SAM-MS34 Multi-Switch Module
User Guide
3 x 4 Multi-Switch
40 – 2150 MHz
DIRECTV® APPROVED
FOR TECHNICAL SUPPORT, PLEASE CALL
®
ZINWELL
CORPORATION (909)444-1518,910-8680
1001 East Hwy 212
Hector, MN 55342
www.suttleonline.com
Toll Free: 1-800-852-8662
Local: 1-320-848-6711
Fax: 320-848-2361
Module Installation
Mounting:
Align the mounting pins with the grid holes on the back of the enclosure.
With the mounting pin plungers in the “out” position, press the unit into
the grid in the desired location, secure by pushing the plungers in.
Terminate incoming/outgoing coaxial cable:
Install F male connectorized RF coaxial cables from the satellite to the
“18V SAT” and “13V SAT” ports. Install F male connectorized RF coaxial
cables from the “RX1” through “RX4” ports to the receiver(s). If CATV or
antenna signal is used, install an F male connectorized RF coaxial cable
to the “ANT IN” port. In this case a diplexer must be used on the output
ports to split the satellite signal to the receiver and the antenna signal to
the TV. Use the port identification label to record the output locations.
Satellite
SATELLITE – UHF/VHF/CATV
DIPLEXER (optional)
Diplexer may be omitted if
UHF/VHF/CATV is not needed
for the application. In this case
connect multi-switch directly
TV
DIPLEXER
CATV/Ant.
(optional)
To minimize off-air analog signal ghosting or
off-air digital signal degradation, the 75-ohm
terminators (3 included) should be used on all
unused outputs as shown. Any unused cable
connected to the output should also be thus
terminated at the connector plate. Save
unused terminators for future applications.
RECEIVER
75-ohm TERMINATOR
p/n 100968-00 Rev. A
Loading...