All trademarks are the property of their legal holders.
NOTICE OF RESPONSIBILITY RESTRICTION
Despite the exerted efforts to make this Manual more exact, some discrepancies may occur.
The information in this Manual is given on «as is» terms. The author and the publisher do not bear
any liability to a person or an organization for loss or damage which has arisen from the information
contained in this Manual.
• Unpack the device carefully. Make sure there are no accessories left in the box. Check up the
device for damage; if the product was damaged during transportation, address the firm which
carried out the delivery; if the product functions incorrectly, address the dealer at once.
• Check up the package contents and availability of the warranty card. Make sure the warranty
card has a shop stamp, a legible signature or the seller’s stamp and purchase date, and the number
of the wall mount corresponds to that in the warranty card. Remember: in case of warranty card
loss or discrepancy of numbers you forfeit the right for warranty repairs.
• Do not switch on the speaker system immediately after you bring it into a room from environment with negative temperature! After unpacking, the speaker system should be kept in conditions
of room temperature for at least 4 hours.
• Before installing and using the speaker system, read this Manual carefully and keep it for future
reference.
HT-435R
Technical support is on www.sven.fi.
1
Page 3
ENG
5.1 Active Home Theater
you want - we can
2. PACKAGE CONTENTS
• Subwoofer – 1 pc
• Satellites – 4 pcs
• Remote control (RC) – 1 pc
• RC batteries (AAA type) – 2 pcs
• Signal stereo cable – 3 pcs
• Audio cable – 5 pcs
• Operation manual – 1pc
• Warranty card – 1pc
3. SAFETY PRECAUTIONS
Caution! High voltage inside! To avoid the risk of electric shock do not
open and touch elements inside.
• To avoid electric shock, do not open the HTSS and do not perform repairs by yourself. Service and
repairs should be performed only by qualified specialists in an authorized ser vice center. The list of
authorized service centers is available on www.sven.fi
• Do not allow the circuit of wires (including the grounded ones) between the speakers, on the power
amplifier or the ground, for it causes damage to the power amplifier output stage.
• Do not touch the HTSS power cord plug pins for 2 seconds after unplugging it from the mains.
• Do not put foreign objects inside the holes of the HTSS.
• The product shall not be exposed to water dripping or splashing and no objects filled with liquids, such
as vases shall be placed on the product.
• Protect the HTSS from heating: do not locate it near heating appliances or expose to direct sunlight.
• Do not place sources of open flame on or near the HTSS.
• Donэt place the HTSS in poorly ventilated areas. Leave an air gap of 10 cm or more. When operating
the HTSS, do not put any devices on it, do not cover it with cloth or other objects preventing it from
cooling.
• HTSS has the device of cutting off connection, easy to operate. If the МAINS plug and coupled appa-
ratus used as the disconnect device, the disconnect device should be convenient to insert and pull out.
• Do not clean the HTSS with chemicals, use dry soft cloth only.
Speaker System
4. TECHNICAL DESCRIPTION
НТ-435R 5.1 Home Theater Speaker System (HTSS) is designed for creating a home theater. The multi-
channel 5.1 amplifier built into the subwoofer enables to connect the HTSS to virtually any audio source.
HTSS special features
• Integrated 5.1 amplifier
• Analog stereo input
• Possibility to play stereo through all satellites
• Full-function remote control
• LED indication
• Wall-mountable satellites
2
Page 4
ENG
Operation Manual
Description of the front panel
a STANDBY: STANDBY LED
b POWER: on/o button
c IR: IR WINDOW
d AUX: AUX mode LED
e DVD: DVD mode LED
f VOL-/VOL+: speaker volume LED
g INPUT SELECT: input selector button
to DVD/AUX-system
h 2.1/5.1: mode select button
i VOL-/VOL+: volume control button
Description of the rear panel of the subwoofer
a AUX(L/R): AUX input connectors
b INPUT (5.1CH):
• FL/FR: front Left/Right channel input connectors
d Safety fuse
e ON/OFF: on/o power switch
f Power cord
HT-435R
a
b
a
b
c
d
e
f
Fig. 1. Front control panel
g
h
i
FUSE
AC 220V~50Hz
Fig. 2. Rear panel
c
d
e
f
3
Page 5
ENG
you want - we can
Remote control
a POWER: POWER button
b RESET: return to default settings
c MUTE: sound o/on button
d INPUT: audio input selection button
e 2.1/5.1: 2.1/5.1 mode selection button
f TREBLE+/-: treble level control buttons
g BASS+/-: bass level control buttons
h FRONT +/-: front channel volume control buttons
i CENTRE +/-: center channel volume control buttons
j REAR+/-: surround speakers channel volume control buttons
k SUB+/-: subwoofer channel volume control buttons
l VOLUME +/-: master volume control buttons
Remote control battery installation
• Open the battery compartment on the back of the remote control.
• Insert 2 AAA type batteries (included).
• Close the battery compartment.
Notes:
• Use the remote control at an angle of no more than 30°, no
more than 7 meters away.
• Direct the RC at the IR receiver display on the subwoofer.
• If the remote control does not work, check the battery or replace the discharged battery with a new one.
• Remove the battery from the remote control if you don’t intend
to use it for a long time (more than a week).
5.1 Active Home Theater
Speaker System
Fig. 3. Remote control
5. PREPARATION AND OPERATION
Speaker placement
• To achieve optimum sound, it’s recommended that you place the
speakers according to Fig. 5. The center and front speakers should
be located along an imaginary circle with the distance between the
listener and the center channel speaker as a radius, and the listener’s head as the center. Each of the three speakers should be
placed at equal distance from the listener. The front speakers and
the listener make up an equilateral triangle. The rear speakers are
placed at the same distance from the listener (on the imaginary
circle, too) at an angle of nearly 110° to the Listener – Display axis.
• Avoid placing your speakers in the corners and close to walls, as
this can lead to unwanted resonance and distortions. If possible,
place them at least 20 cm away from walls.
• For more accurate perception, the tweeters should be at the listener’s ear level.
• Do not locate the speakers in niches. Such placement can aect the sound badly, especially in the lows.
• The subwoofer emits non-directional sound, therefore it can be located in any place of the room where
it sounds the best.
Fig. 4. Battery installation
4
Page 6
ENG
Operation Manual
Fig. 5. Placement of the speakers
Connections illustration
• To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and
turn o the power on all devices before making any connections.
• Connect the Subwoofer, the Center, the Front and the Surround Speakers (sww Fig. 6).
HT-435R
SUB
SRFLFRSLCEN
FUSE
Fig. 6. Connections of the Subwoofer, the Center, the Front and the Surround Speakers
5
Page 7
ENG
you want - we can
Sound source installation diagram
T
U
P
T
IN
IO
D
U
A
L
FL
CEN
SL
FR
SW
SR
R
AUX
DVD(5.1CH)
T
U
P
T
IN
IO
D
U
A
L
FL
CEN
FR
SW
SRSL
R
AUX
DVD(5.1CH)
AUDIO
Sound card,
CD-player,
MP3-player
5.1 Active Home Theater
Speaker System
T
U
P
T
IN
IO
D
U
A
L
FL
CEN
R
FR
SW
SRSL
AUX
DVD(5.1CH)
FRFL
SWC
SRSL
DVD-player
FRONT
REAR
CENTER\SUB
AUDIO
5.1-channel sound card
Fig. 7. Sound source installation diagram
Operation
• Switch on the HTTS with POWER switche (ON position) on the subwoofer rear panel (Fig. 2). The device
will switch on in standby mode. To turn the system to operation mode.
• Press STANDBY button a on the remote control (Fig. 3) or on the subwoofer front panel (Fig. 1). AUX
stereo input is active by default. Choose an input with corresponding remote control buttons or INPUT
SELECT g button on the front panel. At your own discretion with the help of corresponding remote
control buttons or on the subwoofer front panel adjust the volume: with buttons VOL (+/-) – the master
volume control, with FRONT (+/-) – front channels, CENTER (+/-) – central channel and REAR (+/-) – rear
channels volume control.
• RESET button k for returning to default settings.
• 2.1/5.1 mode button i is used for playing a stereo signal via AUX stereo input, and the signal is reproduced
with all the satellites.
Note. If you aren’t going to use the system for a long time, mind to turn the POWER switch e on the
subwoofer rear panel to OFF position and unplug the power cable f.
6
Page 8
ENG
Operation Manual
6. TROUBLESHOOTING
Problem
No power.
No sound.
Subwoofer no
sound or volume
low.
Distortion.
The remote control
malfunctions.
If none of the above methods can not solve the problem, please seek professional advice at your nearest service center. Never attempt to repair the product yourself.
7. TECHNICAL SPECIFICATIONS
Parameter, measurement unit
Output power (RMS), W:
Speaker diameters, mm:
subwoofer
front, rear satellites
center satellite
Supply voltage, V/Hz
Frequency range, Hz:
subwoofer
satellites
Dimensions (one speaker), mm:
subwoofer
front, rear satellites
center satellite
Weight, kg
Cause
The power plug connected improperly.
The power switch doesn’t turn on.
The volume regulator is at minimum position.
The signal source is connected improperly.
Wrong choice for signal in selector.
The mute button on the remote control
is activated.
The signal source improper connection.
The subwoofer volume regulator is at minimum
position.
Volume is too loud.
The RC receiving window on the panel is hidden
or don’t face the receiving window.
Value
110 (35 + 5 × 15)
= 165
full range = 76
full range 2 × = 76
AC 220/50
40 – 150
150 – 20 000
313 × 170 × 313
95 × 110 × 120
95 × 220 × 110
8.5
HT-435R
Solution
Reconnect properly.
Turn on the power switch.
Turn the volume regulator properly.
Connect properly.
Choose signal source correctly.
Press mute button on the RC or volume
control button once.
Connect the signal source properly.
Adjust the subwoofer regulator
properly.
Adjust the volume regulator properly.
Please remove the barrier or let the
RC face receiving window.
Notes. The above specifications are only for reference. Technical specifications and package
contents are subject to change without notice due to the improvement of SVEN production. Durabilit y —
5 years. Technical support is on w ww.sven.fi.
7
Page 9
5.1 Active Home Theater
Speaker System
you want - we can
Модель: HT-435R
Импортер в России: ООО «СКАНДИТРЕЛ», 111024,
РФ, г. Москва, ул. Авиамоторная, д. 65, стр. 1.
Уполномоченная организация в России:
ООО «РТ-Ф», 105082, г. Москва,
ул. Фридриха Энгельса, д. 75, стр. 5.
Условия гарантийного обслуживания смотрите
в гарантийном талоне или на сайте www.sven..
Гарантийный срок: 12 мес. Срок службы: 5 лет.
Производитель: «СВЕН ПТЕ. Лимитед», 176
Джу Чиат Роуд, № 02-02, Сингапур, 427447.
Произведено под контролем «Свен Скандинавия
Лимитед», 48310, Финляндия, Котка, Котолахдентие,
15. Сделано в Китае.
Manufacturer: SVEN PTE. LTD, 176 Joo Chiat Road,
№ 02-02, Singapore, 427447. Produced under the control
of Oy Sven Scandinavia Ltd. 15, Kotolahdentie, Kotka,
Finland, 48310. Made in China.
® Registered Trademark of Oy SVEN
Scandinavia Ltd. Finland.
HT-435R
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.