Swann SR16210 Installation And User Manual

Retro Table Top Cooler

Installation and User Guide

For model: SR16210 (all colours)

Swan Service Help line

0333 220 6050

SR16210_IM.indd 1 03/04/2018 13:59

v1.0

Important Safeguards

Do not connect your appliance
to the electricity supply until all
packing and transit protectors
have been removed.

Leave to stand upright for at least
4 hours before switching on to
allow compressor oil to settle

This cooler must only be used
for its intended purpose i.e the
storing cooling of drinks in bottles,
cans or plastic containers. It is
not designed for foodstuff to be
in direct contact with the internal
surfaces.

Do not dispose of the appliance
on a fire. Your appliance
contains non CFC/HFC natural
substances in the cooling system
and in the insulation, which are
potentially flammable if exposed
to fire. Therefore, take care not
to damage, the cooling circuit
or pipes of the appliance in
transportation and in use. In
case of damage do not expose
the appliance to fire or potential
ignition source and immediately
ventilate the room where the
appliance is situated.

We suggest you contact your
local authority for disposal
information and facilities available.
See installation section for
information on suitable location.

On delivery, check to make
sure that the product is not
damaged and that all the parts
and accessories are in perfect
condition.

Ensure that the plug remains
readily accessible. Do not use
multiple adaptor or extension
cables

Failure to observe these
instructions may invalidate your
right to free service during the
guarantee period.

WARNING: Ensure adequate
ventilation around the appliance.
Do not site close to heat sources.

22

SR16210_IM.indd 2 03/04/2018 13:59

Important Safeguards

WARNING: Do not damage the
refrigerant circuit.

We suggest you keep these
instructions in a safe place for
easy reference.

This appliance can be used by
children aged from 8 years
and above if they have been
given supervision or instruction
concerning use of the appliance in
a safe way and if they understand

the hazards involved.

Cleaning and user maintenance
shall not be made by children
unless they are older than 8 and
supervised. Keep the appliance and
its cord out of reach of children

aged less than 8 years.

Children should be supervised to
ensure that they do not play with
the appliance.

CAUTION: In order to avoid
a hazard due to inadvertent
resetting of the thermal cutout,
this appliance must not be
supplied through an external
switching device, such as a
timer, or connected to a circuit
that is regularly switched on and
off by the utility company

This appliance should only
be connected to an earthed,
switched mains socket. Do not
use an extension cord with this
appliance

If the supply cord is damaged,
it must be replaced by the
manufacturer, its service agent or
similarly qualified persons in order
to avoid a hazard.

The plug must be accessible after
the installation.

3

SR16210_IM.indd 3 03/04/2018 13:59

Installation Notes

It is important that upon receipt you stand your appliance upright for at least 4
hours before switching on to allow the system to settle.

1. The appliance should not be tilted more than 45 degrees when you move it. Do
not use force on any part such as the condenser, the door or handle. They could
distort and affect the operation of the cooler. Ensure ALL packaging is removed
before installation

2cm

2cm

2. Make sure there is enough ventilation space around product

3. The appliance should not be installed near external heat sources eg direct sun­shine - or external moisture sources.

2cm

4

2cm

SR16210_IM.indd 4 03/04/2018 13:59