Survivor MMR-88 DAB Instructions Manual
Version 1
中文
GB
SURVIVOR DAB
MMR-88 DAB
1
Important safety instructions
1. Please read these instructions carefully.
2. Please keep these instructions for future reference.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the
manufacturer's instructions.
8. Do not install near any heat sources such as radiators, heat
registers, stoves or other apparatus (including amplifiers) that
produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type
plug. A polarized plug has two blades with one wider than the other.
A grounding type plug has two blades and a third grounding prong.
The wide blade or the third prong are provided for your safety. If the
provided plug does not t into your outlet, consult an electrician for
replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly
at plugs, convenience receptacles and the point where they exit from
the apparatus.
11. Only use attachments/accessories specied by the manufacturer.
12. Use only with the cart, stand, tripod, bracket or table specied by the
manufacturer or sold with the apparatus. When a cart is used, use
caution when moving the cart/apparatus combination to avoid injury
from tip-over.
13. Unplug this apparatus during lightning storms or when unused for a
long period of time.
2
GB
14. Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way, such
as power-supply cord or plug is damaged, liquid has been spilled
or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture does not operate normally or has been
dropped.
15. Apparatus shall not be exposed to dripping or splashing and no
objects filled with liquids, such as vases, shall be placed on the
apparatus.
16. To reduce the risk of fire or electric shock, do not expose this
apparatus to rain or moisture.
17. The battery shall not be exposed to excessive heat such as
sunshine, re or the like.
18. CAUTION: Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
19. To prevent possible hearing damage, do not listen at high
volume levels for long periods.
CAUTION:
To reduce the risk of the electric shock, do not perform any servicing
other than that contained in the operating instructions unless you are
qualied to do so.
3
4
GB
Controls
LED Flashlight button
Solar charging panel
Charging indicator
Low battery indicator
LCD display
Tuning up button
Power button
Tuning down button
Speaker
Select/Lock button
Info/Menu button
Band button
Preset button
Volume Control -down
Volume Control - up
LED Flashlight
3.5 mm headphone socket
USB charging socket to mobile phones or MP3 players
Micro USB charging outlet
Carrying strap holder
Telescopic antenna
Dynamo power hand crank
Battery compartment
The SURVIVOR DAB (MMR-88 DAB) is powered by an 850mAh
rechargeable Lithium-ion battery (supplied). Before operating the radio
for the rst time, ensure that you fully charge the supplied battery.
Inserting the supplied rechargeable battery
1. Open the battery compartment on the bottom of the unit by pushing
the battery door following the arrow direction.
2. Insert the supplied rechargeable battery into the space in the
compartment. Make sure the battery is inserted with correct polarity as
shown in the compartment.
23
22
21
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
5
Recharging the radio
Note:
Please use one of the following methods to recharge your radio or when
the battery power indicator LED blinks indicating the battery power is
low.
1. Using the supplied USB to Micro USB cable simply plug the USB end
into a USB socket on a computer, tablet or any USB power supply.
Then plug the Micro USB end into the Micro USB socket on the right
hand side of the radio.
2. Using an AC adapter with a Micro USB connector (not supplied) plug
the AC adapter into a standard AC outlet. Then plug the Micro USB
end into the Micro USB socket on the right hand side of the radio. The
battery power icon will illuminate showing that charging is in progress.
The CHARGE LED indicator will also be on at the same time during
the charging process.
NOTE:
The radio will begin charging the Lithium-ion battery. Charging time will
take approx. 2 hours to be fully charged. The battery power icon will
stop ashing when the radio is fully charged. Reduced power, distortion,
stuttering sounds or when the battery power indicator light is low are all
signs that the battery needs to be recharged.
NOTE:
The radio can play approx. 10 hours when the battery is fully charged.
Using Dynamo power
1. Make sure the telescopic antenna is in the rest position before rotating
the dynamo handle.
2. Take the Dynamo power handle from its rest position.
3. Rotate the Dynamo power handle approx. 120 rotations per minute,
either clock-wise or counter-clock wise until the charging LED indicator
appears red.
4. Under normal listening conditions, one minute of charging from
Dynamo power will allow you to listen to the radio for approx. 5-7
minutes.
5. Make sure the handle is in its rest position after charging is completed.
Loading...