Sunbeam TA8820R, TA8820W, TA8820G, TA8820Y, TA8820B User Manual

Care and Cleaning

12 Month Replacement Guarantee

Need help with your appliance?

Contact our customer service team or visit our website

for information and tips on getting the most from your appliance.

Australia

Phone [phone]

Mail Units 5 & 6, 13 Lord Street,
Botany, NSW 2019, Australia

Visit www.sunbeam.com.au

Sunbeam Corporation Limited | ABN 45 000 006 771

Sunbeam Corporation is a division of GUD Holdings Limited.

Sunbeam is a registered trademark. Made in China to Sunbeam’s specification.

Due to minor changes in design or otherwise, the product you buy may differ slightly from the one

shown here. Approved by the appropriate electrical regulatory authorities.

©Copyright Sunbeam 2015.

New Zealand

Phone [phone]
Mail Level 6, Building 5, Central Park,
660-670 Great South Road,
Greenlane, Auckland,
New Zealand
Visit www.sunbeam.co.nz

Always turn the power OFF and remove the
plug from the power outlet after use and
before cleaning your toaster.

To clean the exterior
Wipe exterior with a slightly dampened cloth
and polish with a soft dry cloth.

Do not use metal scourers or abrasives as
this may scratch the exterior surface.

Removable Crumb Tray

To remove the crumbs, simply pull off the top
of the toaster, empty the tray and place it back
under the toaster.

Important: Clean the crumb tray regularly. Do
not allow crumbs to accumulate, as they may
cause a potential fire hazard.

To clean the toaster interior
Clean inside the toaster regularly. To do this,
unplug the appliance, turn it upside down over
the sink and gently shake all the crumbs

Upon receipt of your claim, Sunbeam will seek to
resolve your difficulties or, if the product is defective,
advise you on how to obtain a replacement or refund.

To assist us in managing warranty claims, we
recommend you register your product as soon as
practicable after purchase by creating a MySunbeam
account on our website and uploading a copy of your
original receipt.

In order to make a claim under our warranty, you must
have the original proof of purchase documentation
for the product and present it when requested (if not
already uploaded to our website).

Should your product develop any defect within 12
months of purchase because of faulty materials
or workmanship, we will replace or repair it, at our
discretion, free of charge. A product presented for
repair may be replaced by a refurbished product of
the same type rather than being repaired. Refurbished
parts may be used to repair the product.

Our replacement or repair warranty only applies
where a defect arises as a result of faulty material
or workmanship during the warranty period. Your
warranty does not cover misuse or negligent handling
(including damage caused by failing to use the
product in accordance with this instruction booklet),
accidental damage, or normal wear and tear.

Your warranty does not:

• cover freight or any other costs incurred in making
a claim, consumable items, accessories that by their
nature and limited lifespan require periodic renewal
(such as filters and seals) or any consequential loss
or damage; or

• cover damage caused by:

- power surges, power dips, voltage supply

problems, or use of the product on
incorrect voltage;

- servicing or modification of the product other

than by Sunbeam or an authorised Sunbeam
service centre;

- use of the product with other accessories,

attachments, product supplies, parts or devices
that do not conform to Sunbeam specifications; or

- exposure of the product to abnormally corrosive

conditions; or

• extend beyond 3 months if the product is
used in commercial, industrial, educational or
rental applications.

The benefits given to you by our warranty are in
addition to other rights and remedies under law
in relation to the product.

In Australia our goods come with guarantees that
cannot be excluded under the Australian Consumer
Law. You are entitled to a replacement or refund for
a major failure and for compensation for any other
foreseeable loss or damage. You are also entitled to
have the goods repaired or replaced if the goods fail
to be of acceptable quality and the failure does not
amount to a major failure.

Our goods also come with guarantees that cannot
be excluded under the New Zealand Consumer
Guarantees Act.

If your warranty claim is not accepted, we will inform
you and if requested to do so by you, repair the
product provided you pay the usual charges for such
repair. You will also be responsible for all freight and
other costs.

Should your product require repair or service after
the warranty period, contact your nearest Sunbeam
service centre.For a complete list of Sunbeam’s
service centres, visit our website or call our customer
service line for advice on 1300 881 861 in Australia,
or 0800 786 232 in New Zealand.

Should you experience any difficulties with
your product during the warranty period,
please contact our customer service line
for advice on 1300 881 861 in Australia, or
0800 786 232 in New Zealand.

Australia | www.sunbeam.com.au
1300 881 861
Units 5 & 6,
13 Lord Street,
Botany NSW 2019
Australia

New Zealand | www.sunbeam.co.nz
0800 786 232
Level 6, Building 5, Central Park,
660-670 Great South Road,
Greenlane, Auckland
New Zealand

2 Slice Toaster User Guide

Sunbeam’s safety precautions 2
Features of your toaster 3
Using your toaster 4
Toaster functions 4
Toasting tips 5
Troubleshooting guide 5
Care and cleaning 6

3012A

3012-A-IB.indd 1 26/08/2015 3:23:37 PM

6 7

TA8820R | TA8820W | TA8820K | TA8820B | TA8820G | TA8820O | TA8820Y

Sunbeam’s Safety Precautions

Important Instructions - retain for future use

Features of your Marc Newson Toaster

Using your Marc Newson
Toaster

Toaster Functions

Toasting Tips

SAFETY PRECAUTIONS
FOR YOUR SUNBEAM TOASTER.

• Do not place any objects such as toast, bread
or similar on top of your toaster when in use.

• Operate the toaster on a flat level surface.

• The bread may burn, therefore do not use
the toaster near or below combustible
material, such as curtains.

• Do not leave your toaster unattended when
in use.

• Clean crumb tray regularly.

• Do not allow crumbs to accumulate in the
crumb tray.

• Do not toast stale bread, rice crackers
or similar on a high setting as they may
catch fire.

• WARNING: Never attempt to extract jammed
toast, crumpets or muffins with a knife or
any other metal object, as contact with a
live element may cause electrocution.

Sunbeam is very safety conscious when
designing and manufacturing consumer
products, but it is essential that the
product user also exercise care when using
an electrical appliance. Listed below are
precautions which are essential for the safe
use of an electrical appliance:

• Read carefully and save all the instructions
provided with an appliance.

• Always turn the power off at the power
outlet before you insert or remove a plug.
Remove by grasping the plug - do not pull
on the cord.

• Turn the power off and remove the plug
when the appliance is not in use and before
cleaning.

• Do not use your appliance with an
extension cord unless this cord has been
checked and tested by a qualified technician
or service person.

• Always use your appliance from a power
outlet of the voltage (A.C. only) marked
on the appliance.

• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,

2 3 4 5

unless they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.

• Children should be supervised to ensure that
they do not play with the appliance.

• The temperature of accessible surfaces may
be high when the appliance is operating.

• Never leave an appliance unattended while
in use.

• The heating element surface is subject to
residual heat after use.

• Do not use an appliance for any purpose
other than its intended use as this may
result in potential injury.

• Do not place an appliance on or near a
hot gas flame, electric element or on a
heated oven.

• Do not place on top of any other appliance.

• Do not let the power cord of an appliance
hang over the edge of a table or bench top
or touch any hot surface.

• Do not operate any electrical appliance with
a damaged cord or after the appliance has
been damaged in any manner. If damage
is suspected, return the appliance to the
nearest Sunbeam Appointed Service Centre
for examination, repair or adjustment.

• For additional protection, Sunbeam
recommend the use of a residual current
device (RCD) with a tripping current not
exceeding 30mA in the electrical circuit
supplying power to your appliances.

• Do not immerse the appliance in water or
any other liquid unless recommended.

• Appliances are not intended to be operated
by means of an external timer or separate
remote control system.

• This appliance is intended to be used in
household and similar applications such as:
staff kitchen areas in shops, offices and
other working environments; farm houses;
by clients in hotels, motels and other
residential type environments; bed and
breakfast type environments.

If you have any concerns regarding the
performance and use of your appliance, please
visit www.sunbeam.com.au or contact the
Sunbeam Consumer Service Line. Ensure the
above safety precautions are understood.

1

4

1. Toast/ Cancel Button

One button control to start and lower
your toast. The Toast/Cancel button
starts or immediately stops any of the
toasting cycles. As a consequence of this,
the toast will pop up.

Defrost Button

The defrost setting ensures bread can be
toasted straight from the freezer.

Reheat

The reheat button toasts for 30 seconds.

2. Browning Control

Select your desired browning level.

3. Removable Crumb tray
Full length crumb tray for easy
crumb removal.

4. Cord Storage
The cord can be wrapped around the cord
storage facility for convenient storage.

5. Self centering slots

Allows bread to always be held in centre
of slot to ensure even toasting.

Before first use, remove any packaging
material or promotional labels attached to
your toaster.

5

2

3

1. Insert the power plug into a 220/240 volt
power outlet then turn the power on.

2. Place bread into toasting slot. Ensure items
for toasting are not too long or too thick to
fit in the toasting slots.

3. Select the toast setting by adjusting the
BROWNING CONTROL on the front of the
toaster. The toast settings range from ‘Left’
(lightest) to ‘Right’ (darkest).

To start the toasting process, press the
TOAST/CANCEL button. The TOAST/CANCEL
button will illuminate and the carriage
will automatically lower into the toasting
position and start the toasting cycle.

4. Once the toasting cycle has completed and
the carriage has risen and locked into the
raised position, the toast ready alert will
sound. Remove the toast.

NOTE: Push the TOAST/CANCEL button
during operation to cancel the toasting
process or any other function.

Toast/ Cancel button

The Toast/Cancel button starts or
immediately stops any of the toasting cycles.
As a consequence of Cancel, the toast will
move to the raised position.

Defrost Feature

The defrost feature can be used to toast
your frozen bread. The colour of your toast
will brown according to the toasting setting
you have chosen. This feature is activated
by pressing the frozen button at any time
during the toasting cycle.

Reheat

The reheat button toasts for 30 seconds
or raises the toast if the cycle time has
exceeded 30 seconds.

• If your bread jams in the toaster, switch
power off, remove the plug from the power
outlet and ease the bread out of the toaster.

• Ensure muffins or bagels are cut into even
halves and fit freely into the bread slot. Do
not force them into the toaster.

WARNING: Never attempt to extract
jammed toast, muffins, bagels or crumpets
with a knife or any other metal object, as
contact with the live element may cause
electrocution.

Troubleshooting Guide

Problem Possible Cause Solution

Unit is not heating
or stops heating

Uneven toast Toasting single

Second toasting
is too dark

Toast is too light
or too dark

You smell burnt
food or smoke
is coming out
when toaster
is being used

Electrical
outlet is not
working or toaster
is unplugged

slice or toasting
brown bread

Setting on toast
is too dark.

You may have
changed the
setting

Remnants of food
in crumb tray.

Check to make sure the outlet is
working. Unplug unit and re-insert plug.
Test toaster by selecting a setting and
depressing the toast control level with
nothing in the toaster

Simply reset the selector to the
desirable setting

If doing repeated toasting in the toaster,
you may want to select a setting lower
than the previous setting

Simply reset the selector to the
desirable setting for the function you
wish to use

Refer to the directions in CARE AND
CLEANING section of this booklet. Make
sure the crumb tray is empty and wiped
clean. Check to make sure no large
crumbs are caught in the slot.

Refer to the directions in CARE AND
CLEANING section of this booklet. Make
sure the crumb tray is empty and wiped
clean. Check to make sure no large
crumbs are caught in the slot.

Turn unplugged unit upside down over
the sink and shake to remove crumbs.

3012-A-IB.indd 2 26/08/2015 3:23:37 PM