SUNGI TECHNOLOGY T2U User Manual
Notes:
Notes:
this product has A B C three configurations can choose.
this product has A B C three configurations can choose.
lithium battery version,this version built in
Configure A:
Configure A:
rechargeable lithium battery,additional charge USB line.
rechargeable lithium battery,additional charge USB line.
Configure B:
Configure B:
support the charging function.
support the charging function.
Configure C:
Configure C:
for lithium battery configuration.
for lithium battery configuration.
press the FN+F2,turn on the backlit lights
press the FN+F2,turn on the backlit lights
press the FN+F2,turn off the backlit lights
press the FN+F2,turn off the backlit lights
lithium battery version,this version built in
install AAA 2 battery,this version does not
install AAA 2 battery,this version does not
Backlit version，this version is only suitable
Backlit version，this version is only suitable
with USB Dongle
FCC Information and Copyright
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does
cause harmful interference to radio or televisi on reception, which can be determined by turning the
equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
15.19 Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1)This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
Loading...