All trademarks are the property of their legal holders.
NOTICE OF RESPONSIBILITY RESTRICTION
Despite the exerted efforts to make this Manual more exact, some discrepancies may occur. The
information in this Manual is given on “as is” terms. The author and the publisher do not bear any
liability to a person or an organization for loss or damage which has arisen from the information
contained in this Manual.
• Unpack the device carefully. Make sure there are no accessories left in the box. Check up the
device for damage; if the product was damaged during transportation, address the firm which
carried out the delivery; if the product functions incorrectly, address the dealer at once.
• Check up the package contents and availability of the warranty card. Make sure the warranty card
has a shop stamp, a legible signature or the seller’s stamp and purchase date, and the number of
the wall mount corresponds to that in the warranty card. Remember: in case of warranty card loss
or discrepancy of numbers you forfeit the right for warranty repairs.
• Before installing and using the wall mount, read this Manual carefully.
t51-44
...........
..........
........
............
........
.............
1
2
2
2
2
3
5
Technical support is on www.sven.fi.
1
ENG
Wall Mount for LED/LCD/Plasma
TVs and Monitors
2. APPLICATION
T51-44 is designed for wall-mounting LED/LCD/Plasma TV sets and monitors.
3. SAFETY PRECAUTIONS
• Do not exceed the maximum load specified in the Manual to avoid accidents or damage.
• Before installing the wall mount, read this Manual carefully and follow all the instructions when
installing. To ensure safe and reliable mounting, it’s recommended that installation be done by
qualified specialists.
• Position your mount away from internal electric wires, water and gas pipes and other dangerous
objects.
• Install the mount on walls of solid brick, concrete, wood or other material providing equivalent
support.
• When installing the mount on a wooden wall, drill the holes as close as possible to the center of
the board to provide secure support.
• Fasten the screws until they are fixed. Do not use electric tools for this purpose.
• For safety reasons, do not install the wall mount alone.
4. SPECIAL FEATURES
• VESA: 100 × 100/ 200 × 200/ 300 × 300/
400 × 400 mm
• Diagonal compatibility: 26" – 55"/
66 – 140 сm
• Level included
• 0° to +15° adjustable tilt angle
• Easy installation and mounting
• High-strength polymer coating
• Security locks
Components and Accessory Kit
M5×12M6×12
4 pcs4 pcs4 pcs
M8×18
5. PACKAGE CONTENTS
• Mount — 1 pc
• Mounting accessory kit — 1 pack
• User’s Мanual — 1 pc
• Warranty card — 1 pc
26" – 55"
66 – 140 cm
100 × 100 mm
200 × 200 mm
300 × 300 mm
400 × 400 mm
2
32 mm
M5×25 M6×25 M8×30
4 pcs4 pcs4 pcs
Ø18 × Ø6,6 Ø 5 × Ø6 × Ø8
4 pcs4 pcs4 pcs4 pcs4 pcs4 pcs 1 pc
ST6×50
1 pc
ENG
User’s Manual
c
d
L = (3 ~ 5) a
H = c + d
t51-44
b
a
H = ?
L
6. MOUNTING AND INSTALLATION
• Choose a wall to hang your mount on.
It’s recommended that the height H and
the distance L from the viewer be calculated according to the formulas in the
figures on the left.
• Then, place the wall plate against the
wall and mark the spots where the holes
should be drilled (see Fig. a). In a wooden
wall, drill Ø 4 mm and 30-40 mm deep
holes; in a brick or concrete wall, drill
Ø 8 mm and 60 mm deep holes (Fig. b).
30-40 mm
Wooden
wall
Brick
wall
Concrete
wall
Ø 4
Ø 8
Ø 8
60 mm
Ø 4Ø 8
3
ENG
Wall Mount for LED/LCD/Plasma
TVs and Monitors
Max 1.5N·M
OPEN
10 mm
• Fix the wall plate on the wall, as shown in
Fig. c, using suitable accessories from the
mounting kit.
• Fix the mounting system on the rear panel
of your TV (see Fig. d).
• Hang your TV on the wall plate, as shown in
Fig. e. The security locks will snap shut.
Adjust the tilt angle as desired.
• For convenience, fasten the cables with ties
from the package, as shown in Fig. f.
4
ENG
User’s Manual
OK
• To unmount your TV, release the security
locks by pulling the tabs down (see Fig. g).
Lift your TV slightly and take the mounting
system out of the holes.
7. TECHNICAL SPECIFICATIONS
Parameter, measurement unit
Diagonal compatibility, inch/cm
VESA range, mm
Maximum load, kg
Mounting type
Number of degrees of freedom
Distance from wall, mm
Coating type
t51-44
7
OPEN
Value
26 – 55/66 – 140
100 × 100/200 × 200/300 × 300/400 × 400
30
tilt
1
32
high-quality polymer
Notes:
• Technical specifications given in this table are supplemental information and cannot give
occasion to claims.
• Technical specifications are subject to change without notice due to the improvement of
SVEN production.
5
Wall Mount for LED/LCD/Plasma
TVs and Monitors
Модель: T51-44
Импортер в России: ООО «СКАНДИТРЕЛ»,
111024, РФ, г. Москва, ул. Авиамоторная, д. 65, стр. 1.
Уполномоченная организация в России: ООО «РТ-Ф»,
105082, г. Москва, ул. Фридриха Энгельса, д. 75, стр. 5.
Условия гарантийного обслуживания смотрите
в гарантийном талоне или на сайте www.sven.fi.
Гарантийный срок: 5 лет.
Срок службы: 15 лет.
Производитель: «СВЕН ПТЕ. Лимитед», 176
Джу Чиат Роуд, № 02-02, Сингапур, 427447.
Произведено под контролем «Свен Скандинавия
Лимитед», 48310, Финляндия, Котка,
Котолахдентие, 15. Сделано в Китае
Manufacturer: SVEN PTE. LTD, 176 Joo Chiat Road,
№ 02-02, Singapore, 427447. Produced under the control
of Oy Sven Scandinavia Ltd. 15, Kotolahdentie, Kotka,
Finland, 48310. Made in China.
® Registered Trademark of Oy SVEN
Scandinavia Ltd. Finland.
.
t51-44
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.