Sunpentown RF-330SS Installation Manual

PLEASE READ THIS MANUAL CAREFULLY BEFORE USING

RF-330SS (Stainless Steel)

RF-330W (White)

PARTS IDENTIFICATION

1. Thermostat Dial

2. Freezer Compartment With Freezer Door

3. Wire shelf

4. Drip Tray

5. Magnetic Gasket

6. Bottle Racks

7. Canstor Door Liner

8. Leveling Legs

Note: This figure is only a sketch of the refrigerator. The actual product may differ slightly.

1

READ THESE INSTRUCTIONS COMPLETELY AND CAREFULLY

Ventilation

There is need of good ventilation around the refrigerator for dissipation of
heat, high efficiency of refrigeration and low power consumption. For this
purpose, following clearance is needed for proper air circulation:

Back: 4” (100mm) from the wall
Sides: 8” (200mm)
Top: 12” (300mm)

• A clear space should be left to open the door to 160º

Protection from Moisture

Avoid placing unit where heavy moisture is present, this is to minimize
possibility of metal parts rusting. Never spray water onto the unit.
Never spray water directly onto the unit – which may damage the insulation.

Protection from Heat

PREPARING TO INSALL

Keep unit away from any heat source and direct sunshine.

Location

Unit should be placed on a flat and solid ground, which can support the
refrigerator when fully loaded. Adjust the leveling legs so the unit is firmly
positioned on the floor. Do not place unit near anything that may echo.

Keep Away from Danger

Do not place refrigerator near any combustibles such as gas, petrol,
alcohol, lacquer, banana old and etc. The above mentioned should not be
stored in the refrigerator.

Moving

Secure all loose items (such as shelves and ice tray). Unit should never be
set horizontally, upside down or declined more than 45º.

2