FCC Caution:
Any Changes or modificati
ons not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) information
SAR tests are conducted using standard operating positions accepted by the FCC with the
watch transmitting at its highest certified power level in all tested frequency bands, although
the SAR is determined at the highest certified power level, the actual SAR level of the watch
while operating can be well below the maximum value.
Before a new model watch is a available for sale to the public, it must be tested and certified to
the FCC that it does not exceed the exposure limit established by the FCC, Tests for each
watch are performed in positions and locations (e.g. at the limb
required by the FCC.
For Limb-worn operation, this model watch has been tested and
ines. When used this product, please positions the device a minimum of 10 cm from the face.
guidel
Non-compliance with the above restrictions may result in violation of RF exposure guidelines.
When you start to use this watch, please pay attention to the following information: for safety
concerns, you should only wear the wrist watch on your wrist and the device should Not be
worn on the inside of the wrist (Such as palm side) or in any other configurations during
transmission.
If damaged, please do not attempt repair for yourself.
)as
meets the FCC RF exposure
Loading...