Swann SSUS1000, SSUS2000 Installation Procedures Manual

TO BE REMOVED FOR USE BY OCCUPANT

Installation Procedure for

Swan

COR POR AT I O N

Drain Assembly

Figure 1

MODEL SSUS1000

SWANSTONE UTILITY SINK

12 1/4”

3 3/4”

Mounting Assembly Figure 2

Read ALL instructions carefully BEFORE starting your installation

CAPACITY 17.50 GALLONS

1. Measure and cut counter hole for sink insertion 23-5/8” wide x
20-5/8” long. Test fit sink. File any areas which require widening.

2. After test fitting sink, remove from counter hole and install faucet
(not included) and drain assembly (see Figure 1).

Helpful Hint .... for easy installation of final supply line

connections, it is suggested that, if possible, plumbing
connection to faucet be made at this point. Plumbing
connections to hot and cold supply line can then be made after
sink is secured to counter top.

Mounting Point

Clip

Threaded Bolt

4. Set sink into place and assemble bracket, washer, and nut
attachments (see Figure 2). Alternating from one to another,
tighten mounting bracket assembly nuts.

5. Some caulking residue may flow from under sink flange. This
residue can be wiped clean following instructions on silicone or
latex caulking tube.

6. Attach drain waste and faucet plumbing.

3. In the installation of the SSUS1000, DO NOT use the white washer
in the installation process. Use of the white washer may cause the
drain to sit improperly and cause water to pool around the drain
area.

FORM #651-6-15-1M

TO BE REMOVED FOR USE BY OCCUPANT

Swan

CORPORATION

Installation Procedure for

MODEL SSUS2000

SWANSTONE UTILITY SINK

3 3/4”

8

10 1/2”

3/4”

IMPORTANT

It is recommended that a standard

3-1/2” drain assembly (not included)

be used to complete the installation

of the Swan DIT-S self-rimming

of the Swan SSUS2000.

drop-in Tub.

Read ALL instructions carefully BEFORE starting your installation

CAPACITY 7 GALLONS

1. Measure and cut counter hole for sink insertion 15-7/8” wide x
18-5/8” long. Test fit sink. File any areas which require widening.

2. After test fitting sink, remove from counter hole and install faucet
(not included) and drain assembly (not included). A standard
3-1/2” drain assembly is recommended.

NOTE

For easy installation of final supply line connections, it
is suggested that, if possible, plumbing connection to
faucet be made at this point. Plumbing connections to
hot and cold supply line can then be made after sink
is secured to counter top.

3. Caulk along edges of 15-7/8” x 18-5/8” counter hole with 1/8”
bead of silicone or latex caulk (not included).

4. Set sink into place and assemble (see Figure 1). Alternate from
one threaded bolt to another until all bolts are tight.

5. Some caulking residue may flow from under sink flange. This
residue can be wiped clean following instructions on silicone
or latex caulking tube.

6. Attach drain waste and faucet plumbing.