Swanstone SS-WTK Installation

36"

1 1/2"

10 "

B

A

C

A

A

WINDOW TRIM KIT MODEL SS WTK

Installation Procedure for
Swanstone Window Trim Kit
MODEL SS WTK

INCLUDED IN CARTON:
A. Three sill/jamb panels
B. One tube of adhesive
C. One tube of silicone caulk

CAUTION:

Read ALL instructions carefully BEFORE starting your installation.

Save this manual for future reference

INSTALLATION OPTIONS

When installing the Swanstone Window Trim Kit, you have four options. Before you begin, decide on the application best suited for you.
Allow panels to adjust to room temperature for at least six hours (65⬚ - 90⬚F). The options are as illustrated below.

Option 1. Notching the sill panel only.

Option 3. Mitering all three panels.

Option 2. Notching the two jamb panels.

Option 4. Trimming to fit all panels with no

notching or mitering.

WINDOW TRIM KIT MODEL SS WTK

TOOLS REQUIRED TO INSTALL

The only tools needed are a saber saw, ruler, and caulking gun.

DO NOT NAIL PANELS TO WINDOW SILL OR JAMBS.

INSTALLATION PROCEDURE

Remove unnecessary window moldings, if any, and clean area of dirt, chipped paint, loose plaster, etc.

Depth of jamb

Height of jamb

Notched cut
illustrated:
Your cut may
be different.

A. Taking into account the
installation option you choose,
measure the side of the sill
opening. Then measure the
depth of the sill area, mark
and cut panel to exact size.

NOTE: IT IS ADVISABLE TO
TRIAL FIT ALL THREE PAN­ELS BEFORE CUTTING.

B. Cut the left and right jamb

panels to the desired height
and depth. Again, consider
the application that you have
chosen; this will determine the
size of your cut. If applicable,
you may wish to line up the
jamb panels with the height of
the tub surround material.

C. Apply adhesive per “S”
pattern shown to the under­side of the sill and press firm­ly into place. Repeat the same
procedure for the two jamb
panels. Press down on all
panels to insure good contact.

D. Caulk all edges to seal out
moisture.

NOTE: ALLOW ADHESIVE
AT LEAST 24 HOURS TO
CURE BEFORE USING.

CLEANING

Clean your Swanstone Window Trim Kit as you would any other fine bath fixture, using normal household detergents and cleansers. Just
wiping the surface quickly removes watermarks and residue. Occasional scrubbing with household abrasive cleansers maintains
Swanstone’s beautiful luster.

REPAIRING

Use 400 grit sandpaper to remove scratches and gouges in the surface. A “Scotchbright” pad can be used to blend the repair into the
surrounding area.

The Swan Corporation

St. Louis, MO 63101

FORM #527-9-98-5M