Sunpentown WA1240AE Installation Manual

Quick Installation Guide

3. Preparing the Exhaust Hose assembly

1. Check Installaton Kit

Unit Adaptor

Exhaust hose

Bolt

Window Slider Adaptor

Window Slider A Window Slider B

Hung Window Sliding Window

Windows Type

2 Foam Seals A (Adhesive)

2 Foam Seals B (Adhesive)

Security Bracket

2 Screws

Foam Seal C (Non-adhesive)

Window slider A Window slider B

2. Check your window length and type.

Check your window length/width and decide if one or both slider pieces will be used. If using both pieces, adjust to required length and use the bolt to secure.

Bolt

Window slider A

Unit adaptor

Window slider adaptor

Exhaust hose

Press into Press into

Exhaust hose assembly

Type round

4. Install the Exhaust hose assembly to the unit .

Align the hooks on the unit adaptor to the hole seat of the air outlet (located on the back of the unit). Insert the adaptor and slide hose assembly downwards into the groove.

Hook

Hole Seat

Lower groove

adaptor

Make sure the adaptor is inserted into the lower groove of the air outlet.

Cut the adhesive foam seal A and B strips to the proper lengths, and attach them to the window sash and frame as shown.

Foam seal B

(Adhesive type-shorter)

Foam seal A

(Adhesive type)

Cut the non-adhesive foam seal C strip to match the width of the window. Insert the seal between the glass and the window frame to prevent air and insects from getting into the room.

If desired, install the security bracket with 2 screws as shown.

Insert the window slider adaptor into the hole of the window slider.

CP023I-MFBAZDY 1602030000012X

NOTE: If you need more detail information for installation, refer to the " Installation " in the instruction manual.

All the illustrations are for explanation purpose only. Your machine may be slightly different. The actual shape shall prevail.

Foam seal C

(Non-adhesive type)

2 Screws

Security Bracket