HOW TO OPERATE
1. Slide and remove the battery lid, install two
AAA/UM-4 batteries matching correct (+) and (
-
)
poles as indicated, then slide the battery lid back.
2. Pull out the antenna and turn on the switch to upper
side.
3. The power LED (Green) will be lit up to confirm the
detector is operated correctly.
4. If the strength indication LED is lit up and the buzzer
goes off, adjust the sensitivity by tuning the
Sensitivity Tuner to
-
(minus) side to decrease the
sensitivity until the Level 1 (Yellow) LED slightly
lights up.
5. When the detector detects a cellular phone or wireless
hidden camera, the strength of indicator will be lit up,
from Level 1 (Yellow) -> Level 2 (Yellow) -> Level 3
(Red ) indicating the strength of detected signals.
6. Meanwhile, the buzzer will be beeping and the sound
will be changing from slow to rapid, indicating the
strength of detected signals.
SILENT DETECTION
•
SH-055SR
: Set the power switch to bottom
SILENT
mode.
•
SH-055SRV
: Set the power switch to bottom
VIBRATING
mode.
• By earphone hearing.
SENSITIVITY ADJUSTMENT
Turn the Sensitivity Tuner to - (minus) side to decrease the
sensitivity and the detecting distance will be shorter. Turn the
Sensitivity Tuner to + (plus) side to increase the sensitivity and
the detecting distance will be longer.
INTERFERENCE (BACKGROUND NOISE)
ELIMINATION
1. The Sensitivity tuner is also used to eliminate the background
noise (interference).
2. If the scanned environment has other noises that interfere with
your detector, the strength indication LED will be lit up.
3. If this condition appears, adjust the sensitivity by tuning the
Sensitivity Tuner to - (minus) side to decrease the sensitivity
until the Level 1 (Yellow) LED slightly lights up.
4. In normal condition, when to turn on the power, only the
Power LED (Green) lights up to confirm the detector is in
normal condition.
PRINCIPLE PARTS
User's Manual
Suresafe™
Thank you for purchasing the Suresafe™ RF (Radio Frequency)
Signal Detector. Please first read over this manual for proper use,
save this manual and keep it handy.
SH-055SR, SH-055SRV
Superior sensitivity
RF Signal Detector
Exposing Spy Camera, Bug and Cellular Phone, etc.
GENERAL
This device applies with fuzzy scanning technology to detect
peeping cameras, bug, cellular phones and other radio frequency
devices. This device surely avoids being peeped or tapped to
protect privacy or protect information being disclosed secretly.
This device has 3 LEDs. When to detect cellular phone or
peeping camera, the LED will light from Level 1 to Level 2 to
Level 3, and the beeping sound will change from Slow to Rapid
indicating the strength of detected signal.
• SH-055SR: This model also has SILENT detection to reduce
the embarrassment of beep sound when to scan an
environment.
• SH-055SRV: This model also has VIBRATING detection to
warn you when you do not hold this device in
hand to scan an environment.
• Besides, you also can detect by earphone hearing without
other' awareness.
SH-055SR
SH-055SRV
Level 3
Level 2
Level 1
Power
Sound
Vibrate
Off
Sensitivity
Tuner
RF Signal Detector
OFF
earphone
Level 3
Level 2
Level 1
Power
OFF
Sound
Silent
Off
Sensitivity
Tuner
RF Signal Detector
earphone
FEATURES
1. Detecting frequency from 50 MHz ~ 6.0 GHz covering all
kinds of hidden cameras, cellular phones and Bugs, etc.
2. Fuzzy technique of multi-channel scanning.
3. Audio and light warning indicate the strength of detected
signals.
4. Three kinds of detecting method for selection: Sound, Silent
or Earphone hearing, fit to use anytime, anywhere.
5. Advanced sensitivity tuner for background noise elimination
and distance adjustment.
1. If you are not going to use this device for a long time,
remove the batteries to avoid damage caused by corrosion
from battery leakage.
2. Unauthorized repair or disassembly of this device will void
all the warranties.
3. Avoid water.
4. Do not store this device in an excessively hot place.
5. Avoid impact or dropping this device.
NOTICE OF USE
04.2006
55SRPK1A
WARNING
Use this device as an auxiliary, supplemental help or aid to prevent
the risks caused by hidden camera, cellular phone or other wireless
devices. This device does not take the place of all the supervisions.
Performance of this Radio frequency (RF) product will be affected by
the circumstance of use. The producer and marketing group accepts
no liability for any loss or damage by malfunction or misuse.
COPYRIGHT
No part of this manual may be reproduced, transmitted, transcribed, or
translated into any language in any form by any means, electrical or
mechanical, including photocopying, recording, or information and
retrieval systems, without the express written permission of
manufacturer. Products mentioned in this manual are for identification
purposes only. All brand names appearing in this manual may or may
not be registered trademarks or copyrights of their respective
companies. The manufacturer reserves the right to change or modify
the specifications of any one or all of these products as deemed
necessary at any time without prior notification. The manufacturer
may further revise this manual from time to time without prior notice.
Copyright 1999-2003, All rights reserved.
Suresafe™, Pro Hunter™ are trademark of the manufacturer.
HOW TO DISTINGUISH IF IT IS A SIGNAL OF
WIRELESS CAMERA OR HIDDEN MICROPHONE
OR CELLULAR PHONE ?
The signal wave of wireless camera and hidden
microphone is continuous wave, so the LED of the
detector will light up without blinking when the detector
detects a wireless camera or hidden microphone. And the
buzzer will go off continuously.
The signal wave of cellular phone is pulse wave, so the
LED of the detector will be blinking when the detector
detects someone uses cellular phone. And the buzzer will
go off discontinuously and in small sound.
* Specifications may change without notice
SPECIFICATION
Power AAA / UM-4 battery x 2, 3V DC
Detecting frequencies 50 MHz - 6.0 GHz
Dimension L 87 x W 55 x H 24 mm
Weight 105 g
Warning mode 1 Audible alarm and 3 LEDs
Warning mode 2 Silent, only 3 LEDs (SH-055SR)
Vibration and 3 LEDs (SH-055SRV)
Warning mode 3 Silent, 3 LEDs and earphone hearing
about 8 feet (regular 10mW)
about 20 feet (regular 10mW)
about 40 feet
Detecting Distance :
5.8GHz
Wireless camera
2.4
GHz Wireless camera
Cellular phone
LOW BATTERY WARNING
If your detector is turned on, and the bottom LED (Red) lights
up without blinking, it means the batteries run down. Please
replace batteries.
Loading...