Super Vision International IGP231, IGS54 Installation Manual

8210 Presidents Drive

Orlando,Florida 32809

svision.com

WARNING!

PERMANENT

DAMAGE T O THE

12VACLAMP WILL

OCCUR IF IT

INSTALLED IN A

120V

AC

SOCKET.

The IGS54 and the IGS321
are available in either
12VAC(low volatge) model
and a 120VAC mode.
The 120V

AC light has a
gold or brass colored
Edison screw base.
The 12V

AC Edison screw
base is a silver or aluminim
color.

DANGER!

RISK OF ELECTRICAL

SHOCK OR

ELECTROCUTION

Always disconnect power
to the pool or spa light at
the circuit breaker before
servicing the light. Failure
to do so could result in
death or serious injury to
the installer, servicemen.
pool and spa users or
others due to electrical
shock.
Refer to the original
manufacturer’s installation
manual before proceeding.

This device is not intended
for use with emergency
exit fixtures or emergency
exit lights.

IGS54
Spa LED Lamp

DELIVER T O HOMEO WNER

IGP231/IGS54

Galax y LED Lamp

Installation/Operation/Warranty

This guide contains important information on installing
and using your Galaxy LED Lamp. Please read it
carefully and save it for future reference.

Rated Lamp Life

The illumination generated by the Galaxy LED Lamp is
based on Light Emitting Diodes (LED) whose predicted
source life is rated at 100,000 elapsed time hours under
normal operating conditions.
[Temperature: -4° to 104°F (-20°C to 40°C), Humidity:
0-95% non-condensing humidity]. This equates to 11.4
years of continuous 24-hour a day usage.

Safety Precautions

Do not open, alter or tamper with the product. This
will void the manufacturer’s warranty. Follow all
instructions in the user guide,and observe all warnings
carefully.

• Do not allow the LED unit to get wet. I t is conformal
coated to protect it from moisture.

• Keep the unit dry.

• Handle the Galaxy LED Lamp as you would any
delicate product. Be careful not to drop the unit.

IGP231
Pool LED Lamp

Installation for IGP231/IGS54
Galaxy LED Pool &Spa Lamps

NOTE: Galaxy LED Lamp fits most 12VAC and 120VAC wedge-based lighting
sockets. Galaxy LED Lamp are not for use with spas that have dimming systems or
electronic controllers.

STEP 1

Access the old lamp according to your spa
manufacturer’s instructions. Remove the locking
ring. (Fig.1)

STEP 2

Remove the existing lamp.(Fig.2),

WARNING: Always install a new lens gasket
whenever disassembling the light. Failure to do so
may permit water to leak into the assembly,
which could cause:an electrical hazard resulting in
death or serious injury to pool and spa users,
installers or others due to electrical
shock; or breakage of the lamp or lens
which could result in serious injury to
pool and spa users, installers,
bystanders,or in proper ty damage.

STEP 3

Replace the existing gasket with a new

one. (Fig.3)

STEP 4

Screw in the Galaxy
LED Lamp into the
socket.

(Fig.4A,4B)

(Fig.1)

(Fig.2)

(Fig.3)

(Fig.4A)

(Fig.4B)