superior fires CLARA LED INSET ELECTRIC FIRE, NDY-19, LONDRA LED REFLECTIONS INSET ELECTRIC FIRE Installation & User's Instructions

INSTALLATION & USER INSTRUCTIONS

MODELS COVERED BY THESE INSTRUCTIONS

NDY-19

CLARA LED INSET ELECTRIC FIRE

LONDRA LED REFLECTIONS INSET ELECTRIC FIRE

FRET AND FRAME OPTIONS AVAILABLE

LED ELECTRIC FIRE

1

Revision D - 12/17

GB IE

MODEL SHOWN: CLARA LED INSET ELECTRIC FIRE

Image used for illustration puposes only

All instructions must be handed to the user

for safekeeping.

Please note : Except where otherwise stated, all
rights, including copyright in the text, images
and layout of this booklet is owned by Focal
Point Fires plc. You are not permitted to copy
or adapt any of the content without the prior
written permission of Focal Point Fires plc.

©

2017 Focal Point Fires plc.

This product is only suitable for well insulated spaces or occasional use.

Superior Fires

Christchurch, Dorset BH23 2BT

Tel: [phone]
Fax: [phone]

www.superiorfires.co.uk

Email : [e-mail]

1.0 PRELIMINARY NOTES

I N S TA L L AT I O N & U S E R I N S T RU C T I O N S

2

GB IE

Section Contents Page No.

1.0 Preliminary Notes 2

2.0 Installation Requirements 3

3.0 Appliance Data 3

4.0 Unpacking the Appliance 4

5.0 Component Checklist 5

6.0 Installing the Appliance 5

7.0 Removing the Appliance Spacer Frames 6

Section Contents Page No.

8.0 Fitting the Decorative Frame and Front 6

8.1 Fitting the Loose Fuel Bed Options 7

9.0 Operating the Appliance 7

10.0 Safety Cut-Out System 11

11.0 Cleaning and Maintenance 11

12.0 Servicing 12

13.0 Guarantee - Terms and Conditions 12

IMPORTANT - THESE INSTRUCTIONS SHOULD BE READ CAREFULLY

AND RETAINED FOR FUTURE REFERENCE.

The appliance is designed for indoor use, and can be simply floor mounted in the
majority of floor positions anticipated. It can be located in any household room, with
the exception of bathrooms. Read all of the instructions before commencing installa­tion. Retain for future reference and pass on as necessary to subsequent owners of the
appliance.

• DO NOT use this appliance immediately below a fixed socket outlet.

• DO NOT use this appliance in an open flue.
When using this electrical appliance, basic precautions should be followed to reduce the risk

of fire, electric shock and injury to person, including the following:

• This heater must be used on an AC supply only and the voltage marked on the heater’s
rating label must correspond to the supply voltage.

• DO NOT switch the appliance on until it is properly installed as described in this
manual.

• This appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children shall not play with the appliance. Cleaning and
user maintenance shall not be made by children without supervision.

• Children of less than 3 years should be kept away unless continuously supervised.
Children aged from 3 years and less than 8 years shall only switch on/off the appliance pro­vided that it has been placed or installed in its intended normal operating position and they
have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children aged from 3 years and less than 8 years shall not
plug in, regulate and clean the appliance or perform user maintenance.

• CAUTION: Some parts of this product can become very hot and cause burns.
Particular attention has to be given where children and vulnerable people are present.

• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.

• The heater must not be located immediately below a socket-outlet.

• DO NOT use this heater in the immediate surroundings of a bath, a shower or a swim-
ming pool, or other area where water/moisture could present a hazard.

• WARNING: In order to avoid overheating, do not cover the heater.

• DO NOT use this heater with a programmer, timer, separate remote-control system or
any other device that switches the heater on automatically, since a fire risk exists if the
heater is covered or positioned incorrectly.

• CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal
cutout, this appliance must not be supplied through an external switching device, such as a

© 2017 Focal Point Fires plc.

3

DO NOT - site in a position where curtains or drapes could cover the appliance.

- site in a position where other soft materials could cover e.g. below a coat rack.

- site behind an opening door where mechanical impact/damage could occur.

- site where the supply cable would become a trip hazard.

- sit, stand or forcefully pull on the appliance.

- obstruct, cover or force items into the openings.

- use the heater to dry clothes.

- site/use in an outdoor location(s).

- run the supply cable under carpets.

- Mount on a wall.

• DO NOT run the mains cable under carpets, rugs etc.

• DO NOT cover or obstruct the heater in any way. Overheating will result if it is acci-
dentally covered.

• Never immerse the product in water or any other liquids.

• DO NOT use the appliance outdoors.

• Before cleaning the appliance, ensure it is unplugged from the power and that it is com­pletely cool.

• DO NOT clean the appliance with abrasive chemicals.

• Never use accessories that are not recommended or supplied by the manufacturer. It
could cause danger to the user or damage to the appliance.

• DO NOT insert or allow foreign objects to enter the inlet or outlet vents as this may
result in electric shock, fire or damage to the appliance.

• DO NOT install the fire using an extension cord.

• Unplug from the mains supply if the appliance is not to be used for long periods.

• This product is only suitable for well insulated spaces or occasional use.

timer, or connected to a circuit that is regularly switched on and off by the utility.

• Keep furniture, curtains and other fabric material away from the appliance.

• DO NOT leave the appliance unattended during use.

• From time to time, check the cord for damage. Never use the appliance if the cord or any
part of the appliance shows signs of damage.

1.0 PRELIMINARY NOTES - CONTINUED

GB IE

3.0 APPLIANCE DATA

Weight (kg): 14 kg
Voltage (Volts): 220-240V a.c. 50Hz
Rated Power 2 x 900W/ 2 x 1000W
Supply Plug: BS 1363, 13A Fused
Supply Cord: 1.7 Metres
Location: Indoor Use
LED Display: 4 Watts

This product is only suitable for well insulated spaces or occasional use. The appliance is supplied with a pre-wired three pin plug (13 Amp fuse
rated) and 1.7 metres of electrical cable. It is therefore necessary for a suitable electrical socket to be located within this distance and be eas­ily accessible. The appliance is suitable for installation into all proprietary surrounds with an opening of 406mm by 559mm (16” by 22”). The
appliance is supplied fitted with 2 spacer frames enabling it to be fitted with no need for a recess into a wall or surround back panel. Both spac­er frames have a depth of 57mm. The appliance can be fully recessed if the opening depth is 113mm or greater and neither spacer is used. It
may be installed directly into any proprietary surround which can house this size of rebate, without the need to recess the appliance into a wall
opening or fabricate a false chimney breast.

This appliance should be positioned on a firm level surface and in a clean ‘dust free’ environment. If the fire is to be sited in a fire surround then
the suitability of the surround for use with electrical heaters should be established with the fire surround manufacturer.
If fitted into an open draught fireplace, it is recommended to blank off the chimney to reduce the risk of draught through the fire, which may
cause the safety cut out system in the fan heater to operate.

2.0 INSTALLATION REQUIREMENTS

© 2017 Focal Point Fires plc.

Read all the instructions before continuing to unpack or install this appliance. Carefully remove the appliance from its packaging and lay on the
floor with it’s back surface downward. Note: DO NOT stand the appliance on its frame as this may cause distortion. Check that the remaining
packaging contents correlate with the component checklist below. Please dispose of all packaging with care at your local recycling centre.

4.0 UNPACKING THE APPLIANCE

4

3.0 APPLIANCE DATA - CONTINUED

GB IE

© 2017 Focal Point Fires plc.

All Models NDY-19

Item Symbol Value Unit Item Unit

Heat output Types of heat input, for electric storage local

space heaters only

Nominal
heat output

Pnom 1.9 KW Manual heat charge control with

integrated thermostat

N/A

Minimum heat
output
(indicative)

Pmin 0.95 KW Manual hear charge control with

room and/or outdoor temperature
feedback

N/A

Maximum
continuous heat
output

Pmax, c 1.9 KW Electronic heat charge control with

room and/or outdoor temperature
feedback

N/A

Auxiliary electricity consumption Fan assisted heat output N/A

At nominal
heat output

elmax 0.014 KW Type of heat output/room temperature control

At minimum
heat output

elmin 0.014 KW Single stage heat output and no

room temperature control

No

In standby mode elSB 0.48 W Two or more manual stages no tem-

perature control

No

With mechanical thermostat room
temperature control

No

With electronic room temperature
control

No

Electronic room temperature con­trol plus day timer

No

Electronic room temperature con­trol plus week timer

Yes

Other control options No

Room temperature control with
presence detection

No

Room temperature control with
open window detection

No

With distance control option No

With adaptive start control Yes

With working time limitation No

With black bulb sensor No

Contact details Focal Point Fires, Avon Trading Park, Christchurch Dorset, BH23 2BT