Sunhans SH24BTA-N User Manual

If only have wireless router, signal coverage range is very

small, the second  oor will become very weak signal

When the wireless router connect to SUNHANS wireless

signal ampli er, the signal coverage range is very large,

on the second  oor of the signal becomes very strong.

www.sunhans.com

made in china

User Manual

P/N 24BTAN24014

Operating Temperature

Operating Humidity

Material

Booster Weight

Package Weight

Booster Size

Package Size

-20°C to + 70°C

Up to 75% relative humidity

Cast Aluminum

145 g

380g

8.4 x 4.7 x 1.7cm

21 x 13.5 x 4.5cm

Connector Type

Input Power

Transmit Gain

Output Power

Receiver Gain

Noise Figure

Frequency Response

Power Adapter

Operating Mode

Bi-directional, half-duplex, time division duplex senses RF, carrier

from transmitter and automatically switch receiving to transmitting

mode

SMA Receptacle (50 ohm)

0 ~ 20 dBm

15-18dB

3000mW (35dBm)

≤ 12 dB

3.5 dB typical

±1dB over operating range

12V/2A DC, 100~240V for AC Adapter

Model Name

Operating Range

SH24BTA-N

2400~2500 MHz

Sunhans’s family of Wi-Fi Signal Booster is designed for use in mobile and/or mesh

wireless networking applications. most consistent signal amplication available for Wi-Fi

networks. Designed for bi-directional signal amplication, In contrast, traditional analog

amplier technologies can go into saturation or reduce transmit power as input signal

uctuates, negatively impacting signal quality and network performance. While allowing

for the use of virtually any 2,4GHz antenna that implements an SMA-Male connector.

while the small footprint and low prole design makes it an ideal solution for mounting on

vehicles or in other space constrained applications.

The Sunhans’s 2.4GHz Inline Signal Booster efciently increases signal reach of any

antenna by up to 200%-400% while maintaining high data throughput rates. This signal

boosting functionality adds up to 18dB of transmit gain and 12dB of receive gain, resulting

in a farther reaching signal and better connectivity with client radios.results may vary

depending on environmental factors, interference, cable length and type, etc.

Features & Description

Installation Sketch Map

1

2

3

4

Remove antenna from AP Router

Connect Booster to AP Router with RG316 cable

Connect the antenna to the other end of booster

Plug in the power adapter

www.sunhans.com

Package Contents:

.1 X signal booster
.1 X power adapter
.1 X 20cm RG316 cable
.1 X 6dBi antenna
.1 x English user manual

1

2

4

3