sunpentown SR652R User Manual

Your Guarantee

If this product is found to be faulty as a result of faulty
materials or workmanship within one year from date of
purchase, it will be repaired free of charge.

This guarantee is subject to the following terms:

• Sunpentown must be notified of the fault.

• Proof of purchase must be presented to Sunpentown’s nominated

representative.

• The warranty will be void if the product if modified, misused or repaired
by an unauthorized person.

• The warranty after repair will not be extended beyond the original one­year period.

• All replacement parts will be new or reconditioned.

• Parts, which are replaced, become the property of Sunpentown.

• The warranty applies for the use of the product in the USA only.

What is NOT COVERED:

• Warranty does not include freight charges.

• Incidental or consequential damage caused by possible defects with

this product.

• Damage to product caused by improper power supply voltage, accident,
fire, floods or acts of nature.

• Failure of product resulting from unauthorized modifications to the
product.

• Improper installation or failure to perform the necessary maintenance.

This GUARANTEE is in addition to your Statutory Rights

SUNPENTOWN INTERNATIONAL INC.

14625 Clark Ave. City of Industry, CA 91745

Tel: [phone]

[e-mail]

www.sunpentown.com

SMARTSCAN®

SR-183R (120V / 1800W)

SR-652R (208-240V / 2700W)

INSTRUCTION MANUAL

Thank you for purchasing your SMARTSCAN induction cooker by Sunpentown. Make
full use of your new induction range. Please carefully read this manual and keep on
hand for future reference.

IMPORTANT SAFEGUARDS

A. Read all instructions.
B. Do not touch hot surfaces. Use handles or knobs.
C. To protect against electrical shock, do not immerse cord or appliance in water or

other liquid.
D. Close supervision is necessary when any appliance is used by or near children.
E. Unplug from outlet when not in use and before cleaning. Allow to cool before

putting on or taking off parts.
F. Do not operate any appliance with a damaged cord or plug or after the appliance

malfunctions or has been damaged in any manner. Return appliance to the nearest

authorized service facility for examination, repair or adjustment.
G. The use of accessory attachments not recommended by the appliance manufacturer

may cause injuries.
H. Do not use outdoors.
I. Do not let cord hang over edge of table or counter, or touch hot surfaces.
J. Do not place on or near a hot gas or electric burner, or in a heated oven.
K. Extreme caution must be used when moving an appliance containing hot oil or

other hot liquids.
L. Always attach plug to appliance first, then plug cord into the wall outlet. To

disconnect, turn any control to “off”, then removed plug from wall outlet.
M. Do not use appliance for other than intended use.
N. Save these instructions.

SPECIFICATIONS

Model SR-183R SR-652R
Voltage 120V~ 60Hz 208-240V~ 50/60Hz
Consumption 1800W 2700W
Dimension 12.60” x 13.4” x 3.94” (H)
Weight 12.79 LBS
Power Range 350~1800W 250~2700W
Cord Length 5.9 feet

Overheat protection. Automatic hazard detection. Circuit

Protection Designs

Warning: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user's authority to operate the
equipment.

NOTE: This equipment has been tested and found to comply with the limits for a
consumer ISM equipment, pursuant to Part 18 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio TV technician for help.

This device complies with part 18 of the FCC rules.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may

cause undesired operation.

protection sensor. High voltage. 20A fuse. Small object

heat prevention. Thermostat. Pan material detection