Sunset Trading DLUB24AB, DLUB24BCH, DLUB24LO, DLUB24NLO, DLUB30NLO Assembly Guide
...
Barstool
Instructions
Step 3 - Put 1 Lock Washer and 1 Washer to each bolt.
Attach the Swivel to the seat bottom through the access
hole in the Bottom of the Base Unit with all four (4) bolts.
Screw all 4 screws
in part way before
tightening with
Allen Wrench provided.
(Fig. 4)
Fig. 4
www.SunsetTrading.com
Barstool
Instructions
Step 3 - Put 1 Lock Washer and 1 Washer to each bolt.
Attach the Swivel to the seat bottom through the access
hole in the Bottom of the Base Unit with all four (4) bolts.
Screw all 4 screws
in part way before
tightening with
Allen Wrench provided.
(Fig. 4)
Fig. 4
www.SunsetTrading.com
Parts/Units, (Fig. 1)
1 Bottom Base Unit
(Pre-Assembled)
1 Top Seat Unit (Pre-Assembled)
1 Swivel
4 Seat Machine Bolts
4 Lock Washers
8 Washers
4 Base Lag Bolts
1 4mm Allen Wrench
1 Instruction Sheet
Step 1 - Place Swivel on top of Base with
top front markings on Swivel facing up.
Attach Swivel to the Base Bottom using 4
Base Lag Bolts and 4 Washers. Tighten
with 4mm Allen Wrench provided. (Fig. 2)
Step 2 - Place Seat Top
upside down on table or
bench (lay a towel down to
protect from scratches).
Make note of the marking on
the top of the Swivel that
says FRONT. This side of
the Swivel must be mounted
toward the front of the
Barstool seat in order to provide proper angle for sitting.
Line up the four (4) slots in
the Swivel top with the four
(4) nut inserts that are
mounted in the seat. (Fig. 3)
Fig. 1
Fig. 2
Fig. 3
Parts/Units, (Fig. 1)
1 Bottom Base Unit
(Pre-Assembled)
1 Top Seat Unit (Pre-Assembled)
1 Swivel
4 Seat Machine Bolts
4 Lock Washers
8 Washers
4 Base Lag Bolts
1 4mm Allen Wrench
1 Instruction Sheet
Step 1 - Place Swivel on top of Base with
top front markings on Swivel facing up.
Attach Swivel to the Base Bottom using 4
Base Lag Bolts and 4 Washers. Tighten
with 4mm Allen Wrench provided. (Fig. 2)
Step 2 - Place Seat Top
upside down on table or
bench (lay a towel down to
protect from scratches).
Make note of the marking on
the top of the Swivel that
says FRONT. This side of
the Swivel must be mounted
toward the front of the
Barstool seat in order to provide proper angle for sitting.
Line up the four (4) slots in
the Swivel top with the four
(4) nut inserts that are
mounted in the seat. (Fig. 3)
Fig. 1
Fig. 2
Fig. 3
Loading...