ICED + HOT COFFEE MACHINE
User Guide
SDP1500BK
Contents
Sunbeam’s Safety Precautions 1
Features of your Iced + Hot Machine 2
Let's get you started 3
How to use the Frother 4
How to clean your Iced + Hot Coffee Machine 5
FAQ 6
Sunbeam’s Safety Precautions
FOR YOUR SUNBEAM ICED + HOT COFFEE
MACHINE:
• Always place the unit on a flat, level surface.
• Do not place in a cabinet when in use.
• Do not operate without water in water reservoir.
Fill water reservoir with filtered water. Observe
the maximum filling volume.
• Do not allow the power cord to come into contact
with the hot parts of the machine.
• Do not place hands directly under the brew spout
as this can lead to scalding or injury.
• The temperature of accessible surfaces may be
high when the appliance is operating. Even after
use, the heating element surface is subject to
Sunbeam is very safety conscious when designing
and manufacturing consumer products, but it is
essential that the product user also exercise care
when using an electrical appliance. Listed below are
precautions which are essential for the safe use of
an electrical appliance:
• Read carefully and save all the instructions
provided with an appliance.
• Always turn the power off at the power outlet
before you insert or remove a plug. Remove by
grasping the plug - do not pull on the cord.
• Turn the power off and remove the plug when the
appliance is not in use and before cleaning.
• Do not use your appliance with an extension cord
unless this cord has been checked and tested by
a qualified technician or service person.
• Always use your appliance from a power outlet of
the voltage (A.C. only) marked on the appliance.
• This appliance is not intended for use by persons
(including children) with reduced physical,
sensory or mental capabilities, or lack of
experience and knowledge, unless they have been
given supervision or instruction concerning use
of the appliance by a person responsible for their
safety.
• Children should be supervised to ensure that they
do not play with the appliance.
• The temperature of accessible surfaces may be
high when the appliance is operating.
• Never leave an appliance unattended while in use.
residual heat after use.
• Always switch off and unplug at power outlet
before cleaning the coffee machine.
• Children should not perform cleaning and user
maintenance without supervision.
• Always switch off and unplug at power outlet if
there is any problem during the coffee making
process.
• Do not use an appliance for any purpose other
than its intended use. Injury could occur from
misuse.
• CAUTION: To prevent damage to the appliance
do not use alkaline cleaning agents when
cleaning, use a soft cloth and detergent.
• Do not use an appliance for any purpose other
than its intended use.
• Do not place an appliance on or near a hot gas
flame, electric element or on a heated oven.
• Do not place on top of any other appliance.
• Do not let the power cord of an appliance hang
over the edge of a table or bench top or touch
any hot surface.
• Do not operate any electrical appliance with a
damaged cord or after the appliance has been
damaged in any manner. If damage is suspected,
return the appliance to the nearest Sunbeam
Appointed Service Centre for examination, repair
or adjustment.
• For additional protection, Sunbeam recommend
the use of a residual current device (RCD)
with a tripping current not exceeding 30mA in
the electrical circuit supplying power to your
appliances.
• Do not immerse the appliance in water or any
other liquid unless recommended.
• Appliances are not intended to be operated by
means of an external timer or separate remote
control system.
• This appliance is intended to be used in
household and similar applications such as: staff
kitchen areas in shops, offices and other working
environments; farm houses; by clients in hotels,
motels and other residential type environments;
bed and breakfast type environments.
If you have any concerns regarding the performance and use of your appliance,
please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line.
Ensure the above safety precautions are understood.
1
Features of your Iced + Hot
Machine
1
8
5
2
6
3
7
4
1. Lid
2. Brew Spout
3. Scoop Storage
4. Drip tray
5. Frothing jar lid
6. Frothing jar
7. Frothing jar mount
8. HOT BREW button
9. OVER ICE button
10. HOT FROTH button
11. COLD FOAM button
12. Brew Basket
9
13. Reusable coffee filter
14. Scoop
15. Reusable 650ml tumbler
16. Tumbler straw
17. Tumbler lid
2
Let's get you started
Let’s make Iced Coffee!
1. Start with the unit unplugged.
WARNING: To prevent injury from hot
steam or potential damage to the unit do
not plug the unit in until the water is in
the reservoir and the tumbler is put in
place.
2. Fill the tumbler to the “WATER” marking
with filtered water.
3. Pour water into the reservoir.
NOTE: Do not pour above 475ml max fill
line as water reservoir will overflow.
4. Using the Over Ice side of the coffee
scoop, add 1-2 scoops of coffee grounds
to the coffee filter. Rotate the shower
head over the coffee filter and grinds.
Close the lid.
NOTE: Ensure grounds do not spill into
water reservoir when filling coffee filter.
Removing coffee filter to fill with grounds
can help prevent accidental spills into the
reservoir.
5. Fill the tumbler with large ice cubes to
the “ICE” marking.
6. Place the tumbler under the brew spout
and plug unit in. Press the OVER ICE
button – ensure the LED is illuminated.
7. While your coffee is brewing, prepare your
frothed milk if you wish.
8. Wait 3-4 minutes for brewing to
complete, then add your favourite coffee
mix-ins.
9. Insert straw in lid, place lid on tumbler
and enjoy!
Let’s make Hot Coffee!
1. Start with the unit unplugged.
WARNING: To prevent injury from hot steam
or potential damage to the unit do not plug
the unit in until the water is in the reservoir
and the tumbler is put in place in.
2. Grab desired coffee cup or mug and fill with
as much water as you would like coffee.
TIP: Taller coffee mugs work best to avoid
any splashing during brewing.
3. Fill the reservoir with the desired amount
of water, according to the marks on the
inside of the reservoir.
NOTE: Do not pour above 475ml max fill
line as water reservoir will overflow.
4. Using the HOT side of the coffee scoop,
measure coffee grounds that correspond
to amount of water poured.
NOTE: If you prefer bolder hot coffee, you
can use an extra ½ - 1 scoops of coffee
grounds.
5. Pour coffee grounds into reusable coffee
filter.
NOTE: Ensure grounds do not spill into water
reservoir when filling coffee filter. Removing
coffee filter to fill with grounds can help
prevent accidental spills into the reservoir.
6. Rotate the shower head over the coffee
filter and grinds. Close the lid.
7. Place the mug that was used to measure
water under the Brew Spout. Press HOT
BREW button.
8. Wait 3-4 minutes for brewing to
complete, then add in your favourite
coffee mix-ins. Enjoy!
3
How to use the Frother
Let's personalise your coffee with Hot Froth or
Cold Foam
NOTE: When placing the whisk in the frothing
jar, ensure you press down firmly until you
hear the whisk connect to the jar.
1. For a cappuccino add 150ml of the milk
of your choice to the ‘CAPP’ line indicator
in the frothing jar. For a latte add 200ml
of the milk of your choice to the ‘LATTE’
line indicator in the frothing jar.
NOTE: Do not fill frothing jar past ‘MAX’
level indicator.
2. Place frothing jar on mount. Put lid back
on the frothing jar.
3. Press either the COLD FOAM or HOT
FROTH, depending on your preference.
Ensure the LED is illuminated and
frothing will begin. Frothing will stop
automatically once the cycle is complete.
NOTE: Do not remove frothing jar from
mount while frothing is in progress. If
removed, turn off frother by pressing
COLD FOAM button again.
4. Pour frothed milk into tumbler, add straw
and lid then enjoy!
NOTE: Please ensure to handle frothing
jar by the silicone sleeve as the bottom of
the frothing jar gets hot!
5. Clean frothing jar after each use.
NOTE: Wait a minute or so before frothing
again to allow the heater to cool.
NOTE: Do not touch frothing warming plate
after use as it is hot.
4
How to clean your Iced + Hot
Machine
Minerals (like calcium and limestone) found
in water can leave deposits in your machine
and affect its performance. Decalcifying your
machine is an important part of ensuring your
coffee always tastes great!
We recommend decalcifying your machine
once per month to keep it at peak
performance. It’s an easy process – See steps
below.
Sunbeam Eco-friendly descaling sachets
(EMA0015CL) are available for purchase from
Sunbeam.
Contact details are on the back page.
1. Dissolve half the contents of a Sunbeam
Descaler sachet in 450ml of warm water.
Pour the solution into the water reservoir.
Fold the sachet (containing the remaining
descaler) up tightly and store for next use.
2. Place the reusable coffee filter into the
brew basket and close the lid.
3. Place the tumbler under the spout and
press the HOT BREW button to run a
brew cycle.
4. When the descaling solution begins to
pour through the brew spout, press the
HOT BREW button again to stop the pour.
Leave the descaling solution in the Iced +
Hot machine for 1 minute. Then press the
HOT BREW button to resume the pour.
5. When the brew cycle has completed,
discard the contents of the tumbler.
Remove the reusable coffee filter from the
brew basket.
6. Rinse out the tumbler, reusable coffee
filter and brew basket with clean water.
7. Place tumbler under spout.
8. Fill the water reservoir to the 475ml mark
with clean water, and press the HOT
BREW button to run a brew cycle.
9. When the brew cycle has completed,
discard the contents of the tumbler and
rinse tumbler thoroughly with clean water.
10. Repeat steps 7-9 one more time, to
ensure the machine is thoroughly rinsed.
Your Iced + Hot machine is now clean and
ready to brew delicious Iced or Hot coffee
whenever you need a pick-me-up!
DISHWASHER SAFE PARTS OF YOUR ICED
COFFEE MACHINE
To thoroughly clean your Iced + Hot coffee
machine, you can put the following parts into
the top rack of the dishwasher:
1. Reusable coffee filter
2. Brew Basket
CAUTION: THE ELECTRICAL BASE, POWER
CORD AND PLUG ARE NOT DISHWASHER
SAFE AND SHOULD NEVER BE IMMERSED
IN WATER OR OTHER LIQUIDS.
5
FAQ
Why is my milk not frothing?
• Make sure your whisk is properly inserted
at the bottom of your frothing jar. You will
hear a click when it is inserted correctly.
• Ensure you’re not adding milk past the
latte/cappuccino line in the frothing jar.
• Try using a different kind or brand of milk.
My iced or hot coffee isn’t strong enough for my
taste – what now?
No problem – everyone’s tastes are different!
Add another half scoop of coffee grounds into
the reusable coffee filter next time you make
iced coffee. If that’s still not strong enough,
try a full extra scoop.
Try selecting the “OVER ICE” setting for Hot
Coffee, as this pre-infuses the coffee for best
extraction.
Is the tumbler dishwasher safe?
No, the tumbler, lid and straw should be
hand-washed only.
Why is there no ice left in my cup after brewing
iced coffee?
Try using bigger ice cubes when making your
iced coffee – these will melt slower and give
you ice in your drink for longer! Also be sure
you have filled your tumbler all the way to the
“ICE” marking.
Why are there coffee grounds in my coffee?
You may have over-filled your reusable coffee
filter with coffee grounds, and they could
have spilled over the top. Although this is
uncommon, try using a little less grounds
next time and that should solve this problem!
Can I use a different tumbler or cup for making
iced coffee?
Sure thing! Just ensure you keep the same
ratio of water-ground-ice to create the best
tasting iced coffee!
6
Australia
www.sunbeam.com.au
1300 881 861
New Zealand
www.sunbeam.co.nz
0800 786 232
7
Need help with your appliance?
Contact our customer service team or visit our
website for information and tips on getting the
most from your appliance.
Australia | visit www.sunbeam.com.au
phone 1300 881 861
New Zealand | visit www.sunbeam.co.nz
phone 0800 786 232
Newell Australia Pty Ltd. ABN 68 075 071 233
Sunbeam is a registered trade mark.
Made in China to Sunbeam’s specification.
Due to minor changes in design or otherwise,
the product you buy may differ slightly from the one shown here.
Approved by the appropriate electrical regulatory authorities.
©Copyright Sunbeam 2023.
04/04
SDP1500BK_23EM1 (ANZ)_GCDS-JC
PN: NWL0001531206
Loading...