Page 1
R
Sunglo™ Patio Heaters
PSA265 V E
sun glosun glo
The Original Outdoor Patio Heater
Model PSA265 V , E
The Sunglo™ model PSA265 permanent post heater
is an outdoor rated natural gas heater ideal for open
patio designs. The in-ground post minimizes the deck
space required and positions these heaters at the ideal
height for comfort and safety. Heat coverage varies
depending on the wind exposure on the patio. The
average spacing between heaters is 12 feet apart.
This heater is available with a variety of control
systems. Each control system is equipped with 100%
safety shutoff. The PSA265 is a manually operated
heater requiring no electrical connections. The
PSA265V with solenoid gas valve allows the heater
to be turned off/on at the turn of a switch. The
PSA265E offers a completely automated ignition
system. Both the PSA265V and PSA265E require an
external 24 VAC source.
This heater offers a large deep aluminum disk
reflector for maximum comfort, a primary aerated
burner for minimal noise, and 100% safety shutoff.
The post is available in a glossy black powder-coat
finish or 304 stainless steel.
( ) ( )
( ) ( )
A242
A244 V E
( ) ( )
Specifications:
Overall Height 93 inches
Input Rating 50,000 BTU/HR
Fuel Type Natural Gas
Ignition Pilot or Electronic
Electrical PSA265V & E 24 VAC 20 VA
Transformer 24 VAC Not Included
Wind Rating 10 mph Horizontal
Nominal Spacing 12 feet
Manufactured United States
Certification CSA International
Warranty One Year / Parts Only
Mfr. by:
INFRARED DYNAMICS, INC.
3830 Prospect Avenue
Yorba Linda, CA 92886
Toll Free: 1-888-317-5255
www.infradyne.com
A270
Sunpak S25, S34
Form No 65061-10/07 Printed in U.S.A. Copyright © Infrared Dynamics, Inc. 2007
Page 2
R
Sunglo™ Patio Heaters
sun glosun glo
The Original Outdoor Patio Heater
Top Clearance
18”
24” Side
Clearance
84”
12”
34 ½”Diameter
Reflector
Radiant Emitter Grid
Pilot Lighting Hole
100% Safety Shutoff Control
Heater Head Base
Slip Collar
3” Dia. Steel Post
½” Gas Pipe
WARNING
All external piping must be
protected against trip
hazards.
Model PSA265 V , E
( ) ( )
PSA265 heaters require no electrical connection and are the
easiest to service and maintain. This heater utilizes a pilotthermocouple 100% safety shutoff. Pilot must be manually lit.
Heater is turned off/on with a manual control knob located at
the front of the heater.
PSA265V heaters require 24 VAC electrical to be connected
in order to operate the main burner. This heater utilizes a
pilot-thermocouple 100% safety shutoff. Pilot must be
manually lit. Heater is turned off/on with electrical switch,
timer or other control device by interrupting the 24 VAC
supply to the heater. Control device is to be supplied by the
installer. Manual control knob must be set to the ON position
for this heater to operate with an electrical switch.
PSA265E heaters require 24 VAC electrical to be connected
in order to operate. This heater utilizes an electronic ignition
and monitors the heater through flame rectification. Heater
cannot be manually lit. Heater is turned off/on with electrical
switch, timer or other control device by interrupting the 24
VAC supply to the heater. Control device is to be supplied by
the installer.
U/L or CSA
Certified Waterproof
Outdoor Junction Box
(Supplied By
Electrical Installer)
7½”Ref.
Ground Level
Under Ground
½”PVC
Plastic Tubing
½” 90 Elbow
Gas Inlet
½” Pipe Coupling
Approved Manual
½” Gas Shut-Off Valve
½”Gas Inlet Pipeline
for 50,000 BTU/Hr
12” Minimum
Suggested Specifications:
Heater shall be Sunglo™ model PSA265, PSA265V, or
PSA265E as manufactured by Infrared Dynamics, Inc.,
Yorba Linda, California. All heaters shall be equipped
with a control system for use with natural gas fuel.
Each heater shall have passed the ANSI requirements
for outdoor heaters.
Reflector shall be of a deep disk circular type mounted
on top of heater.
The required clearance from combustible materials must be
maintained on all heaters. In addition heaters must have
adequate fresh air and ventilation to operate properly. Make
sure you can meet these requirements in making your heater
selection.
This specification sheet was designed as a brief summary
about this heater. The primary use of this sheet should be for
heater selection only. It should not be used as the sole guide
in placement and installation of these heaters. Complete
installation instructions can be obtained by calling toll free at
1-888-317-5255 and online at www.infradyne.com.
SUGGESTED SPACING WHEN
MULTIPLE HEATERS
ARE USED:
15 Ft. 15 Ft.
Spacing For - WELL PROTECTED AREAS
AND MILD CLIMATIC CONDITIONS
12 Ft. 12 Ft.
Infrared Radiant Emitter Grid shall be made of
perforated stainless steel.
Each heater shall be equipped with a 100% safety
shutoff device.
Spacing For - SEMI EXPOSED AREAS
WITH AVERAGE WEATHER CONDITIONS
8 Ft. 8 Ft.
Spacing For - COMPLETELY EXPOSED AREAS
WITH SEVERE WEATHER CONDITIONS
Loading...