Swann SR244-BVD Specification
B&W Video Doorphone - Easy Setup Guide
A
Extension
Cable
C
1
Packaging
Camera
Package Contents
Manual
Monitor
Hardware
Mounting Bracket
Back
Power
Supply
B
Speaker
Microphone
1. Connect small prongs of wire to monitor
2. Connect large prongs to camera
3. Connect power supply to unit
Speaker
ALARM Button
UNLOCK Latch Button*
TALK/VIDEO Button
* Door Latch Sold Separately
2
Getting to Know Your Doorphone
Microphone
CALL
Button
Doorbell Volume
Brightness
Doorphone Connections
Front Back
3
Power Supply
Extension Wire
Swann Communications • Toll Free Technical Support: USA - 1-800-627-2799, 1-877-274-3695, Australia - 1300 13 8324 • Email: tech@swannsecurity.com
A B
SR244-BVD-10005 EN10122008
www.swannsecurity.com
B&W Video Doorphone - Easy Setup Guide
D
1
CALL
Button
Push the CALL button
to ring bell
2
NOTE: If TALK/VIDEO button is held or not pushed
quickly enough video will turn off
E
Problem: I see no image when I press the TALK/VIDEO button when someone is at the door.
When tone sounds the
screen will light up and
you will see the camera
image. Quickly press
the TALK/VIDEO
button to speak. Push
TALK/VIDEO button
again to turn off video
TALK/VIDEO
Button
Problem: The unlock button for my Door Strike works occasionally or not at all.
Answering the Doorbell and Viewing the Camera
3
Press the TALK/VIDEO
button to see camera in
silent mode
Troubleshooting Guide
Answer: Quickly push the TALK/VIDEO button and release. If you hold the TALK/VIDEO
button down too long or do not release the button quickly enough the monitor will
not show an image and remain off.
Problem: When the image comes on the screen is bright white or too dark to see who’s there.
Answer: The image is over or underexposed. Adjust the Brightness dial on the on the left side
of the Doorbell.
Swann Communications • Toll Free Technical Support: USA - 1-800-627-2799, 1-877-274-3695, Australia - 1300 13 8324 • Email: tech@swannsecurity.com
Answer: Check the Extension Cable for damage. Ensure you are using the original cable or
replacement cable of similar quality and length. If the cable length is joined or spliced
to another cable the loss of current will prevent the Door Strike from operating
correctly.
Tip 1: Mount the camera in an obvious location where visitors can access the doorbell.
Tip 2: Test the unit is working correctly before permanently installing
www.swannsecurity.com
Loading...