Page 1
User Manual:
Please read this user manual carefully before installation. Keep user manual for further reference.
Technical Data:
Model Rated Voltage Input Frequency Rated Wattage Rated Current Lamp Cap
EB-3W 110-130V 60Hz 3 40 E26
EG-3W 110-130V 60Hz 3 40 E26
EU-5W 110-130V 60Hz 5 70 E26
EF-5W 110-130V 60Hz 5 70 E26
EG-7W 110-130V 60Hz 7 95 E26
Treatment of the lamp
- Please don't drop the lamp or push against it.
- Please don't disassemble the lamp, don't make alterations.2
Installation
- Can't be used in dimming circuit.
- Don't install inside a recessed area in the wall.
- Don't use lids without ventilation openings.
- Don't cover with a glass bowl.
- For lamps with a weight significantly higher than that of the lamps for which they are
a replacement, attention should be drawn to the fact that the increased weight may reduce the
mechanical stability of certain luminaire.
Electrical connection
- Use only in indoor areas at an ambient temperature 25°C.
- Don't use as emergency lighting.
- To avoid electrical shock, don't install in damp or wet locations.
Remarks
- Don't touch the lamp directly with your hand or face when it is in use to avoid burns.
- If the lamp is damaged, replace it by a new one and don't try to repair it in order to avoid hazards.
- If this lamp should be replaced by a heavier one, please take care that the mechanical stability of
the luminaire could be impaired by the increased weight.
- Energy saving lamps containing a small amount of quicksilver/mercury (ca. 5 mg). Nevertheless
the toxicity of this small amount requires a disposal as hazarduse waste.
- In the case a lamp breaks, there is no direct risk for the healthiness, but don’t touch powdery
substances, improve air ventilation. Keep children away.
Page 2
Warnings
This product complier with Part 18 of the FCC rules but may cause interference to televisions,
radios, wireless remote control or maritime safety communications equipment or other critical
navigation or communication equipment operating between 0.45-30MHz. If interference should
occur, move the lamp away from the appliance a distance of three feet or more. Or plug the
lamp or the compliance into a different outlet.
Loading...