SuperDroid Robots MLT-JR Assembly And Operation Manual

MLT-JR Tracked Robot Platform

Assembly and Operation

The MLT-JR tracked robot platform and is equipped with 32mm motors, a motor

controller, and Spektrum remote control. This is a rugged and maneuverable robot

platform.

Images shown may not be an exact representation of the robot’s features listed in this document

SuperDroid Robots, Inc Contact
224 Technology Park Lane [phone]
Fuquay Varina, NC 27526 [e-mail]
www.SuperDroidRobots.com

Revised: May 22, 2018 Page 2 of 13

Contents

Mechanical Assembly ................................................................................................................................................... 4

Electrical Assembly ..................................................................................................................................................... 12

Operation .................................................................................................................................................................... 12

General Terms............................................................................................................................................................. 13

Caution:

SuperDroid Robots, Inc Contact
224 Technology Park Lane [phone]
Fuquay Varina, NC 27526 [e-mail]
www.SuperDroidRobots.com

Revised: May 22, 2018 Page 3 of 13

It is always important to use safe practices. Only people with good mechanical and electrical experience should
work on the robots. Minors should always be supervised by adults.

The aluminum chassis also has many sharp edges and care needs to be taken not to get cut. Sharp edges can
be brought down with a metal file.

The treaded ATRs have very powerful motors. The treaded design presents many pinch points! If fingers
or hands are inside the treaded section and the motors energize, you cause serious injury. ALWAYS disconnect
the power before working on the robot. The easiest way of disconnecting the power is by pulling the motor
fuse(s). Do not solely rely on the switch as a disconnect, since it can be easily bumped and turned on resulting
in the motors surging.

SuperDroid Robots, Inc Contact
224 Technology Park Lane [phone]
Fuquay Varina, NC 27526 [e-mail]
www.SuperDroidRobots.com

Revised: May 22, 2018 Page 4 of 13

Mechanical Assembly

Parts of the MLT-JR robot kit.

1. Start by pressing the nuts into place on the wheel bearing hubs. There will be 8 nuts and two bearing hubs.

Sometimes it helps to use one of the #4 machine screws to hammer the nuts into the counter bored holes.