Suncon Toys Industry 604393 Users manual

Owner’s Manual draft as below:

RadioShack

1969 CHEVROLET CAMARO HOT ROD
60-4393

what’s included

Vehicle, transmitter, rear wheel (2), box wrench

Step One
Installing Batteries
You will need…

One 9V battery for the transmitter
One 7.2V battery pack for the CAMARO
(neither supplied)

Put Batteries in the CAMARO

· Turn off the Vehicle

· Remove the battery compartment cover.

· Insert the battery pack with it’s connector on the same side as the vehicle’s connector.

· Attach the battery pack and the vehicle connectors. They fit together only one way.
Do not force them.

· Replace the cover.

Put Battery in the Transmitter

. Turn the transmitter off.
. Open the battery compartment cover.
. Insert one 9V battery in the battery compartment, and match the polarity symbols (+

and -) as marked inside.

. Replace the cover and snap it shut.

Step Two
Driving the CAMARO

. Extend the transmitter’s antenna to its full length.
. Turn on your transmitter and vehicle. The red LED light on dashboard starts blinking
to indicate the car is security locked.
. Press Engine Start/Stop button to ignite the vehicle. Headlight cover will slide opened.

Headlight and taillight will illuminate. Idling sound effect will on. The vehicle
changes to ready to drive mode.

. Pick a frequency by setting BAND ABC on the transmitter and the vehicle to the same

setting.

. Pull the trigger towards the handle to drive forward. Driving sound will on when

moving forward.

. Push the trigger away from the handle to drive backward. Braking lights and driving

sound will on when moving backward.

. Release to stop.
. Use the steering wheel to steer the vehicle left and right. Release it to drive straight.
. Designed for easy operation with either hand, you can reverse the direction of the

steering control using left/right switch on the transmitter.

. Press the Horn button for Horn sound effect.
. Press the Engine Start/Stop button to stop the engine. Headlight cover will slide closed.

Headlight and taillight will turn off. The vehicle changes to security locked mode.

. When you finish driving the vehicle, turn the transmitter and vehicle off.
. You can cut all sound effects by selecting the Sound On/ Off switch to Off under the

chassis.

Radio operation
. Turn on your vehicle.
. Slide the Radio On/Off switch to On.
. Press the Scan button to start auto-scanning for radio channel from 88 MHz. The radio

will stop scanning when it received channel.
. Press the Scan button again to scan for next channel.
. Scroll the Volume to adjust volume.
. Press the Reset button to scan back to the beginning frequency (88MHz).
. Slide the Radio On/Off switch to Off.

Battery Notes

· Use only fresh batteries of the required size and recommended type.

· Do not mix old and new batteries, different types of batteries (standard, alkaline, or

rechargeable), or rechargeable batteries of different capacities.

· If you do not plan to use your vehicle for a week or more, remove the battery from the
transmitter and the battery pack from the vehicle. Batteries can leak chemicals that may
destroy electronic parts.

· Never leave dead or weak batteries in the vehicle or transmitter.