Feel Perfect
Heated Throw
Instruction Booklet
TR6300 Luxe Faux Fur
Please read these instructions carefully
and retain for future reference.
Contents
Sunbeam’s Safety Precautions 1
Safety Precautions for your heated throw 2
®
Sunbeam’s SleepPerfect
Features of your Feel Perfect Heated Throw 4
Using your heated throw 5
Troubleshooting 6
Care and cleaning 7
Technology 3
Sunbeam’s Safety Precautions
Sunbeam is very safety conscious when
designing and manufacturing consumer products,
but it is essential that the product user also
exercise care when using an electrical appliance.
Listed below are precautions which are essential
for the safe use of an electrical appliance:
• Read carefully and save all the instructions
provided with an appliance.
• Always turn the power off at the power outlet
before you insert or remove a plug. Remove
by grasping the plug - do not pull on the cord.
• Turn the power off and remove the plug
when the appliance is not in use and
before cleaning.
• Do not use your appliance with an extension
cord unless this cord has been checked
and tested by a qualified technician or
service person.
• Always use your appliance from a power
outlet of the voltage (A.C. only) marked
on the appliance.
• Close supervision is necessary when your
appliance is being used by children or infirm
persons.
• Young children should be supervised to ensure
that they do not play with the appliance.
• Never leave an appliance unattended while
in use.
• Do not use an appliance for any purpose
other than its intended use.
• Do not place an appliance on or near a hot gas
flame, electric element or on a heated oven.
Do not place on top of any other appliance.
• Do not let the power cord of an appliance hang
over the edge of a table or bench top or touch
any hot surface.
• Do not operate any electrical appliance with
a damaged cord or after the appliance has
been damaged in any manner. If damage is
suspected, return the appliance to the nearest
Sunbeam Appointed Service Centre
for examination, repair or adjustment.
• For additional protection, Sunbeam
recommend the use of a residual current
device (RCD) with a tripping current not
exceeding 30mA in the electrical circuit
supplying power to your appliances.
• Do not immerse the appliance in water
or any other liquid unless recommended.
• Appliances are not intended to be operated
by means of an external timer or separate
remote control system.
If you have any concerns regarding the performance and use of your appliance,
please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line.
Ensure the above safety precautions are understood.
1
Safety Precautions for your
Electric Throw Rug
• Do not switch the throw rug on if moist or wet.
• Do not use pins, needles, safety pins or other
sharp items on your electric throw.
• Examine periodically for signs of wear or damage
on the throw rug cords. If there are such signs, or
the throw rug has been misused, return it to an
authorised service agent for inspection.
• Only use your electric throw with the controls
supplied or marked equivalent.
• Not to be used by very young children
(0-3 years), infirm persons, or persons insensitive
to heat.
• The appliance is not to be used by young children
over the age of three unless the controls have
been pre-set by a parent or guardian, or unless
the child has been adequately instructed on how
to operate the controls safely.
• Ensure that the electric throw is switched off and
unplugged after use.
• This electric throw is not intended for use
in hospitals.
• If appliance is used on an adjustable bed, check
that the throw rug and cord do not become
trapped or rucked, for example in hinges.
• When storing the appliance allow it to cool down
before folding.
• Do not crease the appliance by placing items on
top of it during storage.
• Should your appliance suffer a thermal or fuse
link rupture (normally identified when the
throw rug stops heating) please return it to the
manufacturer or agent for repair or replacement.
• This appliance must not be used by persons
insensitive to heat and other very vulnerable
persons who are unable to react to overheating.
• Children under the age of three are not to use
this appliance due their inability to react to
overheating.
• Use as an overblanket only.
Important instructions – retain for
future use.
If you have any concerns regarding the performance and use of your appliance,
please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line.
Ensure the above safety precautions are understood.
Care Label Symbols
Attention
Instruction Booklet - Please read the instructions thoroughly before use
2
Sunbeam’s SleepPerfect®
Technology
Temperature sensitive, fast-heating elements
All Sunbeam Feel Perfect electric throw
rugs feature our exclusive SleepPerfect
technology. This technology uses a unique
heating element that adjusts the heat level
of your electric throw rug to maintain your
selected setting.
A built-in microprocessor continually senses
changes in room and body temperature
and adjusts the power input accordingly, to
provide a constant level of comfort.
®
Nine levels of safety protection
Nine levels of total safety protection make
Sunbeam's Feel Perfect range safer than
any other electric throw rug. A built-in
microprocessor constantly senses the
resistance of the heating wire and adjusts the
power input accordingly. It senses any rise in
temperature and reduces the power supply to
prevent overheating.
In the unlikely event of a fault, the
microprocessor senses the abnormal
operation and automatically cuts off power to
the throw rug.
The unique flexible heating element allows
the fabric to drape around you, enabling the
heated throw to be used on the lounge or
your favourite arm chair.
This unique element also heats up to reach
your selected temperature in just 10 minutes,
so there’s no need for hours of preheating.
A second microprocessor acts as a back up
should the first fail.
For additional safety protection, all Feel
Perfect electric throw rugs contain a thermal
back up fuse that is independent of the
throw rug control. It detects any abnormal
temperature variations in the heating element
and automatically switches the throw rug off
to prevent overheating.
3
Features of your Feel Perfect
Heated Throw
TR6300 Luxe Faux Fur
Your Feel Perfect heated throw
has the following features:
SleepPerfect
Sunbeam’s exclusive SleepPerfect
technology continually senses and adjusts to
changes in your room and body temperature
to maintain your selected heat setting. So
when the temperature drops outside, you’ll
stay safe and warm.
Luxurious Faux Fur
The ultimate in luxury! The 885g/m² top
layer of faux fur with an underside of micro
fleece will keep you warm this Winter.
Dry Clean Only
Do not wash or tumble dry.
®
Technology
®
6 heat control
A choice of six heat settings allows you to
select the desired temperature to keep you
comfortable, day or night. The setting dial
illuminates to enable easy adjustment in the
dark.
Detachable control
Remove the control when laundering your
throw rug, or when storing.
4
Using your heated throw
Using your heated throw
Your heated throw can be used on the lounge
or in your favourite chair, providing cosy
comfort wherever you need it. It can even
be used on futons, adjustable beds and
waterbeds.
Connecting the control
With the control set to the off position, insert
the control connector into the socket, making
sure it is firmly clicked into position. Plug
the control into a 230-240V power outlet and
turn the power on.
Note: ensure that the control is connected to
the heated throw before inserting the plug
into the power outlet. Connecting the power
before attaching the control to the throw
rug will replicate a power interruption and
activate the safety system, preventing the
throw from heating.
Caution: keep the control away from heating
sources such as heaters and lamps. Do not
cover the control.
Using your heated throw
Your heated throw is supplied with a 6 heat
control. The settings on the temperature dial
are recommended for use as follows:
1 – 2 Low, gentle heat for all night use
3 – 4 Medium heat
5 – 6 High heat, for preheating only
Use the high heat settings to preheat the
throw only. Do not use your heated throw on
these settings for more than 30 minutes.
5
Troubleshooting
Should your heated throw fail to heat, check the
following:
1. Check that the control is properly
connected to the heated throw and clicked
securely into position. If you find the
control connector plug is not properly fitted
to the heated throw, switch the power off
at the power outlet, securely attach the
control connector plug to the heated throw,
and then switch the power back on.
2. Check that the power cord is connected
to the power outlet and the power is
switched on.
6
Care and cleaning
Before cleaning your throw rug, ensure
that the controls are unplugged from the
throw rug.
Spot cleaning
Sponge the affected area using a neutral
wool detergent or mild soap flakes mixed
with lukewarm water. Sponge twice with
clean water to remove detergent. Remove
excess water by compressing the wet area
between two towels.
Dry clean only
Your faux fur throw rug is dry clean only.
Do not hand or machine wash.
Storing your throw rug
Roll or fold your throw rug loosely and store
in a blanket bag or the bag it was supplied
in. Avoid pressing sharp creases into the
throw rug.
Do not place heavy items on top of your
heated throw when storing.
7
HeadingNotes
3 Year Warranty
This Sunbeam product is covered by a 3 year replacement or repair
warranty, which is in addition to your rights under the Australian Consumer
Law (if your product was purchased in Australia) or New Zealand Consumer
Guarantees Act (if your product was purchased in New Zealand).
Should you experience any difficulties with your
product during the warranty period, please contact
our customer service line for advice on 1300 881 861
in Australia, or 0800 786 232 in New Zealand.
Alternatively, you can send a written claim to
Sunbeam to:
Australia
Units 5 & 6, 13 Lord Street
Botany NSW 2019 Australia
New Zealand
Level 6, Building 5, Central Park,
660-670 Great South Road,
Greenlane, Auckland
Upon receipt of your claim, Sunbeam will seek to
resolve your difficulties or, if the product is defective,
advise you on how to obtain a replacement or refund.
To assist us in managing warranty claims, we
recommend you register your product as soon as
practicable after purchase by creating a MySunbeam
account on our website and send a copy of your
original receipt to Sunbeam.
In order to make a claim under our warranty, you must
have the original proof of purchase documentation for
the product and present it when requested .
Should your product develop any defect within
3 years of purchase because of faulty materials or
workmanship, we will replace or repair it, at our
discretion, free of charge. A product presented for
repair may be replaced by a refurbished product
of the same type rather than being repaired.
Refurbished parts may be used to repair the product.
Our replacement or repair warranty only applies
where a defect arises as a result of faulty material or
workmanship during the warranty period. Your warranty
does not cover misuse or negligent handling (including
damage caused by failing to use the product in
accordance with this instruction booklet), accidental
damage, or normal wear and tear.
Your warranty does not:
• cover freight or any other costs incurred in making a
claim, consumable items, accessories that by their
nature and limited lifespan require periodic renewal
(such as filters and seals) or any consequential loss
or damage; or
• cover damage caused by:
- power surges, power dips, voltage supply problems,
or use of the product on incorrect voltage;
- servicing or modification of the product other than
by Sunbeam or an authorised Sunbeam service
centre;
- use of the product with other accessories,
attachments, product supplies, parts or devices
that do not conform to Sunbeam specifications; or
- exposure of the product to abnormally corrosive
conditions; or
• extend beyond 3 months if the product is used
in commercial, industrial, educational or rental
applications.
The benefits given to you by our warranty are in addition
to other rights and remedies under law in relation to the
product.
In Australia our goods come with guarantees that cannot
be excluded under the Australian Consumer Law. You are
entitled to a replacement or refund for a major failure
and for compensation for any other foreseeable loss or
damage. You are also entitled to have the goods repaired
or replaced if the goods fail to be of acceptable quality
and the failure does not amount to a major failure.
Our goods also come with guarantees that cannot be
excluded under the New Zealand Consumer Guarantees
Act.
If your warranty claim is not accepted, we will inform
you and if requested to do so by you, repair the
product provided you pay the usual charges for such
repair. You will also be responsible for all freight and
other costs.
Should your product require repair or service after the
warranty period, contact your nearest Sunbeam service
centre. For a complete list of Sunbeam’s service
centres, visit our website or call our customer service
line for advice on 1300 881 861 in Australia,
or 0800 786 232 in New Zealand.
Need help with your appliance?
Contact our customer service team or visit
our website for information and tips on
getting the most from your appliance.
In Australia
Visit www.sunbeam.com.au
Or call 1300 881 861
In New Zealand
Visit www.sunbeam.co.nz
Or call 0800 786 232
is a registered trademark.
‘Feel Perfect’ and 'SleepPerfect' are registered trademarks of
Sunbeam Corporation.
Made in China.
Due to minor changes in design or otherwise,
the product may differ from the one shown in this leaflet.
© Copyright. Sunbeam Corporation Limited 2005-2012.
ABN 45 000 006 771
Units 5 & 6, 13 Lord Street
Botany NSW 2019 Australia
Level 6, Building 5, Central Park
660-670 Great South Road
Greenlane, Auckland
New Zealand
Sunbeam Corporation is a division of GUD Holdings Ltd.
11/13
Loading...