Page 1
Mini Stepper with
Edited with the trial version of
Foxit Advanced PDF Editor
To remove this notice, visit:
www.foxitsoftware.com/shopping
Exercise Bands
Item NO. 012
For Customer Service, please contact: support@sunnyhealthfitness.com
Page 2
Important Safety Information
Edited with the trial version of
Foxit Advanced PDF Editor
To remove this notice, visit:
www.foxitsoftware.com/shopping
1
We thank you for choosing our product. To guarantee your safety and health, please use this equipment
correctly. Please read the information below carefully before using this equipment.
1. It is important to read this entire manual before assembling and using the equipment. Safe and effective
use can only be achieved if the equipment is assembled, maintained and used properly.
2. Before starting any exercise program you should consult your doctor to determine if you have any medical
or physical conditions that could put your health and safety at risk, or prevent you from using the equipment
properly. Your doctor’s advice is essential if you are taking medication that affects your heart rate, blood
pressure or cholesterol level.
3. Be aware of your body’s signals. Incorrect or excessive exercise can damage your health. Stop exercising if you experience any of the following symptoms: pain, tightness in your chest, irregular heartbeat, and
extreme shortness of breath, lightheadedness, dizziness or feelings of nausea. If you do experience any of
these conditions you should consult your doctor before continuing with your exercise program.
4. Keep children and pets away from the equipment. The equipment is designed for adult use only.
5. Use the equipment on a solid, flat level surface with a protective cover for your floor or carpet. To ensure
safety, the equipment should have at least 1.7 feet of free space all around it.
6. Before using the equipment, check that the nuts and bolts are securely tightened. Always use the
equipment as indicated. If you find any defective components while assembling or checking the equipment,
or if you hear any unusual noises coming from the equipment during use, stop immediately. Do not use the
equipment until the problem has been rectified.
7. There are many functions of the computer; the data will show when using the equipment and will display
information about your exercise routine.
8. Wear suitable clothing while using the equipment. Avoid wearing loose clothing that may get caught in the
equipment or that may restrict or prevent movement.
9. This equipment is designed for indoor and home use only, not intended for commercial use.
10. Maximum weight of user: 220LB.
11. Care must be taken when lifting or moving the equipment so as not to injure your back.
12. The equipment is not suitable for therapeutic use.
13. Please save this manual and the assembling tools as well.
Page 3
Part List :
Edited with the trial version of
Foxit Advanced PDF Editor
To remove this notice, visit:
www.foxitsoftware.com/shopping
Main frame 1pc
2
1
NO.
1
2
Exercise bands 2pcs
PARTS QTY
1
2
2
Page 4
Assembly Instructions:
Edited with the trial version of
Foxit Advanced PDF Editor
To remove this notice, visit:
www.foxitsoftware.com/shopping
3
1.
Take out the stepper main frame from the box and l
up first (make
2.
Then adjust the knob clockwise to its place. Note: "+" means
sure cable is secure on the wheel).
higher step range and "-" means lower step range.
3.
Attach the exercise bands to the ring on the stepper (as seen in
steps below).
ift one pedal
4.
Assembly completed.
Rope Assembly Instructions:
1. Unscrew the rope hook nut until it has opened.
2. Attach the rope hook into the pedal hook. Screw the rope hook nut
until it is securely closed.
3. Assembly is done.
Page 5
Adjusting the Rope Length
Edited with the trial version of
Foxit Advanced PDF Editor
To remove this notice, visit:
www.foxitsoftware.com/shopping
4
To Lengthen Rope
Put down one side of the rope; then pull the
bottom of rope down.
(repeat until rope is at desired length)
This adjustment decreases the tension.
*When lengthening the rope; only one side of
the rope can be pushed down. If it doesn’t go
down; try the other side of the rope.
Push up the rope from the bottom; pull one
side of the top rope.
(repeat until rope is at desired length)
This adjustment increases the tension.
To Shorten Rope
Operating Instructions:
1. Please follow and read the instructions before assembling and using the equipment... Any
other kinds of improper use are strictly prohibited.
2. To operate your stepper, make sure the cable is
3
. The
4
. To start exercise, always make sure your feet step right on the pedals; and
5
. Use Knob to adjust the stepping height & tension.
+ Tension gets stronger when tightening the knob and moving range gets higher.
- Tension gets weaker when loosening the knob and moving range gets lower.
suggested
and bolts are securely tightened.
time limit of exercise is 10-15 minutes
connected to
, at least 3 times a week.
the wheel of
Base
Frame.
that all
nuts
Maintenance and Care Instructions:
1. If the stepper screeches during exercise, lubricate shock absorber to improve
the sliding condition.
2. Only use a dry cloth to gently wipe the stepper, clean after usage. Then store
your stepper in a dry place.
3. It’s normal for sound to come from the cylinder when it gets hot during exercise.
4. The cylinder will become hot while exercising. Please do not touch the cylinder to avoid
burning your hand.
Please lubricate U-Shaped iron and cable (
see below
4
)
Page 6
Computer Functions:
Edited with the trial version of
Foxit Advanced PDF Editor
To remove this notice, visit:
www.foxitsoftware.com/shopping
5
MODE/RESET: Press the red "mode" button to select each function. Hold the button down for
3 seconds to reset to zero.
SCAN: Press "mode" button to select "scan", then it will automatically scan through
each function in sequence.
TIME: Automatically accumulates workout time when
CALORIES: Automatically accumulates calories consumed during exercise.
COUNT: Automatically accumulates the counts of steps made during exercise sessions.
REPS/MIN: Automatically displays the count of steps per minute.
starting exercise.
Note:
1. If you have an inaccurate reading on the monitor, please replace the battery immediately
(please see below instructions.)
Battery Exchange Instructions:
1) Take off the plastic cap.
2) Push the battery out by tool/finger.
Page 7
3) Insert the new battery in by tool/finger. Please
Edited with the trial version of
Foxit Advanced PDF Editor
To remove this notice, visit:
www.foxitsoftware.com/shopping
6
make sure the anode (with words) is on the top.
4) Cover the battery with the plastic cap.
5) Connect the wire onto the meter.
6) Insert the meter on Base Frame (1).
2. Please use (1) LR44, 1.5V battery.
3. The monitor is auto-powered. It turns on when exercise begins, and it turns off when no
movement is made between 4 to 5 minutes.
4. All functions will automatically stop calculating when a “stop” sign appears in the upper left
corner of the display monitor. This occurs when there is no signal for a period of 4
seconds. Once the exercise begins again, the meter will automatically start recalculating
and the “stop“ sign will disappear.
Loading...