SuperTek SteamTek 3 User Manual

USER’S GUIDE

OPERATING
INSTRUCTIONS

&
IMPORTANT
SAFETY
INFORMATION

Please read all the instructions
carefully prior to using the
SteamTek3 Mop for the first time.
Keep this manual in a safe place for
future reference.

Congratulations for choosing the

3 – in – 1 Steam Mop

It cleans, shines, sanitizes and deodorizes

hard floor surfaces, carpets, and

now features a detachable, hand-held steamer

for tough to reach areas, even fabric.

The powerful SteamTek3

releases 1500W of high pressure steam

at 90 – 100ºC (194-212ºF)

to help disinfect, destroy fungus, mildew and dust mites

without chemicals or detergents.

IMPORTANT SAFETY CAUTIONS

PLEASE READ ALL INSTRUCTIONS BEFORE USING THE STEAMTEK3

WARNING - DANGER OF SCALDING

CAUTION:

1. Make sure to connect unit to a grounded outlet only which corresponds to these voltage
specifications: - 110-120V, 60HZ, 1500W

- 220-230V, 50/60HZ, 1500W

2. DO NOT use unit if the cord or plug is damaged. If the power cord is damaged, it must
be replaced by a qualified electrician to avoid shock or injury.

3. DO NOT force the plug into an outlet.

4. DO NOT use with outlets or extension cords that do not have adequate current carrying
capacity.

5. DO NOT unplug unit by the cord. Pull the plug only to unplug unit from power outlet.

6. DO NOT leave the SteamTek3 Mop unattended while in the ON position.

7. DO NOT leave the SteamTek3 Mop in a stationary position while in the ON position to
avoid any possible damage to your floor/carpet.

8. DO NOT allow children to operate the SteamTek3 Mop.

9. DO NOT carry/pull the unit by the cord or use the cord as a handle.

10. Be careful to not damage cord while closing doors, while using near sharp edges and
corners, and keep away from heaters and heated surfaces.

11. DO NOT use the SteamTek3 Mop or handle the plug with wet hands.

12. DO NOT operate while barefoot.

13. EXERCISE CAUTION when using the SteamTek3 Mop around children, pets and plants.

14. DO NOT use without floor pad in place.

15. DO NOT use without water in the tank.

16. DO NOT put cleaning products into the SteamTek3 Mop water tank as this will cause
unsafe operation and will damage the unit.

17. DO NOT block the steam openings of the unit. Check frequently for lint, hair, and other
blockages which could block the steam opening.

18. The SteamTek3 Mop is designed for domestic use only.

19. USE ONLY as outlined in this booklet.

20. DO NOT use the SteamTek3 Mop outside.

21. DO NOT use on walls, windows or ceilings. The SteamTek3 Mop is to be used only on
floors.

22. DO NOT use on unsealed wood floors or cork-tiled floors as the heat and steam will
remove the finish from the surface.

23. Store in a cool, dry place.

24. DO NOT immerse unit in water or other liquids. DO NOT expose unit to rain.

1

25. Always make sure that the steam outlets are kept clear. DO NOT insert any objects into
steam openings. DO NOT use unit with any blocked openings.

26. DO NOT aim steam directly at people or pets.

27. Use mop only as directed in this manual and use only with the included accessories.
Use of other attachments may cause fire, electric shock or injury.

28. DO NOT direct steam towards equipment containing electrical components such as
oven interiors.

29. DO NOT use the SteamTek3 in enclosed spaces where flammable, explosive or toxic vapors
may be present. (Paint thinner, oil-based paints, etc.)

30. DO NOT use unit on leather, wax polished furniture and floors, unsealed hardwood or
parquet floors, synthetic fabrics, velvet or other steam-sensitive materials.

31. DO NOT use for any space heating purposes.

32. ALWAYS UNPLUG UNIT before servicing.

33. DO NOT MODIFY the plug. If it does not fit your outlet, have one installed by a licensed
electrician.

34. DO NOT USE any plug adapters.

35. This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instructions concerning use of the appliance by a
person responsible for their safety.

THE STEAMTEK3 IS INTENDED FOR HOUSEHOLD USE ONLY.

Commercial/industrial use of this unit will void the manufacturer’s warranty.

The SteamTek3 Mop is designed to clean carpets, vinyl, ceramic, stone, linoleum, sealed
hardwood and parquet floor surfaces. The steam reaches temperatures of between 90 – 100ºC
(194 – 212ºF). Exercise caution when using on vinyl, linoleum or any other heat sensitive floors
as too much heat can melt the glue in the flooring. DO NOT use on unsealed wood floors or let
unit stand on any wood floor for an extended period as this could cause the wood grain to swell.
DO NOT use on any floor surfaces that have been treated as the steam and heat could remove
the finish. DO NOT use the carpet glider (14) on floor surfaces other than carpeting as it could
possibly streak, scratch or otherwise damage the floor surface. DO NOT operate on any surface
for an extended time as this could cause water marks, discolouration or otherwise damage the
surface.

Prior to using, we recommend that you test a floor surface area on an isolated floor area. If
uncertain, contact the floor manufacturer for specific floor care instructions and suitability for
steam cleaning.

The SteamTek3 Mop works with water only. If you live in an area with hard water, we
recommend that you use distilled water for optimal performance.

2

PARTS:

1. Microfiber Mop Pads (2)

2. Microfiber Cleaning Pads For Fabric Tool
(Acc. Caddy) (2)

3. Mop Head

4. Mop Handle

5. Measuring Cup

6. Water Tank

7. Detachable Hand-held Steamer Body

8. Mop Body

9. Small Screw

10. Short Jet Nozzle

11. Hand-held Steamer Lock

12. Hand-held Steamer Release Tab

13. Swivel Joint

14. Carpet Glider

15. Cord Holder

16. ON/OFF Mop Trigger

17. Carrying Handle

18. Power Indicator

19. ON/OFF Hand-Held Steamer Switch

20. Ready to Use Indicator

21. Hand-held Steamer Handle

22. Power Cord

23. Hand-held Steamer Accessory Adapter

17

12

11

8

14

16

1

2

5

4

15

6

23

7

13

19

21

3

20

18

9

22

10

3

ASSEMBLY:

1. Lift up the Hand-held Steamer lock (11)
(Illust.1) then push the Hand-Held
Steamer release tab (12) up. (Illust. 2)
to detach the Hand-Held Steamer (7)
from the mop body (8).

2. Attach Mop Head (3) to Mop Body (8)
by inserting the Swivel Joint (13) into
the hole in the Mop Body. (Illust. 3)

3. Fix the Screw (9) on the Mop
Head with a Philips screwdriver
until tight. (Illust.4)

4. Re-attach the Hand-Held
Steamer (7) to the Mop Body (8)
and lock into place with the
Hand-held Steamer Lock. (11)
(Illust. 5 & 6).

Illust.1

Illust.2

Illust.3

Illust.5

Illust.6

5. Slide the Mop Handle (4) into the Mop Body (8)

Illust.7

Illust.4

Illust.8

until it clicks into place. (Illust 7)

NOTE: To remove the Handle (4) from the Body (8), press the button and pull handle up.

(Illust. 8).

4