Sunglo A244VE User Manual

R

Sunglo™ Patio Heaters

PSA265 V E

sun glosun glo

The Original Outdoor Patio Heater

Model A244 V , E

The Sunglo™ model A244 suspended heater frees
your deck by supporting heaters from above. The
distinctive frame works well in a variety of decors.
Optional automatic control systems make these
heaters easy to operate even though they may be out
of easy reach. Heat coverage varies depending on the
wind exposure on patio. The average spacing
between these heaters is 12 feet.

This heater is available with a variety of control
systems. Each control system is equipped with 100%
safety shutoff. The A244 is a manual heater requiring
no electrical hookup. The A244V with solenoid gas
valve allows the heater to be turned OFF/ON at the
turn of a switch. The A2445E offers a completely
automated ignition system. Both the A244V and
A244E requires an external 24 VAC source.

This heater offers a large deep aluminum disk
reflector for maximum comfort, a primary aerated
burner to minimize noise, and 100% safety shutoff.
The wrought iron frame with classic metal scroll
design comes in a black powder coat finish.

( ) ( )

( ) ( )

A242

A244 V E

( ) ( )

Specifications:

Input Rating 50,000 BTU/HR

Fuel Type Natural Gas

Ignition Pilot or Electronic

Electrical (A244V & E) 24 VAC - 20 VA

24 VAC Transformer Not Included

Wind Rating 10 mph Horizontal

Nominal Spacing 12 feet

Mounting Suspended

Manufactured United States

Certification CSA International

Warranty One Year / Parts Only

Weight 49 lbs

Mfr. by:

INFRARED DYNAMICS, INC.

3830 Prospect Avenue

Yorba Linda, CA 92886

Toll Free: 1-888-317-5255

www.infradyne.com

A270

Sunpak S25, S34

Form No 65063-10/07 Printed in U.S.A. Copyright © Infrared Dynamics, Inc. 2007

R

Sunglo™ Patio Heaters

sun glosun glo

The Original Outdoor Patio Heater

A244 heaters require no electrical connection and are
the easiest to service and maintain. This heater
utilizes a pilot-thermocouple 100% safety shutoff.
Pilot must be manually lit. Heater is turned off/on with
a manual control knob located at front of the heater.

A244V heaters require electrical 24 VAC to be
connected in order to operate the main burner. This
heater utilizes a pilot-thermocouple with100% safety
shutoff. Pilot must be manually lit. Heater is turned
off/on with an electrical switch, timer or other control
device by interrupting the 24 VAC supply to the
heater. Control device to be supplied by the installer.
Manual control knob must be set to the ON position
for this heater to operate with an electrical switch.

A244E heaters require 24 VAC electrical to be
connected in order to operate. This heater utilizes an
electronic ignition and monitors the heater through
flame rectification. Heater cannot be manually lit.
Heater is turned off/on with electrical switch, timer or
other control device by interrupting the 24 VAC supply
to the heater. Control device to be supplied by the
installer.

Model A244 V , E

18” Top Clearance

24” Side

Clearance

84”

41 ¼”

25”

12”

Heater

L Bracket
(Supplied
by installer)

34½” Diameter

Head

Base

( ) ( )

Pilot
Lighting Hole

100% Safety
Shutoff Control

½” Electrical Conduit

(Supplied by installer)

Reflector

Radiant
Emitter Grid

24 Volt
Electrical
Inlet

The required clearance from combustible materials
must be maintained on all heaters. In addition heaters
must have adequate fresh air and ventilation to
operate properly. Make sure you can meet these
requirements in making your heater selection.

This specification sheet was designed as a brief
summary about this heater. The primary use of this
sheet should be for heater selection only. It should
not be used as the sole guide for placement and
installation of these heaters. Complete installation
instructions can be obtained by calling toll free at
1-888-317-5255 and online at www.infradyne.com.

Suggested Specifications:

Heater shall be Sunglo™ models A244, A244V, or
A244 as manufactured by Infrared Dynamics, Inc.,
Yorba Linda, California. All heaters shall be equipped
with a control system for use with natural gas fuel.
Each heater shall have passed the ANSI
requirements for outdoor heaters.

Reflector shall be of a deep disk circular type
mounted on top of heater.

Infrared Emitter shall be made of perforated stainless
steel.

½”Gas

Pipe

Gas Inlet

ELECTRICAL HOOKUP

(A244 Only)

37 ½”

NEC Class 2
24 VAC Transformer-20 VA
(Supplied by Installer)

24 VAC120 V

Wall Switch
(Supplied by
Installer)

Each heater shall be equipped with a 100% safety
shutoff device.