Swann Wireless door chime Instruction Manual

WIRELESS ALERT

Security Made Smarter

Wireless Door Chime

with Mains Power

EN

INSTRUCTION MANUAL

SETUP

OVERVIEW

Installing the Chime Speaker

No wiring is necessary. Just plug the Chime Speaker into an easily accessible power point
and switch the power point on.

Installing the Doorbell

The Doorbell comes pre-paired with the Chime Speaker. Simply install the supplied
"23A/12V" battery and it's ready to use.

1. Insert a small flat-head screwdriver into the small notch at the base of the Doorbell
and carefully remove the rear cover.

2. Fit the "23A/12V" battery into the battery compartment according to the polarity
markings (+ and -) shown.

3. Turn the Doobell over and press the button. The Doorbell LED illuminates for 2
seconds and the Chime Speaker responds with the default chime. If the Doorbell LED
does not come on, check that the battery is fitted correctly, and test again.

4. Replace the rear cover with the UP arrow oriented pointing up.

Mounting the Doorbell

The Doorbell can be mounted by sticking it to a wall with the supplied double-sided
adhesive tape. The operating distance between the Chime Speaker and Doorbell is up to
50m/165ft but the range may vary depending on local conditions.

Note: Avoid mounting on metal surfaces and UPVC doorframes as these materials will
interfere with the Doorbell's ability to communicate with the Chime Speaker.

Chime Speaker Doorbell

Decrease volume

Increase volume

Previous chime

Button

Next chime

LED

Current chime