Sunpentown WA1288E User Manual

Portable Air Conditioner

Instruction Manual

WA-1288E

Thank you for purchasing our Portable Air Conditioner.

Before using your air conditioner, please read this instruction manual carefully and keep it for future reference.

READ AND SAVE THESE INSTRUCTIONS!

Contents

P a r ts Identificatio n

S afety P r ecautio n s

C autio n s

Installati o n

O p e r atio n

Maintenan c e

------------------------------ - -

--------------------------- - -

----------------------------- - -

-------------------------- - -

T r oubleshootin g

D esign and C ompliance N o t e s

-------------------- -

------------------- - -

----------------------- - -

-------- - -

1 6

1 7

1 8

W a r r ant y

------------------------------- - -

1 9

Parts Identification

control panel remote signal receptor

horizontal louver control lever(adjust manually)

vertical louver control lever(adjust manually)

Exhaust air outlet

handle

(both sides)

air filter

(behind the grille)

upper air intake

drain outlet

lower air intake

Caster

bottom tray drain outlet

r earf r ont

Safety Precautions

This symbol indicates that ignoring instructions may cause death or serious injury.

WARNING: To prevent death or injury to the user or other people and property damage, the following instructions must be followed. Incorrect operation due to ignoring of instructions may cause death, harm or damage.

-Installation must be performed according to the installation instructions. Improper installation can cause water leakage,

electrical shock, or ﬁre.

-Use only the included accessories and parts, and speciﬁed

tools for the installation. Using non-standard parts can

cause water leakage, electrical shock, ﬁre, and injury or

property damage.

-Make sure that the outlet you are using is grounded and has the appropriate voltage. The power cord is equipped with a three-prong grounding plug to protect against shock. Voltage information can be found on the side of the unit, behind the grille.

-Install the unit on a ﬂat, sturdy surface. Failure to do so

could result in damage or excessive noise and vibration.

-The unit must be kept free from obstruction to ensure proper function and to mitigate safety hazards.

-DO NOT modify the length of the power cord or use an extension cord to power the unit. DO NOT share a single outlet with other electrical appliances. Improper power

supply can cause ﬁre or electrical shock.

-Turn off the product when not in use.

-DO NOT install your air conditioner in a wet room such as a bathroom or laundry room. Too much exposure to water can cause electrical components to short circuit.

-DO NOT install the unit in a location that may be exposed

to combustible gas, as this could cause ﬁre.

-The unit has wheels to facilitate moving. Make sure not to use the wheels on thick carpet or to roll over objects, as these could cause tipping.

-DO NOT operate a unit that it has been dropped or damaged.

-Do not touch the unit with wet or damp hands or when barefoot.

-DO NOT allow children to play with the air conditioner. Children must be supervised around the unit at all times.

-If the air conditioner is knocked over during use, turn off the unit and unplug it from the main power supply immediately. Visually inspect the unit to ensure there is no damage. If you suspect the unit has been damaged, contact a technician or customer service for assistance.

-In a thunderstorm, the power must be cut off to avoid damage to the machine due to lightning.

Cautions

-This appliance can be used by children aged from 8 years and above and person with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play the appliance. Cleaning and user maintenance shall not be made by children without supervision.

-This appliance is not intended for use by persons (including childern) with reduced physical, sensory or mental capabilities or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. (be applicable for other countries except the European Countries )

-Children should be supervised to ensure that they do not play with the appliance.

-If the supply cord is damaged, it must be replaced by the manufacturer,its service agent or similarly qualified persons in order to avoid a hazard.

-Prior to cleaning or other maintenance, the appliance must be disconnected from the power outlet.

-Do not remove any fixed covers. Never use this appliance if it is not working properly, or if it has been dropped or damaged.

-Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.

-Do not operate unit with a damaged cord, plug, power fuse or circuit breaker. Discard unit or return to an authorized service facility for examination and/or repair.

-To reduce the risk of fire or electric shock, do not use this fan with any solid-state speed control device.

-The appliance shall be installed in accordance with national wiring regulations.

-Contact the authorized service technician for repair or maintenance of this unit.

Contact the authorized installer for installation of this unit.

-Do not cover or obstruct the inlet or outlet grilles.

-Do not use this product for functions other than those described in this instruction manual.

Before cleaning, turn off the power and unplug the unit.

Disconnect the power if strange sounds, smell, or smoke comes from it.

Installation

Choosing The Right Location

Recommend Installation

50cm

19.7inch

Your installation location should meet the following requirements:

-Make sure that you install your unit on an even surface to minimize noise and vibration.

-The unit must be installed near a grounded plug, and the bottom tray drain outlet (found on the back of the unit) must be accessible.

-The unit should be located at least 30cm (12”) from the nearest wall to ensure proper air ventilation.

-DO NOT cover the Intakes, Outlets or Remote Signal Receptor of the unit, as this could cause damage to the unit.

Installation

Tools Needed

-Medium Philips screwdriver; -Tape measure or ruler; -Knife or scissors;

-Saw (optional, to shorten window adaptor for narrow windows)

Accessories

Your Window Installation Kit ﬁts windows 67.5-123cm(26.5-48”) and can be shortened for smaller windows.

Part

Description

Quantity

Window Installation Kit Step One: Preparing the Exhaust Hose assembly

Press the exhaust hose into the window slider adaptor and unit adaptor, clamp automatically by elastic buckles of the adaptors.

Exhaust hose

Exhaust hose assembly

Unit Adaptor

1 pc

Unit adaptor Window slider

Exhaust Hose

Window Slider Adaptor

1 pc

adaptor

Step Two: Install the Exhaust hose assembly to the unit

Bolt

Window Slider A

Window Slider B

Foam Seal A (Adhesive)

Foam Seal B (Adhesive)

Foam Seal C (Non-adhesive)

Security Bracket and 2 Screws

Drain Hose

MOD

SWING

TURBO

O L

O W

SLEE

M E

RESE

T LOCK

LED

CLOCK

FAN

AUTO

SPE

CLOCK

SET

CANCE

TEMP

TIME

FAN

Remote Controller and Battery

(For remote control models only)

1 pc

2 pc

1 pc

1 set

1 pc

1 set

Push the Exhaust hose into the airoutlet opening of the unit along the arrow direction.

Step Three: Preparing the Adjustable Window Slider

1. Depending on the size of your window, adjust the size of the window slider.

2. If the length of the window requires two window sliders, use the bolt to fasten the window sliders once they are adjusted to the proper length.

Bolt

Window slider A Window slider B

+ 14 hidden pages