SUPERSONIC SC-904BTK User Manual

Karaoke Treasure Instructions
.Buttons Operation
1.
“ ”
Hold:ON/OFF Press:Mode switching
2. PREV
“ ∧ ”
Press:theprevious song under Mp3mode. Under selfie mode,pressit toenable selfie function (only for iOSsystemmobile phone)
“ ∨ ”
Press:theprevious song under Mp3mode. Under selfie mode,pressit toenable selfie function (only for Android systemmobile phone)
“ ”
4. SCAN Press:Play/Pause.Under FM state,hold it tor automatic search
5. REC MIC/Replay
Press:Mike ON/OFF Hold:Replay functionunder TFcardplay mode
“+
6. VOL+ Increasevolume
“-
7. VOL- Decrease volume
.Wireless Karaoke
1.Supplypower:Hold buttontostart theproduct.
2.Wiress connection:enable the wirelessof mobile phone,click to connect, successful connectionif prompt tone is produced.
3.Adjust sound:adjust the soundvolumeof mikeandthereverberation to suitable
4.Start Karaoke.
“ ”
level.
.Recording with mobile phone
1.Connect the recording wire:insert the MICRO plug of the recording wireinto theMICRO interface of Karaoke Treasure,andthe 3.5mminterface into the marphonejack of the mobile phone.
2.Open the Karaoke soffwarein the mobile phone,suchas:USING,Kugou Musicor other recording
APPs,select your favorable song,recordthe songaccording to the abovementionedsinging method.
3.Test andsavethe song:operate accordingto the instructions of Karaoke software.
.Selfie function
1.Pressthe button to switch fromwirelessmode toselfiemode.
2.Enable wireless in the mobile phone,
3.Openthephotographinterfaceof themobilephone,press the or buttontotakephotos. Note.4.2.2or higher versionfor Android system,6.0 or higher version for iOSsystem, it doesn t support otherversions temporarily,it doesn t the mobile. Phone which has the independent andsolid photograph button.
“ ”
search shutter ,clickcommection.
“∧” “∨ ”
Techmical Parameters
OutputPower:5W FrequencyRange:100Hz-10KHz Max Sound PressureLevel:>115dB 1KHz THD<1% Reverberation Mode:sound effect reverberation Power Supply:Built-in 18650 Li-battery Battery Capacity:1200mAh Charging Power:DC5V
Created with the free version of GreenCloud Printer
FCC Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
·Reorient or relocate the receiving antenna.
·Increase the separation between the equipment and receiver.
·Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
·Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Created with the free version of GreenCloud Printer
Loading...