You have just purchased one of the finest pieces of ergonomic furniture available. The EZ
Back Zero Gravity chair artfully blends the best of aesthetics, technology and wellness
in a seating experience that transcends the highest standards of comfort.
The electric recline system eases the body into a virtually weightless position, as it
elevates the legs above the heart and relieves weight from the spine.
This remarkable chair relieves the soreness, tension and fatigue caused by the earth's
constant pulling, while its fixed-form seating position ensures maximum ergonomic
posture at all recline angles.
To ensure that you don't overlook any of your chair's features, and that you use it safely,
read this manual carefully. Then sit back, relax, and enjoy!
Welcome to Super Relax
EZ Back Zero Gravity Chair
14300 Northwest Fwy Ste A11
Houston TX 77040
USA
© 2011 All rights reserved. Design and Specifications are subject to change without notice
Adjustable Headrest
Headrest Pillow
Folding Tray
Chair Control
Massage Control Pouch
Seat/Footrest Cushion
Backrest Cushion
with Massage Unit
WelcomH
When using an electrical appliance, basic precautions should always
be followed, including the following:
Read all instructions before using this unit
DANGER: To reduce the risk of electrical shock.
electrical outlet immediately after using and before cleaning.
To reduce the risk of burns, fire, electric shock or injury to persons:
Ÿ Do not put hands or fingers near the footrest mechanism on the underside of the chair while
this product is running. Touching the mechanism can result in injury.
Ÿ If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a
similarly qualified person in order to avoid a hazard.
Ÿ An appliance should never be left unattended when plugged in. Unplug from outlet when not in
use, and before putting on or taking off parts.
Ÿ Close supervision is necessary when this product is used by, on, or near children, invalids, or
disabled persons. Keep children away from extended foot support (or other similar parts).
Ÿ Use this product only for its intended use as described in this manual. Do not use attachments
not recommended by the manufacturer.
Ÿ The chair maximum load weight is 113 kg/250 lbs.
Ÿ Never operate this product if it has a damaged cord or plug, if it is not working properly, if it has
been dropped or damaged, or dropped into water. Return this product to a service center for
examination and repair.
Ÿ Do not carry this appliance by supply cord or use cord as a handle.
Ÿ Always keep the power cord away from heated surfaces.
Ÿ Do not use outdoors.
Ÿ Do not operate where aerosol (spray) products are being used or where oxygen is being
administered.
Ÿ Do not use this product when standing on a damp floor, or when any part of the body is in
contact with plumbing or any similar ground.
Ÿ Do not use this product if noise above normal sound is heard.
Ÿ Do not stand on or in appliance. Use only while seated.
Ÿ This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety. Children should be supervised to ensure that they do not play with the appliance.
Always unplug this product from the
Safety Precautions
Ÿ Comfortable clothing is recommended while using this product.
Ÿ If you feel any abnormal discomfort during the operation of this product, turn off the
power immediately and do not use the product. Consult your physician.
Ÿ Do not pull on the AC cord.
Ÿ When using this product after it has been in storage, check to see that the product is
operating properly prior to use. Always confirm that there are no obstacles behind
the product and that there is sufficient space to recline.
SAVE THESE INSTRUCTIONS
Ÿ Do not attempt to repair this product yourself.
Ÿ To reduce the risk of electric shock, this appliance has a polarized plug (one blade is
wide than the other). This plug will fit in a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician to install the proper outlet. Do not change the plug in any way.
Chair
Headrest Frame
Massage Unit
Backrest Cushion Seat Cushion
Headrest Pillow
Items included in the box
Important Safety Instructions
Safety Instructions
Warning
!
!
1. Limited One(1) Year warranty on chair frame and motor.
2. Limited Three(3) Months warranty on massage system.
Warranty
1. Chair upholstery.
2. Freight damage, misuse, neglect, accident, natural disaster and abuse.
3. Unauthorized repairs.
Warranty Exclusions
INSERT THE SEAT CUSHION
Slide the seat cushion onto the chair frame.
Slide the seat cushion onto the lower part of the chair frame,
making sure that the frame slides into the fabric pocket
located on the bottom side of the pad.
Secure the bottom flap.
Wrap the bottom flap around the seat frame by tucking it
under the frame, pulling it up and toward you, then attaching
it to the seat cushion with velcro.
Top Flap
Bottom Flap
Seat Frame
Position the top flap.
Lay the top flap back flat against the backrest frame.
ATTACH THE HEADREST FRAME
Adjust the chair to an upright position.
For your convenience, and to better position the chair
for the remaining assembly, plug in the chair, then
use the recline control to adjust the chair to
an upright position.
Insert the headrest frame into the backrest frame.
Slide the two ends of the headrest frame into the
holes in the top of the backrest frame.
Insert the massage unit into the backrest cushion.
Gently push the massage unit into the backrest cushion cavity.
Leave all remote/wiring connection sticking out for later access
Slide the backrest cushion onto the backrest frame.
Holding the backrest cushion upward with the flap to the back of the
chair, gently slide the backrest cushion over the head/backrest frame until it meets
the seat cushion.
Attache the headrest pillow
onto the headrest with velcro
Installations
Installations
Adjust the headrest frame.
Using the hex key to tighten both screws on the headrest frame to create enough
friction in order to adjust the headrest. Do not over tighten the screws
Headrest Adjustment Screws
Backrest Frame
INSERT THE BACKREST CUSHION
Secure both side with
screws provided
Secure the headrest frame.
Using a Phillips-head screwdriver, secure the two
headrest frame screws to the backrest frame.
Backrest Frame
Chair Operations
Plug the chair into an appropriate power source.
Adjust the headrest
While seated, reach up with both hands and grasp
both sides of the headrest. You will feel the rigid
frame beneath the soft headrest pad. Grasping the
rigid frame, tilt the headrest forward or backward
for desired comfort. The headrest remains in this
position until you adjust it again.
Getting out of the chair
Press up gently on the recline control until the backrest
stops in a full upright position and the footrest stops in a
vertical position.
Use the armrests for support when getting up from the
chair.
CAUTION: Do not put any extra pressure on the footrest
while returning the chair to an upright position. Do not
push on the footrest, or lean against
Adjust the recline angle
Before adjusting the recline angle, be sure there is nothing located directly behind
or beneath the chair. Gently press down on the recline control to recline, or
press up on the control to adjust the angle forward. Release the control button when you
reach the desired angle. The chair automatically stops when you reach the
maximum recline or the full upright position.
NOTE: Lean back against the backrest before reclining the chair.
CAUTION: Do not put any extra pressure on the footrest while returning the
chair to an upright position. Do not push on the footrest, or lean against it.
Recline Control
Recline Control
Chair Operations
!
!
Care & Maintenance
To keep your product working and looking its best, please follow these simple care
guidelines.
Cleaning:
1. Be sure to disconnect the power cord from the electrical outlet before cleaning.
2. Do not use benzene, thinner or any other solvents on your massage chair.
3. Remove dust on the backrest or armrest with a vacuum.
4. If the backrest or armrests become soiled, wipe with a damp cloth, then a dry cloth.
5. Common upholstery cleaners may be used for tough stains.
6. When cleaning the controller or around the power switch, use a dry cloth only.
Never use a damp cloth to clean the controller or power switch.
Fabric Care:
To maintain your product in optimum condition, dust it frequently and/or
vacuum it with a soft brush vacuum extension. Wipe with a slightly damp cloth as
necessary. For tougher stains on non-leather products, use a mild detergent mixed
with water. Leather products should be wiped down occasionally with a leather furniture
cleaning solution.
WARNING:
Be sure to test any cleaning solution on a small, inconspicuous part of the product
to ensure that the color does not fade prior to using the solution on the entire product
surface.
Maintenance and Repair:
1. The mechanics of this product are specially designed and constructed to be
maintenance free. No periodic lubrication or servicing is required.
2. Your chair should only be serviced by an authorized service center.
Use and Storage Environment:
1. When not in use for a long period of time, we recommend that the chair be
covered, the power cord be coiled and that the unit be placed in an environment free
of dust and moisture.
2. Do not store near heat or open flame.
3. Do not leave this product exposed to direct sunlight for long periods of time.
This may cause fading or damage.
4. Do not use or store in extreme temperatures; product stored in cold temperatures
may require 48 hours at room temperature to function properly.
5. Product should be used and stored in an environment with non-condensing
humidity ranging from 10 to 80%; excessive humidity will damage the mechanics.
Miscellaneous:
1. Foreign objects should not be inserted between the massage nodes or the unit
housing.
2. Care should be taken not to overload the unit.
Chair Specifications:
Fully reclined: 63"(160 cm)L x 35"(89 cm)W x 30"(76 cm)H
Full reclined with tray open: 63"(160 cm)L x 44"(112 cm)W x 30"(76 cm)H
Fully inclined: 42"(107 cm)L x 35"(89 cm)W x 50"(127 cm)H
Full inclined with tray open: 42"(107 cm)L x 44"(112 cm)W x 50"(127 cm)H
Maximum Load Weight: 113 Kg/250 Lbs
Chair Weight: 58 Kg/127 Lbs
Chair with Back Massager Weight: 61 Kg/135 Lbs
Shipping Weight: 70 Kg/154 Lbs.
Carton box size: 45 1/4"(115 cm)L x32 1/4"(82 cm)W x 31 1/2"(80 cm)H
© 2011 All rights reserved. Design and Specifications are subject to change without notice
Care & Maintenance
!
EZ Back Zero Gravity Chair
Loading...