User Manual for RCN1008
The remote control used RF4CE protocol to send RF signals (buttons and rotary wheel) for
device controlling. The remote can be used after pairing with a dedicated device which was
installed with a receiver dongle.
RCN1008 was used as a dongle which need to be installed in customer’s device. It offers
several different interfaces, like UART, SPI and I2C to communicate with customer’s device
according predefined protocol.
1: product figure (RCN1008)
3: Technical specifications
RF operating frequency: 2425MHz, 2450MHz, 2475MHz
Reference frequency: 2.400GHz
Channel spacing: 25MHz
Modulation method: Offset-Quadrature Phase Shift Keying
Communication rate: 250Kbps
Output power: 1DBm
Communication mechanism: applied Zigbee frequency hopping mechanism, passively frequency
hopping.
Average operating current：<25mA
Static operating current: key press waking up <30uA
Operating voltage：2.5V-3.4V
Max remitting current: 20mA
Max rate：250Kbit/s
Receiving sensitivity： -85dbm
Receiving current：<20mA
Sleep current：<20uA
Max receiving distance：>15M
Normal operating receiving distance： 10M
4: Warning
- Do not disassemble, repair, modify or replace the remote control Unit or any of its
components.
- Please comply with the national and international flight safety regulations when using
device during your flight trip.
- When storing rechargeable batteries for collection, keep in a vented, non-metal container.
Operating for this product is between 40°F~103°F (5°C~40°C). Storage for this product is
between -4F°~185°F(-20°C~85°C).
- Do NOT dispose of the battery in public trash; it is unlawful under state and federal
environmental laws and regulations.
- Please dispose of the battery at local battery recycling center.
- This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation；
Loading...