SUNVALLEYTEK TT BR01A User Manual

TaoTronics Wireless Receiver
1
2 3 5 6 7 4 8
9
Model: TT-BR08
Thank you for choosing the TaoTronics TT-BR08 Wireless Receiver. If in doubt, please contact our customer support team by email at support@taotronics.com.
Package Content
1×TaoTronics TT-BR08 Wireless Receiver 1×USB Charging Cable 1×3.5mm Audio Cable 1×3.5mm Audio Receiver 1×User Guide
Product Diagram
1. 3.5mm Audio Output Port
2. Volume +
3. Previous track
4. Volume -
5. Micro USB Charging Port
6. Next Track
7. Power Button/LED Indicator
8. Microphone
9. Active Voice Control
How to Use
Function
Operation
Power on/off
Press and hold the Power Button until the LED Indicator flashes/off.
Play/Pause/Answer/Hang up phone call
Press the Power Button once Reject phone call
Press and hold the Power Button for 2 seconds.
Redial
Press the Power Button twice.
Volume +/-
Press the Volume +/- Button
Previous/Next Track
Press the Previous Track/Next Track Button
Active Voice Control
Press the Active Voice Control Button once
1. Charging
1) Connect the charging port with any USB charging adapter or active computer USB port.
2) Charging will start automatically with LED indicator turning green.
3) The receiver is fully charged when LED indicator turns off. Note: Make sure the battery is fully charged before putting the headphones away for
storage.
Charge the receiver at least once every 6 months when not using for a long time.
2. Pairing
1) Make sure the receiver and your Bluetooth® device are next to each other (within
3 feet);
2) The first time you use the receiver, press and hold the Multifunction Button until
the LED indicator flashes red and blue alternately. Now the receiver is in pairing mode;
3) Activate Bluetooth® function on your phone and search for the nearby
Bluetooth® connection: Find “TaoTronics TT-BR08” in the search results. Tap on the name to connect. Once connected, only the blue LED will flash.
NoteThe Bluetooth® receiver can remember previous paired devices.
Button Control
\
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and(2) this device must accept any
interference received, including interference that may cause undesired operation.
Loading...