, slow sync, fill in flash and flash off Power: 2x AA Alkaline battery / Ni-MH
English version
5
Basic Photography
1. Switch on the power.
2. Set the Mode Dial at shooting mode , or Movie Clip Mode for video recording.
3. The setting of the focus range for still image is required as follows:
Macro : 0.2 Mtr.
Portrait : 0.8 Mtr - 1.6 Mtr.
Normal : 1.2 Mtr - infinity
4. Hold still and press down the shutter button.
5. The LED indicator starts blinking right after the shutter button is released.
6. Once the LED indicator stops blinking, you are ready to take another shot.
NOTE!
A message of Low Light appearing on the TFT LCD monitor as a warning is to remind you that the image you are going to capture is in a low light environment. To compose a good quality image, it is strongly recommended to go the Flash Mode, select Auto Flash or Fill in to supply more light sources.
Installing Camera Driver; Ulead Photo Explorer and Downloading the Image(s) Onto you PC
For details please refer to the full English user manual on the enclosed CD.
English version
WWW.SWEEX.COM
4
Switch On or Turn Off the Camera
Slide the Power switch sideways and hold it a while to Switch On the camera. Repeat the action to Switch Off the camera.
Loading the Batteries
1. Check if the camera is Switched Off ”.
2. Slide the battery/Memory card cover out to open it.
3. Load 2 x AA Alkaline batteries into the battery chamber, please follow the polarity indications.
4. Close the battery/Memory card cover.
Using an AC Adapter (optional)
1. Check if the camera is Switched Off.
2. Make sure the AC adapter is 3.3V/2.0 Amp.
3. Connect the AC adapter connector with the DC socket on the camera.
4. Connect the adapter itself with the power outlet.
5. Switch On the camera.
Battery indicator
Battery power is full “. Battery power is half drained, Keep new batteries with you. Battery power is drained. Replace the batteries.
NOTE!
We suggest to use Duracell Alkaline batteries.
Batteries may lose power if kept inside the camera for a long time without using, Please remove the batteries if the camera is not in use.
Do not use manganese batteries, these batteries cannot supply the maximum power and therefore your camera will not operate correctly.
Batteries may not work normally under 0 degrees Celsius.
Loading...