Sunpak LED 9 video light Specification

Sunpak LED 9 video light

High-power illumination for your camcorder or HDSLR camera

Ultra-thin design with 9 super-bright LEDs rotate using patent pending light column technology for even lighting of
standard 4:3 and wide 16:9 HD formats. Runs on just three AAA batteries, while providing brighter light without the
weight.

Instructions
Battery installation: Open the battery
compartment by sliding out and install three
alkaline or Ni-MH AAA (batteries not
included).

Mounting foot with locking ring: Insert the
LED 9 foot into the mount of your camcorder
or HDSLR camera and tighten locking ring to
secure. The 1/4”-20 threaded socket allows
mounting on a tripod or light stand.

Power control: Turn on by sliding the power
control switch upward to M position for the
medium power setting or to H position for
high power setting.

Rotating light columns: rotated individually to
achieve various lighting options. Set light
columns straight ahead standard 4:3
illumination. For 16:9 HD format rotate the
light columns outward. The light columns may
also be rotated inward for special
requirements. Note: do not rotate the light
bars beyond the first left or right click stops.

Diffuser: used to diffuse light for more
pleasing results.

Color correction filter: used to create warmer
and more natural tones.

Both may be used with light columns rotated.

Rotating light columns

Power control

Diffuser

Color correction filter

Battery compartment cover

Mounting foot with locking ring

Sunpak One Year Limited Warranty

This Sunpak product has been carefully manufactured, accurately adjusted, inspected and thoroughly
tested before shipment to assure you of the highest quality.

Should this product require service, we will repair or replace, at our option, any part or the product itself,
which our examination shows to be defective in material or workmanship. This warranty does not apply
to wear and tear associated with the normal use of the product. This warranty is non-transferable.

Repairs will be made to the product at no charge, under the terms of the warranty as stated above, only
when accompanied by a dated and itemized bill of sale and nominal handling charge.

Be certain to follow all assembly and/or operating instructions with this product. This warranty is not
valid if the product has been misused or damaged in any way that is beyond our control or through
normal wear and tear associated with use. This warranty applies only to the product and we are not
responsible in any way for losses, damages or any inconvenience caused by equipment failure.

Some states do not allow the exclusion or limitation of consequential damages, so the above limitation
or exclusion may not apply to you. This warranty gives you specific legal rights and you may have other
rights which may vary from state to state.

Should service be required, the product should be carefully packed (in the original packaging if
possible ) and sent, prepaid and insured, along with a check or money order for $4.95 (shipping and
handling), to the address listed below. A note briefly describing the nature of the defect should also be
enclosed to expedite handling. Proof of purchase and payment for shipping and handling must be

included for all warranty repairs.

Sunpak, ToCAD America Inc., 53 Green Pond Road, Rockaway, NJ 07866, Attention Service Department

Specifications

• Light source: 9 high-power cool light LEDs

• Output: adjustable dimmer control

• Weight: 2.1 oz (without batteries)

• Dimensions: 2.75" wide x 3.95” high x 0.85" deep

• Mount: foot w/locking ring and 1/4” x 20

• Power input: 3 AAA batteries, alkaline or Ni-MH*

• Light output: 1000 lux @ 2’, 300 lux @ 4,

150 lux @ 6’

• Battery life: 90 minutes (with 750 mAh Ni-MH)

• Color temperature: without filter 5500°K– 6500°K

• Working distance: 2’ to 15’

• Included: diffuser, color correction filter, manual

• Warranty: 1 Year limited

* Batteries not included

Product design and specifications subject to change without notice.

s u n p a k . c o m