Sunwe Electronic Technology IHV205, IHV210 User Manual

No. Function Operation Voice prompt LED (Bluetooth)

1 Power on

2 Power off

3

Pairing

4 Volume Control Press & hold "+" or "-" button Maximum Volume

5 Play Music Short press the MFB button Slow flash blue

6 Pause Music Short press the MFB button Slow flash blue

Headphone is “off”
Press & hold the MFB button for 3sec

Headphone is “on”
Press & hold the MFB button for 5sec

(Initial pairing) Headphone is “off”
Press & hold the MFB button for 7sec ->
auto switch to pairing mode

(Not initial pairing) Headphone is “off”
Press & hold the MFB button for 3sec ->
search mode -> after 5min if no suitable
device ->auto power off

(Manual pairing) Headphone is “off”
Press & hold the MFB button for 7sec ->
pairing mode

Paired device

Power on Flash blue

Power off Solid red (3sec)

Power on
Pairing

Power on
Pairing

Power on
Pairing

Your device is
connected

Quick flash blue & red

Flash blue (power on)
Slow flash blue (search)
All LED off

Blue LED flash (power on)
Quick flash blue & red(pairing)

Slow flash blue

7 Resume Playback Short press the MFB button Slow flash blue

8 Track Controls

9 Answer a Call Short press the MFB button Incoming call Slow flash blue

10 End a Call Short press the MFB button Slow flash blue

11 Auto re-connect

12 Low battery alert Lower than 3.3

13 Auto power off

Short press “+" or "-" button once for
previous song or next song

(Out of range)
resume the operation range

V Battery low Slow flash red

(pairing mode)
if no connected, will power off after 5min

(already paired device)
if no signal input, will power off after 10min

USB cable plug in (headphone charging)

Your device is
connected

Power off

Power off

Slow flash blue

Slow flash blue

Flash blue -> Solid red (3sec)

-> all LED off

Flash blue-> Solid red (3sec)

-> all LED off

Solid red (<95%)
LED off (95%~100%)

Federal Communications Commission (FCC) Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a pa rticu lar installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:

●Reorient or relocate the receiving antenna.

●Increase the separation between the equipment and receiver.

●Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

●Consult the dealer or an experienced radio/TV technician for help.

Warning: Changes or modifications made to this device not expressly approved by

Technology Limited may void the FCC authorization to operate this device.

HongKong Sunwe Electronic

Note: The manufacturer is not re sponsible for any radio or TV interference c aused by unauthorized modifications to this
equipment. Such modifications could v oid the user’s authority to operate the equipment.