Supera DSP26-1 Installation Manual
DSP26-1, DSP36-1, DSP48-1
HEATED DISPLAYS
INSTRUCTION MANUAL
This manual contains importatant information regarding your Supera unit. Please read this manual thoroughly prior to equipment set-up,
operation and maintenance. Failure to comply with regular maintenance guidelines outlined in this manual may void the warranty.
WARNINGS
• Fire, injury or death hazard – have this unit installed by a qualifi ed installer in accordance with
all deferral, state and local codes. Failure to install this equipment properly can result in injury
or death.
• Fire hazard – this unit is designed to be used with legs. Do not use without legs installed. Use
of this equipment without legs can cause the unit to overheat and cause a fi re.
• Fire and burn hazard – fi re and burn injuries can occur if this equipment is not used properly.
To reduce the risk of injury or death:
• Do not touch any hot surfaces
• Plug only into a 3-hole grounded electrical outlet
• Do not immerse unit, cord or plug in liquid at any time
• Unplug cord from outlet when not in use and before cleaning
• Do not operate unattended
• Do not use this unit for anything other than intended use
• Do not use outdoors
• Always use on a fi rm, dry and level surface at least 12” from walls or any other obstruction
• Do not use if unit has a damaged cord or plug, in the event the appliance malfunctions, or has
been damaged in any manner
• Keep children and animals away from unit
• Any incorrect installation, alterations, adjustments and/or improper maintenance can lead to
property loss and injury. All repairs should be done by authorized professionals only
• Ensure that the designated power supply is adequate for continual usage and the voltage is
correct
*This unit is intended to be used as a merchandiser for hot food in commercial food service
operations only. It is not intended for household use.
TO INSTALL
1. Remove all packing material and tape.
2. Clean o any glue or tape residue.
3. Place the unit in the desired position and level using the included adjustable feet.
4. Installing doors: Note the longer doors are for the front or sloped side and the shorter doors are
for the back or straight side. The doors are fi tted with the handles facing outside of the unit.
Place the top of the door into the top track and slide the door up to clear and lower into the
bottom track.
5. Installing shelves: Place the uprights into the provided slots. Make sure that the longer tab in
on top and the fl at sides face inwards. Place the shelf supports at the desired locations and
position the shelf on these supports.
6. NOTE: The shelf supports and shelves can be positioned level or sloping forward for improved
presentation.
7. Plug the unit into a properly grounded electrical supply that matches the data plate rating.
Damage to the unit may occur if incorrect power is supplied to the unit.
TO USE
1. Set the thermostat to the desired heat
2. Preheat the unit for approximately 15 minutes, until the unit reaches the set temperature. The
pilot light will cycle on and o when the unit has reached the set temperature.
3. Use the toggle switch to operate the light.
4. If moisture is required, fi ll the humidity pan with 20 ounces of water and monitor the water level
CLEANING – NOTE: To maintain cleanliness and increase service life, the oven should be cleaned
daily. Do not immerse the unit in water or any other liquid. If liquid enters the electrical compartment it may cause a short circuit or electrical shock
1. Unplug the unit and allow to cool completely before cleaning
2. Using a damp cloth or sponge dipped in soapy water, carefully
3. Wipe the unit dry and wait at least a half hour before using the unit.
MANUAL
INSTRUCTION
©SUPERA V.1.0 | August 2014
Wiring Diagram for the Heated Displays
MANUAL
INSTRUCTION
©SUPERA V.1.0 | August 2014
Loading...