Mobile Phone
Brand Name: Zoom, iSWAG
Model Name: Paris
FCC ID: O55454110
Power key: Press and hold this key to turn on/off the mobile
phone; in standby state, press this key to turn on/off the screen
Menu key: Press this key to open the action list, so that you can execute the action in
current interface or menu.
Home key: Press this key to return to the home page from any application or interface.
Back key: Press this key to return to previous interface, or close the dialog box, menu,
notification panel or the screen keypad.
Side key: Press this key to adjust volume
Installation method and precautions of SIM card
By setting PIN (personal identification number) code of the SIM card, you can protect your SIM
card from illegal operation.
Installing SIM card
This is a dual SIM mobile phone with two SIM slots. Please turn off the mobile phone first, take
out the battery, and insert the SIM card into the slot as shown in the picture below; then, place
the battery into the battery jar and install the battery cover.
Precautions of SIM card
By setting PIN (personal identification number) code of the SIM card, you can protect your SIM
card from illegal operation.
If the PIN code is enabled, you need to enter the valid PIN code when you turn on the mobile
phone.
If you input wrong code for three times continuously, your SIM card will be locked and you need
to input PUK code.
Note: Your network service provider will set a standard PIN code (4-8 digits) for your SIM card.
Please change it with your private password as soon as you get the phone.
Connecting to network
When the SIM card is decrypted, the mobile phone will search registered network or available
local network automatically. Once connected, the logo of the network operator appears in the
top of the screen, the mobile phone is in standby state, and you can make or answer calls.
Please contact your network operator if the SIM card has a failure.
Precautions of SIM card:
· Put the SIM card out of children’s reach.
· Please use, insert and remove the SIM card carefully because the SIM card and its contacts are
prone to be scratched or damaged by bending.
· Do not expose the SIM card to electrostatic, dusty or moist environment.
Operation and installation methods of SD card
SD card is a removable mobile memory card inside the mobile phone and used for extending the
storage space of the mobile phone.
Battery and charging methods
1. Connect the charger to provided USB cable.
2. Connect the charger plug to the power outlet.
3. Connect the USB cable to the mobile phone; this icon indicates the charging status.
4. The battery is fully charged when the status icon changes to ; please disconnect the
charger from the power outlet.
5. Disconnect the charger from the mobile phone.
Note: If the battery isn’t used for a long time or the battery is used up, the mobile phone may
be not turned on normally while charging. It is normal. Please charge for a while
before turning on the mobile phone.
The battery can be charged repeatedly; however, it is consumable product, please
change a new battery if the standby duration reduces significantly.
The data service consumes more power and will reduce the standby duration.
The charging time changes according to temperature and battery usage.
The mobile phone will show prompt if the battery is too low. The mobile phone will
power off automatically if battery level drops too low.
Unlocking mode
Mobile phone options list
In standby state, you can press the Power key to lock and turn off the screen, and
press it again to turn on the screen. Press and hold the Power key to open the mobile
phone option list.
Unlocking interface
In locked screen, tap the icon in the bottom of the screen, slide to any
direction unlock the screen, or drag the whole screen to right to access Camera and
take pictures.
Main menu
Main menu page
Slide to left/right on the screen to switch the main menu page, and tap the Menu key to select
Manage applications or Settings
Drag and drop an icon to desktop to create a shortcut.
View notifications
notifications interface of Status bar
quick settings interface of Status bar
Pull down the status bar, you can view the notifications interface directly,in this
interface,you can view notifications of the mobile phone, or tap
icon in top right conner of the screen to display quick setteings interface,in this
interface ,you can turn on/off WLAN, Bluetooth, Data connection, GPS, Flight mode
and customize profiles,etc.
Manage applications
In Manage applications interface, you can manage the running applications to
improve the running speed of the mobile phone. You can view the information of
downloaded applications, applications installed on SD card, running applications and
all applications, restrict permissions or uninstall third party applications.
Contacts
You can search contacts through phone number, email account or name.
Press the Menu key to select Contacts to display, Import/Export, Accounts, Send text
message or Share contacts.
Smart dialing
In dial plate interface, the mobile phone will fuzzy match with local contact info and show in the
result while you are typing. In settings, you can set up voice call, video call, Quick responses and
others.
During a call, you can access the dial plate or contacts through shortcuts.
After typing the number with keypad, press MENU and select Speed dial.
During the call, the backlight turns off when the phone is close to your ear for saving power and
preventing misoperation
Messaging & browser
Messaging interface
Support pinyin, and third party input method software.
Tap Switch to switch among Chinese, English and stroke. If the language of spelling correction is
set to English, tap the word in the input box while typing to get suggested results for choosing.
Browser
There default homepage interface will be show when you open the app first time,you can also
change the default homepage to your favorite webpage site in the settings page. With this
app,you can visit all of the internet webpages,download resource form the web server or watch
video online.
Music
Music interface
Support MP3, aac, ogg, midi and other formats; drag the progress bar while playing to
move to any segment of the music, and tap Play button to pause or play.
Tap and hold artist, album or music name to perform operations such as play, add to
playing list, send to ring tone, delete, and search; select search to search music and play
Camera
Camera function
Tap on the screen to focus and follow the focus automatically, making the capture of moving
object more convenient. You can set best capture, continuous shooting, common mode,
automatic scene detection and other modes. The camera integrates various creative styles; you
can tap to preview different effects.
Dual-camera
Support front camera; tap to switch to front camera and take self photo shoot.
Video recorder
Support video recording，tap to switch to video recorder.
Sound recorder
You can record the sound, and send through MMS or Bluetooth directly, or set as ring tone.
FM radio
Insert the headset and listen to FM radio, which supports loud speaker.
Gallery
You can view the pictures and videos recorded by the camera in Gallery and or pictures and
videos on SD card.
In gallery, you can perform operations to multimedia files such as share, edit and set as wallpaper,
or contact icon.
E-mail
Support Gmail and E-mail; you can create an account and read e-mails at
any time and anywhere with this function, you can merge the e-mails of
different e-mail boxes to the same interface.
File Manager
In File Manager interface, tap the Menu key to select New folder, Cut,
and view the files stored on SD card directly.
Tap and hold a file or folder and select Copy, Cut, Delete, Rename and
other options.
Software store
This mobile phone is designed with built-in “play store”, which provides
popular software and other sources; you can find wanted software
through search or rank list. Experience the desktop shortcut of play store,
get the recommended info quickly, and experience free download
through WIFI or web client.
Settings
Security function
You can set up screen security, encryption, SIM lock, etc.
Backup and reset
In this interface: you can back up the application data, WLAN password
and other settings to Google server；and reset all data stored on the
mobile phone.
Note: Hotspot mode is supported.
Drop-down menu bar
Drop down USB connection in menu bar; as the mobile phone can be set
as flash drive, the files on SD card can be copied to PC or from PC to
mobile phone.
Problem
Reason
Solution
Can’t access
Internet normally
when using
browser
The network operator doesn’t
provide this service or you hasn’t
applied this service
Please contact and consult your
network operator for information of
how to apply and use this service
The setting is not correct
Please refer to specific introductions
of the browser
SIM card error
SIM card is damaged
Please contact your network operator
The SIM card isn‘t installed
properly.
Check the SIM card
The metal surface of the SIM card is
dirty
Clean it with clean cloth
Poor receiving
The mobile phone is used in bad
signal receiving area, for example,
near tall building or in basement,
the radio waves can’t reach these
area effectively
Please make or answer a call in places
with strong signal
The mobile phone is used when
communication is busy and lines
are congested.
Try to avoid using mobile phone when
communication is busy
Can’t switch on
Battery is too low
Charge the battery
Can’t make a call
Call barring is active
Cancel call barring
Can’t connect to
network
SIM card is invalid
Please contact your network operator
Beyond service area
Move to service area of your network
operator
Weak signal
Move to a place with strong signal
and try again
Can’t charge
The voltage is not within rated
range of the charger
Use an allowed voltage within the
rated range of the charger
Nonstandard charger is used.
Use a charger specially designed for
the mobile phone
Poor contact
Check whether the plug is connected
properly
Part Name
Toxic and hazardous substances or elements
Lead
(pb)
Mercury
(Hg)
Cadmium
(Cd)
Hexavalent
chromium
(Cr+6)
Polybrominated
biphenyl
(PBB)
Polybrominated
diphenyl ether
(PBDE)
Troubleshooting
Please refer to the following list of problems and solutions if there is any abnormity when you use
the mobile phone. Please contact the distributor or service provider if it still doesn’t work.
Toxic and Hazardous Substances Declaration
Master unit
○
○
○
○
○
○
Battery
×
○
○
○
○
○
Charger
×
○ × ○ × ×
Accessories
○
○
○
○
○
○
○ :
indicates that this toxic or hazardous substance contained in all the homogeneous materials for
this part is below the limit requirement in SJ/T11363-2006.
×:
indicates that this toxic or hazardous substance contained in at least one of the homogeneous
materials for this part is above the limit requirement in SJ/T11363-2006.
The environmental use period of the product is 20 years. The symbol is shown in the
left. Certain changeable parts may have a different environmental use period (e.g.
battery unit module) pasted on the product. This environmental use period only
applies to the products operated under the condition regulated in the Manual.
FCC RF EXPOSURE INFORMATION:
WARNING!! Read this information before using your phone
In August 1986 the Federal Communications Commission (FCC) of the United States
with its action in Report and Outer FCC 96-326 adopted an updated safety standard for
human exposure to radio frequency (RF) electromagnetic energy emitted by FCC
regulated transmitters. Those guidelines are consistent with the safety standard
previously set by both U.S. and international standards bodies. The design of this phone
complies with the FCC guidelines and these international standards. Use only the
supplied or an approved antenna. Unauthorized antennas modifications, or attachments
could impair call quality, damage the phone, or result in violation of FCC regulations. Do
not use the phone with a damaged antenna. If a damaged antenna comes into contact
with the skin, a minor burn may result. Please contact your local dealer for replacement
antenna.
BODY-WORN OPERATION:
This device was tested for typical body-worn operations with the back of the phone kept
10mm from the body. To comply with FCC RF exposure requirements, a minimum
separation distance of 10mm must be maintained between the user's body and the back
of the phone, including the antenna. Third-party belt-clips, holsters and similar
accessories containing metallic components shall not be used. Body-worn accessories
that cannot maintain 10mm separation distance between the user’s body and the back of
the phone, and have not been tested for typical body-worn operations may not comply
with FCC RF exposure limits and should be avoided.
For more information about RF exposure, please visit the FCC website at www.fcc.gov
Your wireless handheld portable telephone is a low power radio transmitter and receiver.
When it is ON, it receives and also sends out radio frequency (RF) signals. In August,
1996, the Federal Communications Commissions (FCC) adopted RF exposure guidelines
with safety levels for hand-held wireless phones. Those guidelines are consistent with
the safety standards previously set by both U.S. and international standards bodies:
<ANSIC95.1> (1992) / <NCRP Report 86> (1986) / <ICIMIRP> (1996)
Those standards were based on comprehensive and periodic evaluations of the relevant
scientific literature. For example, over 120 scientists, engineers, and physicians from
universities, government health agencies, and industry reviewed the available body of
research to develop the ANSI Standard (C95.1). Nevertheless, we recommend that you
use a hands-free kit with your phone (such as an earpiece or headset) to avoid potential
exposure to RF energy. The design of your phone complies with the FCC guidelines (and
those standards).
Use only the supplied or an approved replacement antenna. Unauthorized antennas,
modifications, or attachments could damage the phone and may violate FCC regulations.
NORMAL POSITION:
Hold the phone as you would any other telephone with the antenna pointed up and over
your shoulder.
RF Exposure Information:
This product is compliance to FCC RF Exposure requirements and refer to FCC website search for
FCC ID: O55454110 to gain further information include SAR Values.
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV interference caused
by unauthorized modifications to this equipment. Such modifications could void the
user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Do not use the device with the environment which below minimum -10℃ or over
maximum 50℃, the device may not work.
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
Ad Hoc function is supported but not able to operate on non-US frequencies.
Loading...