Swann SI9020N User Manual
Steam Generator
10.5.14/v1.1
Item no.: SI9020N
Swan Products Limited, PO Box 3117, Stoke on Trent, Staffordshire, ST4 9GD
2 Year Guarantee
This product is guaranteed for two years from the date of original purchase. If any defect arises due to
faulty materials or workmanship faulty products must be returned to place of purchase. Refunds or
replacement is at the discretion of the store.
The following conditions apply:
•
The product must be returned to the retailer with original proof of purchases.
•
The product must be installed and used in accordance with the instruction contained in this
instruction guide.
•
It must be used only for domestic purposes.
•
It does not cover wear and tear, damage, misuse or consumable parts.
•
Swan has no responsibility for incidental or consequential loss or damage.
•
Valid in the UK and Eire Only
Important Safeguards
When using any electrical appliance, basic safety precautions should always be followed
including the following:
Always ensure that the voltage on the rating label corresponds to the mains voltage in
your home.
•
I
ncorrect operation and improper use can damage the appliance and cause injury to the user.
•
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliances by a person responsible for
their safety. Children should be supervised to ensure that they do not play with the appliance.
•
Check the power cord and plug regularly for any damage. If the cord or the plug is damaged,
it must be replaced by the manufacturer or qualified person in order to avoid an electrical
hazard.
•
Do not use the appliance if it has been dropped or damaged in any way. In case of damage,
take the unit in for examination and/or repair by an authorised service agent.
•
Never immerse the unit in water or any other liquid for cleaning purposes.
•
Remove the plug from the socket by gripping the plug. Do not pull on the cord to disconnect
the appliance from the mains. Always unplug the unit when not in use, before cleaning or
when adding or removing parts.
•
The use of accessory attachments that are not recommended or supplied by the
manufacturer may result in injuries, fire or electric shock.
•
Do not let the cord hang over the edge of a table or counter. Ensure that the cord is not in a
position where it can be pulled on inadvertently.
•
Do not allow the cord to touch hot surfaces and do not place on or near a hot gas or electric
burner or in a heated oven.
•
Do not use the appliance on a gas or electric cooking top or over or near an open flame.
•
Use of an extension cord with this appliance is not recommended. However, if it is necessary
to use an extension lead, ensure that the lead is suited to the power consumption of the
appliance to avoid overheating of extension cord, appliance or plug point. Do not place the
extension cord in a position where it can be pulled on by children or animals or tripped over.
•
This appliance is not suitable for outdoor use. Do not use the appliance for anything other
than its intended use.
•
Do not carry the appliance by the power cord.
•
Do not leave the appliance unattended during use. Always unplug the unit when not in use or
before cleaning.
•
Always operate the appliance on a smooth, even, stable surface. Do not place the unit on a
hot surface.
•
Ensure that the unit is switched off after use.
•
The manufacture does not accept responsibility for any damage or injury caused by improper
or incorrect use, or for repairs carried out by unauthorised personnel.
•
In case of technical problems, switch off the product and do not attempt to repair it yourself.
Return the appliance to an authorised service facility for examination, adjustment or repair.
Always insist on the use of original spare parts. Failure to comply with the above mentions
precautions and instructions, could affect the safe operation of this product.
•
Your appliance must never be switched on through an external timer or any kind of separate
remote control system
•
If the supply cord is damaged it must be replaced by the manufacturer, it's service agent or
similarly qualified persons to avoid hazard
•
The iron must not be left unattended when connected to the supply mains
•
The plug must be removed from the socket outlet before tank is filled with water
•
The iron and/or it's stand must be placed on a stable surface
Loading...