Sunpentown UF304SS, UF304X User Manual

Instruction Manual
3.0 CU. FT. Upright Freezer
UF-304SS (STAINLESS STEEL)
2
Dear customer:
Thank you for buying this upright freezer. To ensure that you get the best results from your new freezer, please take time to read through the simple instructions in this booklet.
Please ensure that the packing material is disposed of in accordance with the current environmental requirements.
When disposing of any upright freezer equipment please contact your local waste disposal department for advice on safe disposal.
This appliance must be only used for its intended purpose.
Main configuration::
3
UNPACKING YOUR UPRIGHT FREEZER
WARNING: Use two or more people to move upright freezer.
Failure to do so can result in back or other injury.
Remove tape and any labels from your upright freezer before using (except the rating label).
Any tape or glue residue can be removed by rubbing the area briskly with your thumb. Or rub the area with a small amount of liquid dish sop, wipe with warm water and dry.
Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These products can damage the surface of your upright freezer.
When moving the upright freezer, do not tilt the upright freezer beyond 45° from upright position.
Before initial use, please use scissor to cut and remove the plastic cable ties at the center of each shelf, as shown in picture. There is a total of three cable ties.
CLEANING BEFORE USE
After you remove all of the packaging materials (be sure the foam between outside condenser and cabinet is removed), clean the inside of your upright freezer before using it.
4
SPACE REQUIREMENTS
WARNING: Keep flammable materials and vapors, such as gasoline, away form upright freezer. Failure to do so can result in death, explosion, fine or burns.
To ensure proper ventilation for your upright freezer, allow a minimum clearance of 8 inches on the sides, 4 inches at the back and 12 inches at the top of the unit.
If you are installing your upright freezer next to a fixed wall, leave sufficient space on the hinge side to allow for the door to swing open.
Never install your upright freezer near heat source and avoid direct sunlight.
ELECTRICAL REQUIREMENT
WARNING:
DO NOT REMOVE GROUND PRONG.
DO NOT USE AN ADAPTOR. DO NOT USE EXTENSION CORD.
Failure to follow these instructions can result in death, fire or electrical shock.
Before you move your upright freezer into its final location, it is important to make sure you have the proper electrical connection.
Recommended Grounding Method
AC 115Volt /60 Hz AC only 10 ampere fused and properly earthed electrical supply is required. It is recommended that a separate circuit serving only this appliance be provided. Use a receptacle which cannot be turned off with a switch or pull chain. Do not use an extension cord.
5
Loading...
+ 8 hidden pages