Sunburst Gear M6BR8, M6R8 Quick Start Manual

WHAT IS IN THE BOX

Your M6BR8/M6R8* package contains the following:

M6BR8/M6R8* Portable All-in-One

6 Channel Rechargeable Mixer/Monitor

Speaker System w/ Bluetooth

®

Quick Start Guide

(1) Speaker
(1) 12V AC Power Supply Adaptor
(1) 12V DC Car Battery Supply Adapter

(1) Right Angle Speaker Cable
(1) Quick Start Guide
(1) Registration Card

* Bluetooth® available in M6BR8 models only
The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Ing. and any use of such marks
by Elite Acoustics Designs, Inc is under license

NOTE: Due to continuous development and improvements of our products, features and specications are subject to

change without notice. All weights and measures are approximate.

QUICK START

1. Make sure the SPEAKER VOLUME [3] control is down before your turn the
POWER [22] on.

2. Connect the output of your microphone to the MIC IN [13]. Or you can connect a
¼” line input from an instrument [12]. Connect an additional mono or stereo [11].

3. Connect the DC power cord to the back panel [20].

4. Turn on the POWER [22] switch

5. Connect device to Bluetooth® [23]

6. Turn on your source signal(s) and adjust the volume on the source signal for
normal operation. Note if you are using an iPhone or iPad via Bluetooth®, set the
volume on your device about halfway. Maximum volume will distort.

7. Adjust the SPEAKER VOLUME [2] to a comfortable level.

8. Turn up GAIN [8] and TRIM [14] until there is a solid green light showing “signal” at
desired level, without a red “peak” light, indicating too much signal.

9. For USB charging of your source device, use USB Port [21]

Power LED: BLUE [1] Indicate unit is ON
+48V LED [2]

Monitor Output Controls

Speaker Volume [3]: Control speakers’ volume level
Mono [4]: Changes speaker output to Mono sound

Equalizer [5]: Adjust Speaker High, Mid, and Low Frequency response

Peak LED [6]: RED indicate Signal Clip
Signal LED [6]: GREEN indicate Signal Present

Aux Input/Level [7]: Connect audio source with 1/8” jack from MP3/CD player

Channel 1-4 input

Gain [8] knob: Input Level control
Mute Switch [9]: Mute Channel
Pan [10] knob: Split signal into Left/Right Channels
Insert [11]: 1/4” TRS - Insert Effects, Chan 1 and 2 only.
Line In [12]: 1/4” TRS inputs
Mic In [13]: XLR for Microphone Input

Channel 5/6 input

Trim Knob [14]: Input Level control
Left/Right channel input [15] : 1/4” TRS inputs
AUX input Level and 1/8” Jack [16]
Monitor Right Output: Connect with extra speakers/monitors
Main Output Level Knob [17]: Output Level Control
Main Output [18]: 1/4” TR
+48VDC [19]
Power Switch [20]

BLUETOOTH® FUNCTION

• To turn ON/OFF Bluetooth® function

PRESS/HOLD down MODE button for approximately 5 seconds

Both LEDs will ash at the same time

• To pair device to the speaker system

Bluetooth® needs to be turned ON
QUICK TAP the MODE button once
Both Flashing LED: indicate Bluetooth ® is ready to be paired

Flashing Blue LED only: indicate Bluetooth® is connected