Sun Cupid Technology NUUZ8 User Manual

Tap-to-Wake: With the LCD off, simply

double tap the screen of your locked
phone to wake it up.

the ringer.

the ringer.

draw an “O” on the screen to open
the camera.

screen state to toggle the flashlight.

With the LCD off,

the phone in lock

Changes or modifications not expressly approved
by the party responsible for compliance could void
the user's authority to operate the equipment.

SAR Information Statement

Your wireless phone is a radio transmitter and
receiver. It is designed and manufactured not to
exceed the emission limits for exposure to
radiofrequency (RF) energy set by the Federal
Communications Commission of the U.S.
Government. These limits are part of
comprehensive guidelines and establish permitted
levels of RF energy for the general population.
The guidelines are based on standards that were
developed by independent scientific organizations
through periodic and thorough evaluation of
scientific studies. The standards include a
substantial safety margin designed to assure the
safety of all persons, regardless of age and health.
The exposure standard for wireless mobile
phones employs a unit of measurement known as
the Specific Absorption Rate, or SAR. The SAR
limit set by the FCC is 1.6 W/kg. * Tests for SAR
are conducted with the phone transmitting at its
highest certified power level in all tested frequency
bands. Although the SAR is determined at the
highest certified power level, the actual SAR level
of the phone while operating can be well below the
maximum value. This is because the phone is
designed to operate at multiple power levels so
as to use only the power required to reach the
network. In general, the closer you are to a
wireless base station antenna, the lower the power
output. Before a phone model is available for sale
to the public, it must betested and certified to the

FCC that it does not exceed the limit established by
the government adopted requirement for safe
exposure. The tests are performed in positions
and locations (e.g., at the ear and worn on the
body) as required by the FCC for each model.
The highest SAR value for this model phone when
tested for use at the head is 0.796 W/Kg and when
worn on the body, as described in this user guide,
is 0.488 W/Kg(Body-worn measurements differ
among phone models, depending upon available
accessories and FCC requirements). The maximum
scaled SAR in hotspot mode is 0.488W/Kg. While
there may be differences between the SAR levels
of various phones and at various positions, they all
meet the government requirement for safe
exposure. The FCC has granted an Equipment
Authorization for this model phone with all reported
SAR levels evaluated as in compliance with the
FCC RF exposure guidelines. SAR information on
this model phone is on file with the FCC and can be
found under the Display Grant section of http://
www.fcc.gov/ oet/fccid after searching on
FCC ID: 2ADINNUUZ8 Additional information on
Specific Absorption Rates (SAR) can be found on
the Cellular Telecommunications Industry
Asso-ciation (CTIA) web-site at http://www.
wow-com.com. * In the United States and Canada,
the SAR limit for mobile phones used by the public
is 1.6watts/kg (W/kg) averaged over one gram of
tissue. The standard incorporates a sub-stantial
margin of safety to give additional protection for the
public and to account for any variations in
measurements.

Body-worn Operation

This device was tested for typical body-worn
operations. To comply with RF exposure
requirements, a minimum separation distance of
10mm must be maintained between the user’s
body and the handset, including the antenna.
Third-party belt-clips, holsters, and similar
accessories used by this device should not contain
any metallic components. Body-worn accessories

that do not meet these requirements may not
comply with RF exposure requirements and
should be avoided. Use only the supplied or an
approved antenna.