Installation Procedure for
Installation Procedure for
Swan
CORPORATION
Drain Assembly
Figure 1
MODEL DIT
SELF-RIMMING DROP-IN TUB
Mounting Assembly Figure 2 Mounting Assembly Figure 2
Swan
CORPORATION
Drain Assembly
Figure 1
MODEL DIT
SELF-RIMMING DROP-IN TUB
Read ALL instructions carefully BEFORE starting your installation
SELF-RIMMING DROP-IN TUB - CAPACITY 17.50 GALLONS
1. Measure and cut counter hole for tub insertion 23-5/8” wide x
20-5/8” long. Test fit tub. File any areas which require widening.
2. After test fitting tub, remove from counter hole and install faucet
(not included) and drain assembly (see Figure 1).
Helpful Hint .... for easy installation of final supply line
connections, it is suggested that, if possible, plumbing
connection to faucet be made at this point. Plumbing
connections to hot and cold supply line can then be made after
drop-in tub is secured to counter top.
Mounting Point Mounting Point
Clip Clip
Threaded Bolt Threaded Bolt
Read ALL instructions carefully BEFORE starting your installation
SELF-RIMMING DROP-IN TUB - CAPACITY 17.50 GALLONS
4. Set sink into place and assemble bracket, washer, and nut attachments (see Figure 2). Alternating from one to another, lighten
mounting bracket assembly nuts.
5. Some caulking residue may flow from under tub flange. This
residue can be wiped clean following instructions on silicone or
latex caulking tube.
6. Attach drain waste and faucet plumbing as desired.
1. Measure and cut counter hole for tub insertion 23-5/8” wide x
20-5/8” long. Test fit tub. File any areas which require widening.
2. After test fitting tub, remove from counter hole and install faucet
(not included) and drain assembly (see Figure 1).
Helpful Hint .... for easy installation of final supply line
connections, it is suggested that, if possible, plumbing
connection to faucet be made at this point. Plumbing
connections to hot and cold supply line can then be made after
drop-in tub is secured to counter top.
4. Set sink into place and assemble bracket, washer, and nut attachments (see Figure 2). Alternating from one to another, lighten
mounting bracket assembly nuts.
5. Some caulking residue may flow from under tub flange. This
residue can be wiped clean following instructions on silicone or
latex caulking tube.
6. Attach drain waste and faucet plumbing as desired.
3. In the installation of the DIT, DO NOT use the white washer in the
installation process. Use of the white washer may cause the drain
to seat improperly and cause water to pool around the drain area.
3. In the installation of the DIT, DO NOT use the white washer in the
installation process. Use of the white washer may cause the drain
to seat improperly and cause water to pool around the drain area.
FORM #650-12-11-3M FORM #650-12-11-3M